Subjact:Data:An inverted u tube manometer is connected to two horizontal pipes A.and 8 threugh which water is flowing The vertical distance betweenaxes of the se pipes is30 cM When an oil SG=0.8 îs uced as aJauge fluid, the vertical heigh 1s ofwater columos in the two limbs arefound to be the sameand equal to 35 cm. Determine the differenceOf pressure between thepipes.0.8Sp.gr.C.30 cm35 cm35cmtw ater30cmwater

To find the pressure difference -

Subjact: Data: An inverted u tube manometer is connected to two horizontal pipes A and B through which water is flowing The vertical distance between axes of these pipes is 30 CM When an oil SG 0.8 îs uced as a gauge fluid, the vertical heights af water columns in the two limbs are found to be the same and equal t0 35 cm. Determine the difference Of pressure between the pipes. 0.8 Sp.gr. 30 cm 35 cm 35cm to ater 30 cm water

Subjact: Data: An inverted u tube manometer is connected to two horizontal pipes A and B through which water is flowing The vertical distance between axes of these pipes is 30 CM When an oil SG 0.8 îs uced as a gauge fluid, the vertical heights af water columns in the two limbs are found to be the same and equal t0 35 cm. Determine the difference Of pressure between the pipes. 0.8 Sp.gr. 30 cm 35 cm 35cm to ater 30 cm water

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q.23 Consider the flow of water through the frictionless pipe as shown in the figure. There is a sudden expansion at a section in the pipe. The flow velocity is 2.5 m/s and 1 m/s in AB and BC portion of the pipe respectively. The reading '' of the mercury- water differential manometer is: [Take specific gravity of mercury as 13.6] A O 50 cm Q B ↓ Water }
13 PLEASE PROVIDE COMPLETE AND DETAILED SOLUTION
The flow rate of water flowing out of an 80mm diameter nozzle shown in Figure 1 is 60 litre/s. The volume of the water in the pipe bend is 50 litres and the pipe bend is installed in a vertical plane. The head loss from point 1 to 2 is 0.44m. Calculate the x and y for components of the thrust block to hold the pipe bend. Horizontal Thrust block 30° 50° Open end Ø80 mm Ø 160 mm Figure 3 Cs Scanned with CamScanner Vertical
Question 3: A lab test was used to identify the headloss coefficient of a confusor k'e where: h = kE' ,V² -V₂² 2g that is shown in the figure. Two pizometers were installed at A1 and A2, which measured piezometric head of 40 cm and 44 cm, respectively. The diameters are 5 cm, and 10 cm at A1 and A2 respectively Flow was measured as 0.02 m³/s. Find kE' V₁- A1 a A2 -V₂
5. Determine the new differential reading along the inclined leg of the mercury manometer of Fig. 3, if the pressure in pipe A is decreased 10 kPa and the pressure in pipe B remains unchanged. The fluid in A has a specific gravity of 0.9 and the fluid in B is water. -SG = 0.9 30⁰ Fig 3 100 mm 50 mm Water 80 mm Mercury
a 150 mm by 50mm venturi meter is installed in an inclined pipe carrying oil. the venturi distance between the inlet and throat is 20cm. the flo is upward through the meter. a differential manometer containing mercury the (sp. gr=13.6) is attached to the inlet base and throat. compute the deflection of the mercury if the actual discharge of pipe is 0.55 m³/s. assume the venturi coefficient to be 0.97.
O Through the pipeline system in the figure calculate gauge and absulate presures at A and B 12 14 cm 5 Air 15 cm 15 cm A 15 cm Mercury 15 cm Water B 10 cm 5 Cm 25 cm 11 Mercury
1. Figure 1 shows the manometer apparatus with different fluids. It is given that the specific density of the mercury and oil are 13.56, and 0.9 respectively. Solve, a. The liquid level, Az when the area of the reservoir on the left lim b of the manometer is 100 times the area of the manometer tube in right limb. The volume X is equal to Volume Y. b. The pressure at point A. Oil Volume Y 45cm 18cm Mercury Az Volume X