student is watching a TV that is receiving a signal though an in-house dipole aerial. As the student stands up and walks towards the TV he can observe that the signal gradually degrades and then recovers again. The students walks back and forth to discover that the distance between the points where the best and the worst signals are observed is 1 m. Can you explain the phenomenon observed by the student.  Select one: a. The student is moving between the nodes and antinodes of the electromagnetic wave carrying

Q: Consider the oscilloscope figure shown next (with X(t) signal operating at a frequency of 1 KHz).…

A:

Q: A beam of Visible light with a frequency of 4.5E+14 Hz and intensity of 0.0051 W strikes a solar…

A: Given    Frequency (f) = 4.5 ×  10^ 14 Hz.    Intensity = 0.0051 Watt      Intensity =   Number of…

Q: a) Radiation is energy moving in a wave, and like any wave (think sound or water waves) it has…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: Plot two cycles of a 25 Hz sine signal, starting at time zero, labeling the time axis at all peaks…

A: Plotting Two Cycles of a 25 Hz Sine Signal To plot two cycles of a 25 Hz sine signal starting at…

Q: In photoclectric effect, the number of photoclectrons emitted is proportional to A- intensity of…

A: Photoelectric effect : When a material absorbs electromagnetic radiation, a phenomenon known as the…

Q: The directivity of the infinitesimal (ideal dipole) is equal to the directivity of short dipole,…

A: The concentration of an antenna's radiation pattern in a certain direction is measured by…

Q: An active dipole in open circuit has a voltage of 120v and in short circuit it has a current of 25A.…

A: The active dipole can be seen as an ideal voltage source with an internal resistance. When it's in…

Q: a a. 398 W/m

A:

Q: If the measurement deviations D are calculated for all measurements then the curve of deviation…

A: The curve of deviation frequency F (D) plotted against deviation magnitude D is a Gaussian curve…

Q: Question Post-2: Figure 8. 18 shows a time trace of a square wave produced by a function generator…

A: The given waveform is shown below. We need to determine the period of the waveform, peak to peak…

Q: What is the solid angle unit? a) rad b) m c) sr d) s

A: In this question , we will define solid angle unit..

Q: (c) Briefly explain the functions of (i) the synchronizing pulse (ii) the blanking pulse of a TV…

A: SYNCHRONIZING PULSE: The synchronizing pulse is transmitted or stored with the analog video signal…

Q: Throughout the semester we have seen many examples of how electromagnetic radiation is produced.…

A: The electromagnetic wave is produced due to the acceleration of a charged particles. Photon is a…

Q: A circular loop TV antenna with a 0.01 m² area is immersed in a 300MHz plane wave. When oriented for…

A: Given, The area of the TV antenna, A=0.01 m2 The peak value of VEMF=20 mV

Q: A flat luminaire with dimensions 1.2 x 0.2m is mounted in a ceiling. The fixture has an opal plastic…

A: Light is electromagnetic radiation, which travels across space with an oscillating electric and…

Q: The figure shows the electric field of a dipole. At what point is the electric potential zero? OA OB…

A: The electric potential due to an electric dipole is zero at every point on the equatorial line of…

Q: where zeta = 0.707 and wn = 15. The transfer function of the power amplifier is approximately G₁(s)…

A: The individual transfer function of a closed antenna system are given as:To determine:sensitivity of…

Q: What is the Jones Matrix of a quarter wave plate that is 45° rotated to the horizontal direction?…

A: What is the jones matric of a quarter wave plate that is  rotated in the horizontal direction.

Q: 4. Sagnac interferometer Consider interferometer shown below. The input beam with amplitude E₁ is…

A: To demonstrate that output 2 of the Sagnac interferometer is always zero, we can use symmetrical,…

Q: What is characteristic impedance? How do you find it by measuring pulses?

A: According to the question, What is characteristic impedance? How do you find it by measuring pulses?

Q: Q4) Design an arithmetic logic unit (ALU) that can do the following operations (A AND B, A-B. B-A, A…

A:

Q: find the current required to radiate a power of 100W at 100MHz from 0.1 herztian dipole

A: Given, P= 100 W dL= 0.1 m f= 100 MHz

Q: The period of this signal is about ms (milliseconds). Use this picture for 2 additional questions…

A:

Q: Consider the oscilloscope figure shown next (with X(t) signal operating at a frequency of 1 KHz).…

A:

Q: Homework: For the circuit shown in the figure below: 1. Find the mathematical expression for the…

A: Given:-

Q: How can we compare the phase of the oscilloscope "signal inversion" when function is NOT available?…

A: Oscilloscope An oscilloscope, often referred as a scope or a two-dimensional depiction of one or…

Q: Write down the expression for an AM wave.

A:

Q: Why does a discrete spectrum occur?

A: If a physical quantity takes only distinct value i.e. with certain gaps between one and other value,…

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.