steps on the orange part please, on how he got the answer, thanks.

Q: The plans show curved lines running between switches and various outlets. What does this means

A: The plans show curved line running between switches and various outlets enhances to differentiate…

Q: When a ground wire is connected to an interior gas piping system and the underground portion of the…

A: Given:When a ground wire is connected to an interior gas piping system and the underground portion…

Q: ladder diagram for bottom half of a switched receptacle is to always be hot plus a duplex receptacle…

A: According to the question, we need to design a ladder diagram for the bottom half of a switched…

Q: Can you show the circuit for this or the diagram?

A:

Q: When calculating a dwelling lighting load on the "volt-ampere per ft" basis, the receptacle load…

A: Given: Receptacle loads used are Floor and table lamps. When dwelling loads are calculated what must…

Q: Shown below is a DC circuit that contains a number of switches. The resistance of each switch is…

A: We have to rank as per ammeter reading from highest to lowest.     Let we consider,  R= 1 ohm and…

Q: What is the allowed ampacity of tap conductors that supply a motor lead and do not exceed5 feet in…

A: 5. (i) Except as permitted in 240.21(A) through (H), conductors must be equipped with over-current…

Q: What assumptions can you make regarding the following receptacle wiring? Check all that apply.

A: A split pair is a wiring fault in which two twisted pair wires are linked instead with two wires…

Q: (15) Electrical fires are rated as Class __________ fires. Select one: A. D B. B C. C D. A

A: A fire-class is a system of categorizing fire with regards to the type of material and fuel for…

Q: Exposed structural metal that is interconnected to form a metal building frame that not…

A: As per the new NEC in 250.104(C) all the structural steel whether it contributes to the interior or…

Q: B1 Battery B2 Battery + A НОНІ Switch B WHOI C 3.30 C 3 VOLTS BAX m 10: KIT NO.

A:

Q: supplementary grounding electrode is required when the only grounding electrode available is ? NEC…

A: According to NEC 250.53 (D)(2)  A supplementary grounding electrode is required if metal…

Q: 4) Calculate the value of the resistance Rled in Circuit #1, to ensure that a GREEN LED will have a…

A:

Q: What dimensions are used when measuring the area of a building? See NEC 220.12.

A: Referring to the NEC 220.12, the floor area is evaluated using the outside of the building…

Q: .A. The insulation color of a grounded wire should be A. white. B. red. C. black.   4.B. A switch…

A: To select proper options from given

Q: YOUR TURN # 19-A: Determine how many 6 RHW-2* conductors can be installed in trade size 3 ½ in.…

A:

Q: using the base of 2 to answer following subtraction:  1000 base 2 -101 base 2 ________________

A: According to the given question, it is required to determine the binary subtraction of the two given…

Q: The resistance of a nine inch length of copper that has a diameter of 0.005 in. is ______  (the…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: What is a matching circuit?

A: Matching circuit : A matching circuit is a circuit which is mainly connected by source and load at…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.