Steam to drive an old-fashioned steam locomotive is supplied at a constant gauge pressure of 1.75 × 106 N/m2 (about 250 psi) to a piston with a 0.200-m radius. (a) By calculating PV, find the work done by the steam when the piston moves 0.800 m. Note that this is the net work output, since gauge pressure is used. (b) Now find the amount of work by calculating the force exerted times the distance traveled. Is the answer the same as in part (a)?

Steam to drive an old-fashioned steam locomotive is supplied at a constant gauge pressure of 1.75 × 106 N/m2 (about 250 psi) to a piston with a 0.200-m radius. (a) By calculating PV, find the work done by the steam when the piston moves 0.800 m. Note that this is the net work output, since gauge pressure is used. (b) Now find the amount of work by calculating the force exerted times the distance traveled. Is the answer the same as in part (a)?

Similar questions

Does a gas do any work when it expands adiabatically? If so, what is the source of the energy needed to do this work?
A sample of an ideal gas is expanded to twice its original volume of 1.00 m³ in a quasi-static process for which P=aV², with α= 4.53 atm/m6, as shown in the P-V plot below. How much work is done on the expanding gas? P Les P=av² 1.00 m³ 2.00 m³
The pressure change of a balloon varies according to the P=CV*1/3 equation (C = 100 kPa m and n= -1/3) Since the balloon is inflated with air at a temperature of 25 ° C from 1 m3 volume to 3 m3 volume at 25 ° C , (R air = 0.287 kJ / kg 'K) a) Find the mass (kg) of air in the final state. b) Find the work (kj) done by air. c) Show the work done on the P-v diagram.
A bathroom extractor fan being sold on Amazon has a duct diameter of 10.0 cm. It extracts air from a bathroom at a rate of 70.0 m3/h and the power supplied to the fan is 7.0 W. With what efficiency does the extractor convert electrical power into the kinetic power associated with the air-motion? Take the density of air to be 1.2 kg/m3 and assume laminar air flow.
1 kg of a fluid expands reversibly according to a linear law from 4.5 bar to 1.6 bar; the initial and final volumes are 0.004 m3and 0.02 m3. The fluid is then cooled reversibly at constant pressure, and finally compressed reversibly according to a law pV = constant back to the initial conditions of 4.5 bar and 0.004 m3. Determine the work done in each process and the net work of the cycle. Sketch the cycle on a p-v diagram.
(a) An ideal gas is taken through a quasi-static process described by P = av, with a = 5.50 atm/m, as shown in the figure. The gas is expanded to twice its original volume of 1.00 m3. How much work (in MJ) is done on the expanding gas in this process? P P= aV? 1.00 m3 2.00 m3 MJ (b) What If? How does the work done in part (a) compare to the lowest and highest possible amounts of work that can be done on this gas between the initial and final states if the pressure always remains between P, and P and the volume always remains between V, and V2 (Enter your answers as percentages of the work done in part (a).) WIowest x 100% = W. part (a) W highest x 100% = W. part (a)