Steam enters the turbine at the rate of 1.5 kg/s with enthalpy of 2300 kJ/kg and exhaust enthalpy of 1200 kJ/kg. Steam is extracted from the turbine at a rate of 0.78 kg/s for heating purposes with enthalpy of 2750 kJ/kg. What is the turbine work? A. 1305 kW B. 441 kW C. 2145 kW D. 495 kW

Q: Compressed liquid

A: Given Data: The pressure of liquid water at the inlet of the steam generator is, P1=10 MPa. The…

Q: A turbine is driven by a system that enters the turbine at the ff. conditions: 200 kg/h, 39 atm, 501…

A: mass flow rate (m.)= 200 kg/h= 200 kg/3600 sec= 0.0555 initial temperature ( Ti)= 501 C speed (C1)=…

Q: The losses in the blade of a steam turbine due to friction is 20%. If the relative velocity of steam…

A: Given                       K = 0.28 Inlet velocity, V = 300 m/s

Q: The actual power output of a wind turbine with an efficiency of 59% is 1250kW. The predicted output…

A:

Q: A pressure relief valve is installed in a rigid 25-L steam cooker to release vapor and maintain…

A: To determine the smallest entropy change of the thermal energy reservoir.

Q: condenser with an enthalpy of 2503 kJ/kg and The condensate leaves the condenser 2 Steam enters a a…

A: Given data  At inlet of condenser enthalpy of steam (h1) = 2503 kJ/kg velocity of steam (V1) = 74…

Q: Catalogue data for R-32 compressor with a displacement of 80 L/s show the capacity to be 8 tons when…

A: Refrigerant=R32Compressor displacement, V˙d=80 L/s=0.080 m3/sRefrigeration capacity, Q˙e=8…

Q: 1. Refrigerant 134-a enters an adiabatic compressor as saturated vapor at 0 °C and is compressed to…

A: Given data: R-134a refrigerant enters an adiabatic compressor as: Saturated vapor at T1=0 °C and is…

Q: A heat pump with refrigerant R22 is used for space heating between temperature limits of -20°C and…

A: Given data: ◆ The evaporator temperature: TE = -20℃ ◆ The condenser temperature: TC = 25℃ ◆ The heat…

Q: R-134a as a refrigerant, in a cooling machine used; refrigerant to evaporator (evaporator) 0.15…

A:

Q: According to the figure below, show that the optimal condition for the efficiency of the Pelton…

A:

Q: a alll Asiacell The unit of temperature in S.I.-17 * units The unit of temperature in S.I. units is…

A: Note: - As per the guidelines of Bartleby, only one question is allowed to answer so please submit…

Q: Air with a pressure of 0.1 MPa and a temperature of 25oC with a flow rate of 5.29 kg/minute enters a…

A:

Q: When there is heat loss in a system, how can you increase the work output? a. Increase inlet T at…

A: Answer: The correct answer is option (a).

Q: ne kg of dry and saturated vapor enters to the turbine at 6.0 MPa. Steam leaves this turbine stage…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: ideal gas turbine is shown in the figure. Determine the work output and the back w

A: Given:Inlet pressure to compressor, P1=100 kPainlet temperature to compressor, T1=20o C or 293 KOut…

Q: An engineer in a steam power plant is tasked with calculating: a. The isentropic efficiency of the…

A: Given Data, Inlet pressure to the turbine= 6MPa Inlet temperature to the turbine= 500oC Outlet…

Q: Steam of 6 MPa and 400-C produced in a boiler at a flow rate of 0.aa6 m³/sec is passed through a…

A: Given data:-Temperature at turbine inlet, T1=400°C=673Ksteam flow rate, Q=0.046m3/sHeat loss from…

Q: e refrigerant at isentropic compressor discharge is

A: Given data. Heat pump with refridegerant R22.  T1=-200C=-20+273=253K  T2=25=25+73=298KHeat…

Q: Rate of evaporator heat transfer, kW 20 18 16 14 12 -20°C -10°C -10 Compressor oc 18-3 The…

A: Given-

Q: I do not understand how to fix state 3 with the given information. Without knowledge of state 3 or…

A: pressure ratio, rp = 1000/100 = 10Temperature at the exit of the turbine, T4 = 450 CIsentropic…

Q: 2. A gas turbine generates 300 MW of power with inlet conditions of 1600 K and 1600 kPa and exit…

A: Input of the turbine is 1600 K. The input pressure of the turbine is 1600 kPa. We can assume the…

Q: A condenser takes in steam with enthalpy of 2450 kJ/kg and mass flowrate of 2 kg/s. It also…

A: in condenser process is constant pressure.

Q: Water inter a condenser at a mass flow rate of (2.5 kg/s) and (21 kPa and 65 C), and exit with (h=…

A:

Q: Determine work output of the engine, for the reversible cycle

A:

Q: Saturated liquid water is heated in a heat exchanger until it exits as a saturated liquid väpor…

A:

Q: b) A steam turbine that uses refrigerant 134-a as the working fluid is passed through a diffuser.…

A:

Q: Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam…

A: Calculate the total pump work of the cycle?

Q: What is the mass flow rate flowing through the boiler?

A:

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: ⇒given data;⇒pressure ratio (r)=P2P1=16⇒inlet temeperature of air  in compressor (T1)=300K⇒mass flow…

Q: Air inlet to a gas turbine has conditions 275.79 kPa, 54.44°C while the outlet has conditions 14.7…

A:

Q: 4 kg/s of air enters steadily at 20°C through a heat exchanger at a velocity of 35 m/s where its…

A: Given Data  The mass flow rate of air in a heat exchanger, m=4Kg/s The inlet temperature of the heat…

Q: What are the advantages of 1-reheater 2-economizer 3-fixed row of steam turbine.

A: Advantage of reheater: It increase the thermal efficiency of the thermal power plant. It reduce the…

Q: Plant B is a Diesel power plarit that has an energy of 12 KW HR everyday operations. What is the…

A:

Q: 1. A small river is to be dammed to create a hydroelectric power plant. After the completion of the…

A: The power produces is the product of density, level difference and discharge flow rate per…

Q: : A Steam enters turbine at nate of 20X10 K/ hr and at F00 Kpa & 450 C. At the turbine exhaust, the…

A: This question is based on the steady flow energy equation applied to the turbines. Assumption taken…

Q: Refer to the steam power plant below and determine the following: ii. i. Specific enthalpy at the…

A:

Q: Water vapor enters a turbine at 6 MPa pressure and 800 ° C temperature and leaves at 20 kPa…

A: according to the steam table at pressure 6 MPa h1 = 3178.3 kJ/kg s1 = 6.5432 kJ/kgK at pressure 120…

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.