Steam enters the turbine 5MPa and 600 and exits adiabatically at 100 kPa. For Actual cycle: turbine efficiency =90%, turbine brake efficiency=84%, generator efficiency=93% Mass flow rate of steam = 15 kg/s Determine the following: For Ideal Rankine Engine Find WT and e SR and HR For Actual Rankine Cycle Find WT’, WB, WK,e’, eB and eK Find SR’, SRB, SRK,HR’, HRB and HRK

Q: c) To examine the behavior of turbocharging, we shall consider the following example of a four…

A:

Q: determine optimum velocity of steam

A: Given; For a single stage impulse turbine with; rotor diameter,d =2 mSpeed,N=3000 rpmNozzle angle…

Q: A large stationary Brayton-cycle gas turbine power plant delivers a Net Power Output of 100 MW…

A: The pressure ratio is The net power output is The minimum temperature is The minimum pressure is The…

Q: P = 10 MPa T= 600 °C =0.2 MPa 2 21 A. For the turbine, for mass flow rate of 3,000 kgħr, caiculate:…

A:

Q: Derive the MEP for dual cycle in terms of P1, rk, rp, k, and e.

A: Dual cycle P1 = pressure  rK = compression ratio rp = pressure ratio rc = cutoff ratio k = specific…

Q: Find the efficiency of Brayton cycle with, (a) Pressure ratio = 6 (b) Pressure ratio = 8 (c)…

A:

Q: The T-S Diagram as represented below are both working on a Carnot Cycle. Which is more efficient?…

A: The efficiency of the cycle.GivenThe two T-S Diagrams as represented below are both working on a…

Q: Consider an ideal Stirling-cycle engine in which the state at the beginning of the isothermal…

A: Data given- P1 = 100 kpa T1= 25°C T3 = 1500°C Compression ratio  V1/V2 = 8

Q: A turbine receives steam at 8.8 MPa, 510OC and exhaust it at 0.175 MPa. (a) For the ideal Rankine,…

A: The steam turbine works in the Rankine cycle. An ideal Rankine cycle is the one where the pump and…

Q: A diesel cycle has a compression ratio of 8 and initial temperature of 340C. If maximum temperature…

A:

Q: Identify the processes involved in ideal and actual Rankine cycle as in Table 2. Table 2 Ideal…

A: The table is given below -

Q: Consider an ideal gas-turbine cycle with the following details in Table 1. Table 1 No. of stages at…

A:

Q: A steam power plant operates with a boiler at 5000 kPa and 500 °C. The turbine exhaust is saturated…

A: To determine Wt, Wp, Qh and Qc for the given cycle

Q: A second carnot cycle receives heat from the cold reservoir of a primary carnot cycle cyle at 191…

A:

Q: the limitation(s) of gas turbines.

A: Given: Gas turbine To write: The limitations of gas turbine

Q: Example. A steam power plant operates on the cycle shown below. If the adiabatic efficiency of the…

A: Given data: adiabatic efficiency of the turbine is 87%adiabatic efficiency of the pump is 85%mss…

Q: Prove that there is an increase in efficiency between a Simple Rankine Cycle and a Reheat Rankine…

A:

Q: 4. Explain Figure Q6-4 FIGURE Q6-4 Thermal efficiency of the ideal Diesel cycle as a function of…

A:

Q: Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam…

A: Calculate the total pump work of the cycle?

Q: What is the compression ratio?

A: The rejected energy is twice the generated energy.Q1 = 2Q2The efficiency is the ratio of difference…

Q: A two-shaft gas turbine power plant is shown in Figure Q2 (b). All the power developed by the…

A: Calculated the temperature at the exit of high pressure turbine. And thermal efficiency ,back work…

Q: A  Carnot cycle has been chosen as a candidate for the ideal vapor power cycle.  The pump inlet is a…

A: The minimum pump work will be about 10 kJ/kg.

Q: In a turbojet engine, what are the assumptions for static & stagnation temperatures and pressures…

A: This question is based on the concept of turbine and compressor.

Q: A simple Rankine cycle works betw een pressures 43 bar and 10 Kpa, the initial condition of steam…

A:

Q: An Otto cycle is to be used to model an engine cycle. All assumptions of the ideal Otto cycle are to…

A:

Q: work output from the

A: Given; An engine operates on the reversible cycles as shown in the figure.Find work output from the…

Q: 7. Prove that the efficiency of the diesel cycle below is given by : 1rg-r 77=1-- 174-7₁ y T3-T₂ =1-…

A:

Q: A steam power plant operates with a boiler at 4,500 kPa and 500 °C. The turbine steam exhaust is at…

A: Given: To determine Wp, Wt, Qh, Qc for the given cycle.

Q: The Reversed Carnot Cycle is used to run a food production company's refrigeration system. The…

A: As per bartleby guidelines we are allowed to solve 3 subparts if multiple subparts are posted.  So…

Q: Consider a Brayton Cycle with all the goodies installed: Regenerator (c=75%); Intercooling of…

A:

Q: 5.2.3 Steam at a pressure of 4MPA and a temperature of 350°C expands to 100kPa ina steam turbine.…

A: Solution: Properties at different state show in the T-s diagram above has to be calculated. At…

Q: For sink temperature of 450 K, efficiency of Carnot engine is 30%. If sink temperature is reduced by…

A:

Q: For a steam turbine with the following data: Initial Temperature T0=36,7°C, Final temperature after…

A: Given that, Initial temperature, T0=36.7 °C,Initial pressure, P0=1 bar,Final temperature of boiler,…

Q: Q2. An idea Otto cycle has a compression ratio of 11, takes in air at 100 kPa and 25 °C. The…

A:

Q: Q2 Figure Q2 is a Reversed Carnot Cycle with a food department is kept at -12°C. The total heat gain…

A:

Q: 5 A 3MW stea m turbine consumes 4.611 kg/sec at full load and 2.53 kg/sec at half ioad. Using…

A:

Q: A gas turbine power plant operates on a simple thermodynamic cycle. The ambient conditions are 100…

A:

Q: ompressor and turbine is 3. The air enters each stage of the compressor at 300 K and each stage of…

A:

Q: An idealcold air-standard Brayton cycle produces some quantity of power. Air with a mass flow rate…

A:

Q: A cycle with regeneration is the stirling cycle; it is composed of two isothermal processes and two…

A: