Steam enters an a turbine with an inlet area of 800 cm^2 at h = 3268 KJ/kg, specific volume of 0.384 m^3/kg and a velocity of 10 m/s. At the exit of the turbine steam is at h = 3072 KJ/kg and 606 m/s. If the steam is losing heat at 20 KW, find the mass flow of the steam. O 1.57 kg/s O2.14 kg/s 3.015 kg/s O2.08 kg/s

Steam enters an a turbine with an inlet area of 800 cm^2 at h = 3268 KJ/kg, specific volume of 0.384 m^3/kg and a velocity of 10 m/s. At the exit of the turbine steam is at h = 3072 KJ/kg and 606 m/s. If the steam is losing heat at 20 KW, find the mass flow of the steam. O 1.57 kg/s O2.14 kg/s 3.015 kg/s O2.08 kg/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In a steam turbine, water vapor enters at a temperature of 450C and a pressure of 2.5 MPa, at a speed of 60 m/s at a height of 12 m, and at a pressure of 20 kPa at a speed of 0.85 degrees of dryness, at a speed of 180 M/s at a height of 6 m. During this process, a power generation of 5 MW occurs. According to the given; a) compare kinetic, potential and enthalpy changes. b) calculate the work done by the unit mass of steam flowing from the turbine. c) calculate the mass flow of steam.
2. 80 m below the free surface of a large water reservoir that can supply water at a rate of 2200 kg/s steadily. If the mechanical power output of the turbine is 1400 kW, determine the turbine efficiency. Neglect losses in the pipes. The gravitational acceleration is g-9.81m/s². Generator h = 80 m Turbine m 2200 kg/s
A wind turbine has a blade length of 20 m. In a given day, average speed of wind for 4 hours is 7 m/s, average speed of wind for another 10 hours is 9 m/s and wind speed is not sufficient to rotate wind turbine for remaining time in a day. Take Air density p = 1.23 kg/m. Determine the following: a) Maximum possible power output of wind turbine for 4 hours ( b) Maximum possible power output of wind turbine for 8 hours c) Maximum possible energy output of turbine in a given day
NASA would like a rocket to accelerate upward at a rate of 125 ft/s2. The mass of the rocket is 35,000 lbm. Determine the upward thrust force, in lbf, that the rocket engine must produce
Methane in the gaseous state flows at a rate of 0.072 m^3/s in a pipe at a temperature of 27°C and gauge pressure of 148.675kPa (point 1). The pipe is divided into two branches (point 2 and 3), as seen in the figure. If the exit velocity in pipe 3 is 12 m/s with a density of 1.9 kg/m^3, what is the flow rate and velocity in pipe 2? Consider that in section 2 the fluid is leaving with a temperature of 402°C and an absolute pressure of 175 kPa. We have an atmospheric pressure of 101.325 kPa and R_methane = 0.5182 kJ/kg ⚫K. (1) Inflow D1 D3=50mm D2=100mm (3) (2)
Please verify my answer
A Liquid fluid with a density of 1,750 kg/m3 from an elevated 2m open reservoir (P1=0 bars) flows before the pump at 7.5 m/s. The liquid fluid is pumped at an unknown final velocity to a 75 meter elevated tank with a pressure reading of 7.75 Bars. assuming Friction losses is 757.75J and the actual WORK of the pump is 1,933,400J. Calculate the power in HP if the pump's efficiency is just 75% and for every 1,000 kg of fluid per hour.
Please assist me with this question as soon as possible.
A compressor draws in 0.25 m% of air whose density is 1.26 kg/m? and discharges it with a density of 4.87 kg/m°. At the suction, P, = 103.4 kPaa; at the discharge, P2 = 551.4 kPaa. The increase in the specific internal energy is 78.63 kJ/kg, and the heat from the air by cooling is 30.24 kJ/kg. Neglecting changes of potential and kinetic energy, determine the work on air in kW, BTU/min, and Hp.
Fluid falls from a 50 m elevation.a. Determine the velocity of the fluid at the surface of the reservoir.b. What is the temperature of the water in the reservoir?Let heat capacity of the fluid equal to 4.19 kj/kg* °C. Assume a steady-state and adiabatic process.