Steam condensing at 120°C (h = 2203 kJ/kg) on the shell side of (1 shell and 12 thin-walled tubes) heat exchanger. Water (18 °C, C =4180 J/kg.°C) enters the tube @ 3.4 kg/s ấnd the temperature difference between the two fluids at the exit is 57°c, assume LMTD correction factor of 1.0, for each tube: length = 2.7 m, diameter = 2.4 cm. What is the rate of condensation of steam (kg/min) ?

Steam condensing at 120°C (h = 2203 kJ/kg) on the shell side of (1 shell and 12 thin-walled tubes) heat exchanger. Water (18 °C, C =4180 J/kg.°C) enters the tube @ 3.4 kg/s ấnd the temperature difference between the two fluids at the exit is 57°c, assume LMTD correction factor of 1.0, for each tube: length = 2.7 m, diameter = 2.4 cm. What is the rate of condensation of steam (kg/min) ?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

0-25 mm kead He nearurement of the moromeler (c) E25 10 15 20 20 0-25 mm TTTTTT|
31 Psi not 30 Psi
10 Figure 5
Select the true statement An automotive crank shaft is... O Is subjected to multiple fatigue load cycles Reduces in strength as a result of corrosion during normal engine operation Subjected to creep failure due to engine temperature Have a geometry manufactured by casting
4. MM 3omm 50 30 mm
are you sure it's not c?, can you show with diagrams
Rod M,L ellle ellecl
The neutral axis of the given built up section is nearest to ______measured from the bottom of the section:
Question 1) F=22 kN single load, M=24 kN.m moment and w=5 kN/m distributed load act on the beam whose loading condition is given in the figure. The length L is also given as L=4 m. The cross-sectional properties of the beam are; body height y g = 203 mm , body thickness x g = 19 mm, flange width x Question 1-E) Find the y distance of the section center with respect to the axis passing through the base of the section. ( Write your result in mm .) Question 1-F) section. (Do your operations by converting the lengths to meters. Take at least 4 digits for the decimal part of your result and use the expression E for the decimal part. Write it as 5E-3 instead of 0.005 .) f 172 mm , flange height yf = 16 mm. Point E on Find the moment of inertia of the beam the section is located just below the flange-body junction. It is desired to determine the stress state in the section taken from the B level of the beam. According to this; D abutment response at point (D y Question 1-A) find. (Your result…
The 10-kg crate is subjected to a force having a constant direction and a magnitude F = 100 N. When s = 15 m, the crate is moving to the right with a speed of 8 m/s. Determine 1) The normal force between the crate and the ground. 2) Its speed when s = 25 m. %3D The coefficient of kinetic friction between the crate and the ground is mk = 0.25.