(c)State the types of hazard for the following types of occupations;(i)Animal officer is exposed to animal bites which is potentially to get TB, tetanusand rabies.(ii)Brick mason works can cause backpain due to over-bending while doing the jobs.(iii)Construction workers in the construction site always working under direct sunlightwhich is exposed to ultraviolet radiation.Staff administration working in long hours in front of computers causing(iv)musculoskeletal disorders (MSDS)Building cleaning workers cleaning the window office in high rise building.(v)

i) Introduction : Tetanus vaccination – Tetanus is a dangerous, potentially fatal infection that can…

State the types of hazard for the following types of occupations; (i) Animal officer is exposed to animal bites which is potentially to get TB, tetanus and rabies. Brick mason works can cause backpain due to over-bending while doing the jobs. (ii)

State the types of hazard for the following types of occupations; (i) Animal officer is exposed to animal bites which is potentially to get TB, tetanus and rabies. Brick mason works can cause backpain due to over-bending while doing the jobs. (ii)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Hand/Power Tool Demonstration and Procedure for safety Demonstrate the ability to identify hazards…

A: Inability to identify or acknowledge hazards that are present or could have been expected is one of…

Q: Employers have the responsibility to ask NSF for information concerning whether any substance in the…

A: Explanation NSF stands for National Science Foundation established in 1950. Every employer have the…

Q: What are the two lessons learned from this incident? 1. 2. www.JJ.AM

Q: What is the risk for a child drinking water contaminated with 0.061 mg/L carbon tetrachloride for 5…

A: Water contamination Although safe drinking water is critical to human existence, many of our water…

Q: Provide three examples on how the scope of RCRA is beyond proper management of hazardous waste.

A: RCRA- It stands for Resource convention and recovery act. It is defined as an act that creates a…

Q: steps of waste water treatment

A: The wastewater from the community undergoes a step of treatment before they are discharges into the…

Q: Q1: Draw the arrow diagram for the following activities and show the critical path: activity…

A: To draw arrow diagram

Q: . Describe the system to track hazardous waste from its generation to its point of final disposal?

A: Hazardous waste is the type of waste with radioactive properties that make it really dangerous or…

Q: Which of the following has the highest accident rate of all of the building trades? A. HVAC…

A: Concept- HVAC installation- It stands for Heating, Ventilation, and air-conditioning. Carpentry-…

Concept explainers

Workplace Safety

A workplace can be referred to as a space where people work together for the accomplishment of a common goal of the organization. Here, people can be a worker, an employee, and an employer. A person can be said to be an employer if he/she gets the job of organizational goal accomplishment through other persons, and that person gets paid for his/her service. All employees can also be referred to as workers. An employer may also hire workers of other categories which require specialized skills to finish a work. Both employees and workers along with the employer form the primary occupants of a workplace.

Question

(c)
State the types of hazard for the following types of occupations;
(i)
Animal officer is exposed to animal bites which is potentially to get TB, tetanus
and rabies.
(ii)
Brick mason works can cause backpain due to over-bending while doing the jobs.
(iii)
Construction workers in the construction site always working under direct sunlight
which is exposed to ultraviolet radiation.
Staff administration working in long hours in front of computers causing
(iv)
musculoskeletal disorders (MSDS)
Building cleaning workers cleaning the window office in high rise building.
(v)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 i) Introduction

VIEW

Step 2: ii) Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the cases listed below, identify which will use an importance factor Ip Contains hazardous substances Center of mass over 4 ft Sprinkler systems Egress stairs Attached to a RC IV building and necessary for continued operation Attached to a RC III building and necessary for continued operation Weighs over 400 pounds = 1.5 for non-structural components.
Major Source Emitter under Title V You are the new safety, health, and environmental manager at an industrial facility in Western PA. You have been asked to determine if the operations at your company would require a Title V permit under the Commonwealth of Pennsylvania’s air quality regulations. In the past your company has had to obtain a Title V permit because you were considered a major source emitter. However, since you are new to the company, you have been asked to reaffirm this. Your company is located in a county that has been classified as serious non-attainment for NOx emissions, serious non-attainment for CO, and serious non-attainment for PM-10. Your county has been classified as attainment for SO2 and ozone (O3) emissions. Your facility releases the following pollutants on an annual basis: PM10: 80 tpy Ethyl Chloride: 3 tpy Trifluralin: 12 tpy NOx: 40 tpy Chloroprene: 4 tpy CO: 70 tpy SO2: 120 tpy Diazomethane: 2 tpy Complete the table below by determining if each…
Discuss the principles of material recycling and reuse in sustainable construction practices.
Case 1. Painter Dies from Burns Received from Explosion Inside Tank INTRODUCTION On May 19, 1989, a 41-year-old male painter (the victim) suffered burn injuries from an explosion which occurred while he was painting the inside of a 1,300-gallon tank. He died 5 days later. A 32-year-old male painter (co-worker) stationed outside the tank suffered burns and a broken arm. OVERVIEW OF EMPLOYER'S SAFETY PROGRAM The employer is a sheet metal fabrication company with 30 employees. The company manufactures steel tanks and has been in business for 20 years. Most of the employees are sheet metal workers, welders and painters. The victim had been with the company as a painter for 3 1/2 years. The co-worker had been a painter with the company for 4 years. The company has a management level employee who serves as the safety officer on a collateral-duty basis. The safety officer conducts safety meetings once a month. New employees receive a safety orientation which consists of a brief discussion of…
How the Surface and near-surface contaminants can be transported?
I need a quick solution within 15 minutes With my best wishesTon
One environmental hazard recently identified is overexposure to airborne asbestos. Ina sample of 20 public buildings over 30 years old, three of which are insulated withmaterials with excessive asbestos content. What method should you use to find theprobability?
) What is risk assessment ? (ii) Briefly describe THREE risks that may be encounteredin project work. (iii) Describe the basis of Cause and Consequence (2C’s) analysis. Provide an example of a 2C’s analysisas part of a product risk management exercise. (b) (i) Explain what is meant by a safe product. (ii) Undertake a Fault Modes and Effect Assessment (FMEA) for ONE relevant safety feature of a product of your choice.(ii) Undertake a Fault Modes and Effect Assessment (FMEA) for ONE relevant safety feature of a product of your choice.
8. An engineer discovers a mistake in his design of an inhabited building. Wind loads were calculated incorrectly. Building could collapse in extreme conditions Does he risk his career and call attention to the problem to fix it? (circle on the two best outcomes) a. Leave the building as it is b. Remove the residents and design/implement a retrofit c. Keep residents and design/implement a retrofit d. Have the residents sign statements saying that they understand the risk of living there
5. What was the first law written to clean-up abandoned hazardous waste sites? When was it enacted? How are household hazardous wastes regulated?