* stack emitting 80 g/s of NO has an effective stack height of 100 m. The windspeed is mis at 10 m, and it is a clear summer day with the sun nearly overhead. Estimate the ground-level NO concentration (a) directly downwind at a distance of 2 km. (b) at the point downwind where NO is a maximum. * at a point located 2 km downwind and 0.1 km off the downwind axis.

* stack emitting 80 g/s of NO has an effective stack height of 100 m. The windspeed is mis at 10 m, and it is a clear summer day with the sun nearly overhead. Estimate the ground-level NO concentration (a) directly downwind at a distance of 2 km. (b) at the point downwind where NO is a maximum. * at a point located 2 km downwind and 0.1 km off the downwind axis.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the emission rate of SOx (ton/day) from a rural ground level source if the 2000m downwind concentration is 6.0μg/m^3. The wind velocity of 2m/s and the Pasquill stability is Class C
20.27 Consider a stack that emits a nonreactive pollutant at the rate of 55 g/s. The stack is 85 m tall, and is located in a rural area, surrounded for many miles by open pasture land. The plume rise is 35 m. The sky is cloudy on a November afternoon, and the wind speed (measured at 10 m height) is 6.0 m/s. (a) Esti- mate the downwind, centerline, ground-level concentration at a downwind distance of 5000 meters from this stack. Give your answer in µg/m³. (b) Also, estimate the ground-level concentra- tion at a cross-wind distance of 200 m, but still at the same downwind distance of 5000 m. Give your answer in µg/m³.
a) With the aid of neat sketehes, explain the stable conditions and unstable condition for a partially submerged object in a liquid column. b) A solid eylindrical pine wood (Specific gravity of 0.5) buoy has a cylindrical lead (Specific gravity of 11.3) weight attached as shown in Figure 1. i) Determine the equilibrium position (i.e. depth of immersion) of the buoy in seawater (Specific gravity of =1.03). ii) Caleulate the metacentric height. iii) Show that the buoy is stable. 4.88 m Pine wood 0.15 m -Lead Diameter (d) = 0.61 m nd Ixx. 64 Figure 1 Cylindrical buoy in sea water
A 0.5 m diameter 20 m high stack releases gases at 500 K at a rate of 10 g/s into asteady 1.0 m/s wind. The exit velocity for the stack is 1.5 m/s and the stack diameter is0.5 m. Assume an inversion height of 1.5 km. Estimate the maximum ground levelconcentration assuming rural stability class B. Repeat assuming rural stability classes Cand D. How significant of an effect does the stability class have on the maximum groundlevel concentrations? Where does the maximum concentration occur for each of the threestability classes? Briefly comment on your results
An 80 m stack is emitting a plume with a rise of 15 m at an emission rate of 300 mg/s in an atmosphere with a wind velocity of 10 m/s and stability class C. Determine the concentration of the dispersed plume at ground level, 4 km downwind from the stack and 40 m to the left of the stack.
A centrifugal pump delivers 900 m3/hr of sea water of sp.gr.= 1.03 from a source wherethe water level varies 2 m from high to low tide level. The pump centerline is located2.6 m above the surface of the water at high tide. The pump discharges into theatmospheric surface condenser, 3 m above the pump centerline. Loss of head due tofriction in the suction pipe is 0.8 m and that in the discharge side is 3m. Pump is directlycoupled to a 1750 rpm, 460 volts, 3 phase, 60 Hz. Calculate: a) total dynamic head b) pump theoretical power
50 N Fig 1 4m 20 N/m 10 m ). Determine 2). Determine the value oF 0). Max the valwe of R1 A1 82 B2 value oF Shear 4). Max Value OF Moment Đ). Deplection at point 8
Earth dam homage material has the fllows data K=0.0005cm/sec level of top of the dem= 200m bed level of the dam =1.78m filter length=25m free beard=2.5mu/s slope=3:1 D/s slope =2.5:1 determine the phredic line for this dam and the discharge casing through the dam (casingrande of flownet)
I need a quick solution within 15 minutes With my best wishesTon.
Match each Question with the correct answer. v Wind farms offshore A. performance line B. v Power coefficient B. is the overall operating characteristics of a wind turbine v The wind speed experienced by a wind turbine C. hydrograph v For estimating the likely energy yield of a site D. mean wind speeds are usually measured with an averaging period of 1 hour v The energy of a hydro scheme E. diffused radiation v flow in a river are described wither by a time series of average daily flow F. proximate analysis G. made up of mean wind speeds, extreme wind speeds and variations in wind speeds v The head and flow of water v run-of-river schemes H. has higher mean wind speeds v Dark wall of large thermal mass separated from a glazed surface by a small airspace 1. azimuth angle greater than 90° v Estimate the future energy consumption for heating or cooling J. руrolysis v Number of heating degree days against the energy consumed in that month K. moisture content L. maximum energy output at the…
A submarine is present at a depth of 76ft below the surface of water. Determine the water pressure imposed on the submarine at the given depth.
Determine the emission rate of SOx [ton/day] from a rural ground level source if the 2000 m downwind concentration is 6.0 µg/m³. The wind velocity of 2 m/s and the Pasquill stability is Class C.