square tank 1.20m on each side,3m deep is filled to a depth of 2.70m with water. A WOODEN CUBE having a specifix gravity of 0.5 measuring 60 cm on an edge is placed in the water so that it will float. A.) Determine the weight of the water displaced by the cube Choices: 2.12 kN,1.06kN,1.15kN,2.30kN B.)Determine the rise of water above the original liquid surface Choices: 0.15m,0.088m,0.075m,0.30m C.) Determine the change in pressure force on one side of the tank Choices: 2.84kN,2.55kN,2.42kN,2.75Kn

Q: Water is flowing into a frustum of a conical vessel 2 m high at 100liters per minute. The vessel has…

A: To determine the height of water when the water surface is rising at 25.72 mm/min.

Q: 1 m A rectangular gate 1.6 m wide is used as a partition as shown. One side has linseed oil filled…

A: Given data in question  Depth Specific gravity  Width of gate To find out  Pressure on right side of…

Q: 3. A scoop carries 610 kg of load with center of mass at G. Neglecting the mass of the members,…

A:

Q: Describe about Flow Nets and Seepage.

A: Flow net is a graphical representation of two-dimensional steady-state groundwater flow through…

Q: Calculate the depth of the center of pressure for vertical rectangular plate having a height h =…

A:

Q: Determine the pressure at the higher end if the pressure at the lower end is 24.525 N/cm^2. 23.924…

A:

Q: Use both methods in computing for the hydrostatic force (in kips) acting on the submerged face of…

A:

Q: A rectangular pontoon 13.5m x 5.4m x 3.0m high floats in water with the 3.0m side vertical. The…

A: Given data, Length l = 13.5 m Width b = 5.4 m Depth d = 3.0 m Weight W = 420 kN Center of gravity G…

Q: -solve it with diagram A closed conical tank has a base diameter of 3m at the top and an altitude of…

A: An inverted closed conical tankBase diameter (D) = 3 m, Base radius (R) = D/2 = 1.5 mAltitude (H) =…

Q: , An open-topped tank with square bottom, 0.9 m on a side is 0.60 m high. It floats in water. A…

A:

Q: a vertical wall separates two different fluids in an open tank. the right side of the tank contains…

A: A tank have been given in the which has been separated by a wall and at the bottom of wall hinged…

Q: 11. A tank 3.66m has its ends vertical, top and bottom horizontal, 1.82m high. The top and the…

A: Given: Required to find:  the time necessary to lower the water surface to 1.22m

Q: The rectangular bin with an inclined gate AB is filled with water to the depth shown. Determine the…

A:

Q: 3. Find the pressure difference between A and B if: a.) x=4ft, y=2ft, z=3ft and Fluid 1 is water,…

A: To find out the pressure difference between  A&B.

Q: A tank is 1.8m deep and square length of 4.5m at the top and square length of 3m at the bottom. The…

A: Given- Depth h=1.8 m, Length of square top b=4.5 m, Length of square bottom a=3 m, Density- ρ=936…

Q: 1. The tank in figure is 3 m wide into the paper. Neglecting atmospher compute the hydrostatic (a)…

A:

Q: Problem 1: L= 100 ft. a) Determine the hydrostatic force (in kips) acting on the dam. b) Determine…

A:

Q: SITUATION 4 A concrete tank shown in Figure 4 is 80% full of water with 340 mm wall and floor slab…

A:

Q: up B What is the total resultant force (kN) that is applied on surface AB? Then find the location of…

A:

Q: A closed rectangular tank measuring 5 m long, 1.59 m wide, and 2 m high is filled to a depth of 1.6…

A: Given data,  L = 5m B = 1.59 m h = 1.6 m H = 2 m Horizontal acceleration = 9.81 m/s² SG = 0.68   To…

Q: Find the depth in a lake at which the pressure is 18500 lb/ft2. Recall Dwater=62.4 lb/ft3

A:

Q: Determine the height of water “h” above the top of the circular 1.24m diameter gate which will cause…

A:

Q: 1.GIVEN: The vessel is initially full. Do = 200 mm %3D C = 0.8 REQUIRED: Time to empty the vessel.…

A:

Q: Problem 2. In reference to the figure, gate XY is 1.20m wide and 1.40m long., If the liquid in the…

A: To determine total hydrostatic force "F" acting on the gate its line of action "h₂" vertically from…

Q: Determine the total hydrostatic force (N) in an inclined, rectangular gate 0.14 m width with oil on…

A:

Q: A vertical cylindrical tank 2 m in diameter and 3.5 m high has two steel hoops with diameter of…

A: Following are the given information. Diameter =2 m Height =3.5 m Hoops diameter =12 mm and 100 mm…

Q: A 1.2m diameter open vessel, 2m high is filled with oil s.g = 0.85 at a depth of 1.6m and rotated at…

A:

Q: The hydraulic cylinder extends at 0.5 m/s and determine the angular velocity and the angular…

A: The given figure is shown below:

Q: vertically into a body of water with open end down and floats with a 1300 N block of concrete (SG =…

A: D=350mm h=1.8m

Q: 6) What is the absolute pressure in the water at the very bottom of the tube? Pa Submit

A:

Q: 30'

A:

Q: ) Water flows in a rectangular channel of 5 m wide as shown in figure below. Calculate a) the force…

A:

Q: Find the height that the buoy sink in salt water, in meters. * Find the maximum height, in…

A:

Q: A square plate having one of its side equal to 3m is immerse in a water surface in a vertical…

A: Given square plate of side = 3mThe center of pressure = 8 cm from CG of plateIt is asked to…

Q: 5. A vertical rectangular gate as shown is 3 m wide and 6 m high is hinged at the top, has a sea…

A: