Spherical Tank Problem 3 The pressures Pa and Pe in the differential manometer gage are 154.415 kPag and 150 kPag respectively. If Y = 1.0 m. and Z = 0.5 m., determine the deflection X due to the deflection of special gage liquid, s.g.l. (s.g. = 2.95). PAS H2O PB s.g.l (s.g, = 2.95)

Spherical Tank Problem 3 The pressures Pa and Pe in the differential manometer gage are 154.415 kPag and 150 kPag respectively. If Y = 1.0 m. and Z = 0.5 m., determine the deflection X due to the deflection of special gage liquid, s.g.l. (s.g. = 2.95). PAS H2O PB s.g.l (s.g, = 2.95)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A differential manometer is attached to a horizontal water pipe at A and B. The deflection of…

A: Given Deflection of mercury is 0.5 m let density of water be ρ density of mercury be ρm

Q: Find the ratio of the system.r, and r₂ for m₁ = m₂ = 1 kg, k₁= 2000 N/m and k₂ = 6000 N/m Base k₁ k₂…

A: To find: The ratio of the system. Given: The masses are m1=m2=1 kg. The spring constant are k1=2000…

Q: As a part of your job, your role is to investigate the behavior of a hydraulic system that is…

A: Consider the diagram shown below for the given system. According to the Pascal's law, the pressure…

Q: A lO-kN car and 5-kN hoist are supported 1.8 m above the floor by a cylinder with a 300-mm bore .…

A: Total force acting on the cylinder,F=10+5=15kN=15000N Area of the bore of the cylinder,A=π/4*(d^2)…

Q: 1. If the gauge pressure of the air in the tank is known to be 20kPa. Determine the pressure in the…

A: Gauge pressure of Air, PAir=20 kPa=20*103 Pah1=10 cm=0.10 mh2=70 cm=0.70 mSpecific gravity of…

Q: If a = 8 cm Find the pressure at Pise B. PA = 200 000 Pa PB =?

Q: From the figure shown below, determine the support reactions at A, B and D.

A: The free-body diagram of CD can be drawn as below, Here, RC is the reaction due to support at C.

Q: 6. For the gate shown, a = 45°C, yı = 1 m, and y2 = 3 m. Will the gate fall or stay in position…

Q: Q1) Find the force F on the bottom of the tank if: K=1.5 m, H= 6 m, D=5 m. Air Oil Mercury s.g=0.9

A: Given data: k = 1.5 m H = 6 m D = 5 m S.G = 0.9 Need to determine the force at the bottom tank.

Q: • The length where the shear is zero (x) (f applicable) • The maximum shear load (Vman) – positive…

Q: w t Please write in clear handwriting a onaration 3. Problem: Detemine the gauge pressure pm at the…

Q: Three liquids of different densities fill connected tubes as shown in the figure below (not drawn to…

Q: A manometer is installed in a vertical pipeline. Determine the difference in pressure in PSI between…

A: The piezometric head can be determined as, Also,

Q: A spherical stainless-steel tank having an inner diameter ‘D’, is used to store natural gas at a…

A: given data D = 620 mm P =25 MPa Tensile stress =1000 MPa Shear stress = 440 MPa modulus of…

Q: 15.G.=13.6 The manometer is open to atmosphere Determine the gage prossure Pa at Point B

Q: Find the distance in meters of the centroid from the rocker colored in blue. -Inx N F(x) = In x Inx…

Q: 4.) The pressure gage reading is 70 kPa. Find the weight (kN) of the piston. 1mø Piston 1 m Ol S…

A: The pressure exerted by the fluid at a point which is located at a depth of h from the surface is…

Q: A 27 m vertical column of fluid (density 1878 kg.m3 ) is located where g= 9.65 m/sec2 . Find the…

Q: 13cm Vaxn's 29cm 26cm StaNcs Xax. S. Find The location of conter of gravity ●

A: Given data Height of triangle = 13 cm Base of triangle= 26 cm Find the centre of gravity.

Q: R1 = 5 cm. F1 = 1000 N, and R2 = 40 cm. Express the answer in Newtons.

Q: 11. The figure shows a high-pressure hand pump used for boosting oil pressure in a hydraulic line.…

A: Given, For the high pressure hand pump, θ=15° Force, P=120 N. Diameter of the piston, d=46mm

Q: For the tank shown below, find the elevation of the liquid in manometer column A and B and determine…

A: PA-ρgx-(ρgh)air=-20000…

Q: A cylindrical buoy 600 mm in diameter and 1.8 m high weighs 205 kg. It i moored in salt water to a…

A: Buoys are floating objects used to locate the position in the water. They rise or drops according to…

Q: Calculate the value of the hydrostatic pressure force acting on the septal septum shown in the…

Q: water Somm 50mm 19.6.=13.6 is de manometer SG.=0.9 200mm 134,5mm •S.G= 13.6

Q: Problem 4: The U-tube manometer is also widely used to measure the difference in pressure between…

A: Given dataVdf=8.236 KNm3VEO=8.955 KNm3PA=105.49 KNm3Vmercury=133 KNm3

Q: 40 N 30 N B -3m -3 m 50

A: The free body diagram represents the all the forces acting on the system including the reactions.…

Q: Determine the area and the centroid (x, y) of the area. 4 m y = 4x - 4 m O (x = 2.2 m, y= 6 m) None…

A: Centroid of an area is defined as the point in the area which is located such that it is equidistant…

Q: The uniform 5-m-long round wooden rod is tied to the bottom by a string. find the tension in the…

Q: Q3- Find H and the pressure gage P as shown in Fig. 125 mm d H 75 mm d 175 mm 100 mm d Hg (13.57)

Q: 5. The gas used in a gas engine trial was tested. The pressure of gas supply is 10cm of water…

Q: A closed cylindrical vessel 5 ft in diameter and 6 ft high is 3/4 filled with molasses (SG = 1.24)…

A: Given data: Diameter of cylindrical vessel = 5 ft Height of cylindrical vessel = 6 ft The vessel is…

Q: 3.29 Arectangular tank, open to the atmosphere, is filled with water to a depth of 2.5 m as shown. A…

A: Given data Height of the water in the tank= 2.5m Height at which U tube manometer is connected from…

Q: The cross section of a concrete dam JKLMN as shown in Figure 1 is used to retain water. The specific…

Concept explainers

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.

Question

Spherical Tank
Problem 3
The pressures PA and PB in the differential manometer
PA
gage are 154.415 kPag and 150 kPag respectively.
If Y = 1.0 m. and Z = 0.5 m., determine the deflection
X due to the deflection of special gage liquid, sg.l.
H2O
(s.g. = 2.95).
PB
sg.l
(s.g, = 2.95)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Show solutions pls
3.) For a gage reading of -17.1 kPa determine the (a) elevations (m) of liquids in the open piezometer columns E, F, andG and (b) the deflection of the mercury (m) (Sg = 13.6) Gage E F G Air El. 15 m s= 0.70 El. 12 m Water El. 8 m S = 1.6 El. 4 m Mercury
Find T1 and T2
A spherical stainless-steel tank having an inner diameter ‘D’, is used to store naturalgas at a pressure of ‘p’. The properties of the steel are as follows: yield stress in tensionis ‘T’; yield stress in shear is ‘S’ and modulus of elasticity is ‘E’. The desired factor ofsafety with respect to yielding is ‘F.S’.Determine the minimum permissible thickness t min of the tank. D (mm)=620 p (MPa)=25 T (MPa)=1000 S (MPa)=440 E (GPa)= 208 F.S=3.4
A 27 m vertical column of fluid (density 1878 kg.m3) is located where g= 9.65 m/sec2. Find the pressure at the base of the column.Ans. 489.313 kPa Please give me the solution.
Find the ratio of the system r, and r₂ for m₁ = m₂ = 1 kg, k₁= 2000 N/m and k₂= 6000 N/m Base k₁ k₂ 00000 m₁ ellee m₂ O a. r₁=-31.88 and O b. ₁ 1.1805 and O c. r₁=4.755 and O d. r₁= -0.0761 and x₁(1) r₂ = 20.911 12 = -0.8471 r2 = -61.34 x₂ (1) 12 = -5.541
2. water 134,5mm HZ •S.G= 13.6 50mm 50mm SG.=0.9 15.G.= 13.6 The manometer is 200mm open to atmosphere at Point B Determine the gage prossure Pa A
Find the height to be raised P.E=2442.11 J Mass=23 kg
80 min 200 mm 11. The figure shows a high-pressure hand pump used for boosting oil pressure in a hydraulic line. When the handle is in equilibrium at theta=15 deg under the action of a force P-120 N, determine the oil pressure p which acts on the 46 mm diameter piston. (Pressure on the top of the piston is atmospheric). 200 mm piston. Ans: P=0.27 MPa mm
B7
Find the height h of the mercury column.
40 N 30 N B -3m -3 m 50