speed of 1500 rpm (revolutions per minute) is connected to a mechanical load. The current of the motor is 10A. If the torque applied to the load is 13Nm, compute the total power loss

Q: In an induction motor running, if the direction of the rotating field is changed by swapping the two…

A: When we swapping any two phase of induction motor,  direction of rotating magnetic field get reverse…

Q: If the prime mover torque suddenly falls by a considerable amount, the damperwinding of the…

A: If the prime mover torque suddenly falls by a considerable amount, the damper winding of the…

Q: a current of 30 A while running at 700 rpm. The armature and series field resistances are 0.1 Ω, 0.2…

A:

Q: A 24 KW, 140 V, Duplex Lap-Wound DC machine has been set to induce rated voltage at a constant K…

A:

Q: Find the torque developed in an induction machine rotating at 1450rpm if the power developed is 4kw.…

A:

Q: If the prime mover torque suddenly falls by a considerable amount, the damperwinding of the…

A: The objective of the question is to understand the role of damper windings in an alternator when…

Q: A 220V DC motor rotating at 1500 rpm (revolution per minute = devir/dakika (d/d)) draws 10A. The…

A:

Q: A DC motor is initially at rest and is then connected to a 12V battery. The motor has aresistance of…

A: The objective of the question is to determine the current through the motor as a function of time,…

Q: The induced voltage in dc motors beyond the pole edges is Select one: O a. infinity Ob. 180 V OC.…

A: induced voltage=eind=(BxV).leind=(BxV).leind=BVlSinθB=Magnetic feildV=Velocityl=Lengthθ=angle…

Q: 4. Explain the importance of residual voltage in a dc generator. Note: Figures and sketches are…

A:

Q: Q2: If the rated frequency for an induction motor is 60 Hz and the maximum tonque Tm is 100 N.m,…

A:

Q: A four-pole induction motor drives a load at 2575 rpm. This is to be accomplished by using an…

A:

Q: 8. Find the counter-EMF voltage of a permanent magnet DC motor when it runs at 2080 rpm. The…

A: The solution is given below

Q: The armature and field resistances of a series machine are 0.2 ohm and 0.3 ohms respectively. While…

A: Machine is series wound machine Armature resistance Ra = 0.2Ω Field resistance Rf = 0.3Ω No load…

Q: While discussing electric motors: Technician A says that when there is high CEMF, there will be high…

A: Given, While discussing electric motors: Technician A says that when there is high CEMF, there will…

Q: SHOW THE CIRCUIT AND COMPLETE SOLUTION A 75-KW, 440V DC generator has 90% efficiency during full-…

A:

Q: An electric motor with a mass of 42 kg, rated speed of 3760 rpm and unbalance of 0.002 kg.m must be…

A: Given:-  Mass (m)= 42kg Speed (N)=3760rmp Unbalance =0.002 kg.m Force transmissibility =0.141…

Q: The machine shown in Figure 2 has three concentrated stator coils, each of eight turns. The coils…

A:

Q: A 240 V series lift motor has resistance of 0.2 ohm. At the speed of 1800 r.p.m. it takes 40 A. Find…

A:

Q: If the prime mover torque suddenly falls by a considerable amount, the damperwinding of the…

A: The objective of the question is to understand the role of damper windings in an alternator when…

Q: V DC separately excited motor has ure resistance 2 ohms and voltage constant V /rad/s. The field…

A: V = 100 V Ra = 2 ohm Kb= 0.6 V/rad/s T= 20 Nm Kt = 50 Nm/s

Q: 2. Calculate voltage drop across the 2 2 resistor for the circuit shown below using nodal analysis.…

A: Given here a electrical circuit and asked to find the voltage across the 2 ohms resistor.

Q: In a DC machine, the reversal of current from one direction to opposite direction is done by O…

A: In DC machine there is a mechanical converter which is used to change the direction of current.

Q: Appliances in home that use DC motor and briefly explain why it works as reverse DC generator

A: => Dc motor are commonly used in the household appliances Like -: vacuum cleaner, food mixer…

Q: A 13kV/50Hz/50MW generator is rotated at 750 rpm. The mechanical power loss of the system is %10…

A: given data: A 13kV/50Hz/50MW generator is rotated at 750 rpm. The mechanical power loss ofthe system…

Q: Q3: A universal fractional horsepower series motor has a resistance of 30 Q and a total inductance…

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: Q1) A separately excited DC generator supplies 150 A to a DC grid. The generator is running at 800…

A:

Q: The e.m.f. induced in the armature of a shunt generator is 600V. The armature resistance is 0.1 ohm.…

A: Given, Induced EMF, Eg = 600 V Armature resistance, Ra = 0.1 ohm Armature current, Ia = 200 A…

Q: 5 10 15 20 25 30 Wind speed From the power curve above, estimate the value of the following: t-in…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: A 415V squirrel cage induction motor develops a torque of 40Nm. The torque developed by the motor if…

A:

Q: .The self-induction of acoil undergoing commutation causes..........at the brushes. 4.The back…

A: 3. .The self-induction of a coil undergoing commutation causes produce reactance voltage at the…

Q: A 240 V, 50 Hz, single-phase capacitor start a.c. motor is loaded such that the ship is 6% The motor…

A:

Q: ) A dc shunt machine while running as generator develops a voltage of 240 V at 1000 rpm. on no-los…

A: In this question we will find speed and efficiency of dc motor....

Q: A 5MW rated power wind turbine has a rotational speed of 20 rpm. If the wind speed is 54km/hr and…

A: Given: A 5MW rated power wind turbine has a rotational speed of 20 rpm. If the wind speed is 54km/hr…

Q: The DC shunt generator with the terminal voltage 350 V, armature drop 6 V and the total brush drop 4…

A: A dc shunt generator V=350V Armature drop=6v Brush drop= 4v

Q: V DC separately excited motor has ure resistance 2 ohms and voltage constant V /rad/s. The field…

A: Note: As the question data is incomplete, still i am trying to solve it by taking some random data.…

Q: A 197-watt permanent magnet DC motor has an armature res istance of 5.678 ohms. Determine the…

A: Given data is written as follows:

Q: A direct current shunt dynamo continuously supplies an ohmic load of 50 Ohm at terminal voltage Vt=…

A:

Q: f the angular speed of a rotating machine is 188.5 rad/sec, The speed in rpm is ........... a. 1000…

A: There are two different methods to measure speed of rotation. One is is radians per second and one…

Q: Q5/ in a DC motor. List and describe the types of losses that occur

A: