Some N2 gas is mixed with some O2 gas, and the sketch below shows a representative sample of the mixture. The total pressure of the mixture is measured, and found to be 2.00 atm. key carbon hydrogen nitrogen sulfur oxygen chlorine Calculate the mole fraction and partial pressure of each gas in this mixture. Round your answers to 3 significant digits. You may assume each gas behaves as an ideal gas. gas mole fraction partial pressure ×10 N₂ ☐ ☐ atm 02 ☐ ☐ at atm

Some N2 gas is mixed with some O2 gas, and the sketch below shows a representative sample of the mixture. The total pressure of the mixture is measured, and found to be 2.00 atm. key carbon hydrogen nitrogen sulfur oxygen chlorine Calculate the mole fraction and partial pressure of each gas in this mixture. Round your answers to 3 significant digits. You may assume each gas behaves as an ideal gas. gas mole fraction partial pressure ×10 N₂ ☐ ☐ atm 02 ☐ ☐ at atm

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter8: Gases

Section: Chapter Questions

Problem 97E: Hydrogen azide, HN3, decomposes on heating by the following unbalanced equation: HN3O(g)N2(g)+H2(g)...

See similar textbooks

Similar questions

A 1.000-g sample of an unknown gas at 0C gives the following data: P(atm) V (L) 0.2500 3.1908 0.5000 1.5928 0.7500 1.0601 1.0000 0.7930 Use these data to calculate the value of the molar mass at each of the given pressures from the ideal gas law (we will call this the apparent molar mass at this pressure). Plot the apparent molar masses against pressure and extrapolate to find the molar mass at zero pressure. Because the ideal gas law is most accurate at low pressures, this extrapolation will give an accurate value for the molar mass. What is the accurate molar mass?
Exhaled air contains 74.5% N2, 15.7% O2, 3.6% CO2, and 6.2% H2O (mole percent). (a) Calculate the molar mass of exhaled air. (b) Calculate the density of exhaled air at 37C and 757 mm Hg and compare the value you obtained with that of ordinary air (MM=29.0g/mol) under the same conditions.
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
Hydrogen azide, HN3, decomposes on heating by the following unbalanced equation: HN3O(g)N2(g)+H2(g) If 3.0 atm of pure HN3(g) is decomposed initially, what is the final total pressure in the reaction container? What are the partial pressures of nitrogen and hydrogen gas? Assume the volume and temperature of the reaction container are constant.
A mixture of N2 and Ne contains equal moles of each gas and has a total mass of 10.0 g. What is the density of this gas mixture at 500 K and 15.00 atm? Assume ideal gas behavior.
The density of air 20 km above Earths surface is 92 g/m3. The pressure of the atmosphere is 42 mm Hg, and the temperature is 63 C. (a) What is the average molar mass of the atmosphere at this altitude? (b) If the atmosphere at this altitude consists of only O2 and N2, what is the mole fraction of each gas?
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
Describe the factors responsible for the deviation of the behavior of real gases from that of an ideal gas.
Plot the data given in Table 5.3 for oxygen at 0C to obtain an accurate molar mass for O2. To do this, calculate a value of the molar mass at each of the given pressures from the ideal gas law (we will call this the apparent molar mass at this pressure). On a graph show the apparent molar mass versus the pressure and extrapolate to find the molar mass at zero pressure. Because the ideal gas law is most accurate at low pressures, this extrapolation will give an accurate value for the molar mass. What is the accurate molar mass?