Some data for saturated methyl chloride (CH3Cl) is given in the table below: State T(°C) P(atm) v(/Kg) h(kJ/kg) Liquid -40 0.47 0.00097 0 Vapor -18 1.29 0.31 456 Vapor 10 3.54 0.12 470.06   Calculate ∆u (specific internal energy) and ∆h (specific enthalpy) for the transition of saturated vapor CH3Cl from 10°C to -18°C.

Q: 10 m of cold air (measured at 287 K and 101.3 kN/m2 saturated with water vapor) is compressed to 330…

A:

Q: From the table of the standard entropy values, calculate the standard entropy changes for the…

A: Temperature = 25°c = 298 K S°H2 = 131  J/K.mol S°Cl2 = 223 J/K.mol S°HCl = 187 J/K.mol

Q: a. Draw and label a ternary phase diagram consistent with the above data. b. Draw and label a…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Caloulate the change in entropy that occurs in the system when 40.6 g of acetone (C, HO) vaporizes…

A: The change in entropy of the system is to be determined.

Q: Shown here is a table of the vapor pressure of benzene and toluene, Vapor Pressure (kPa) Temperature…

A: The given data The variation of vapor pressure of benzene and toluene with respect to temperature is…

Q: the relative humidity,

A: (a) The relative humidity is defined as the ratio of the partial pressure of the condensable vapour…

Q: 7 (b) A mixture containing 50 g water and 50 g ethyl aniline, which can be assumed to be essentially…

A: The problem involves a mixture of water and ethyl aniline, two substances that are assumed to be…

Q: A quantity of 505 J of heat are added to 11.3 g of water at 28.3 °C. What is the final temperature…

A: When heat is supplied to any system, the temperature of the system increases. In this case, heat is…

Q: Suppose you want to cool a liter of water (equivalent to 1 kilogram) from room temperature (26°C) to…

A: If temperature of system has to increase then heat must to be added. When the temperature of a…

Q: A 5 kg/min stream of liquid ethanol-water at 40 °C containing 30% w/w of ethanol will be heated and…

A: To find:(a) What will be the composition  of the liquid at the bottom?(b) What will be the…

Q: PROBLEM 2: The vapor pressures of 1-chlorotetradecane at several temperatures are tabu- lated here:…

A: Vapor pressure has the same units as pressure. The vapor pressure is obtained from the Antoine…

Q: Q18) (a) Using Gibb’s phase rule and phase diagram of a pure substance (CO2) shown below, calculate…

A: Phase diagram of pure substance (CO2):

Q: A gasification plant of MSW produces syngas of the following Component Composition (dry volume %)…

A: The dry volume composition of the syngas is given as: CO = 30%, H2 = 40%, CO2 = 30% Mass of syngas…

Q: conditions. The total pressure is (1.013*10° Pa) and 298 K. The concentration of NH3 at one point is…

A: The transfer of mass or moles from one location to another location due to some driving force is…

Q: Prepare a table of temperature/composition data for the benzene(1)/water(2) system at a pressure of…

A:

Q: Given that at 10 mm Hg glycerol boils at 167.20C and at 760 mm Hg, 290oC, calculate the constants A…

A:

Q: The enthalpy of vaporization of a certain liquid is found to be 14.4 kJ mol-¹ at 180 K, its normal…

A:

Q: 11.7-2. Boiling Point, Dew Point, and Flash Vaporization. Following is the composition of a liquid…

A: The boiling point is where the vapor composition pressure is equal to the surrounding pressure of…

Q: Phase Molar heat capacity, Cm(Jmol⋅K) ΔHfuso(kJmol) ΔHvapo(kJmol) Melting point (oC) Boiling point…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: 5.) The standard entropy change for the raction shown below at 298K is -266 J/mol·K. Calculate the…

A: Given:  Entropy Change for a Reaction = -266 J/mol K  Entropy of O2 = SO2 = 205 J/mol K  Entropy of…

Q: Tabulated values from literature for the latent heat of benzene in J/g are provided in the table…

A: Latent heat of vaporization of benzene at 25 0C = 393.3 J/gLatent heat of vaporization of benzene at…

Q: The vapor pressure of a single component, 2 phase system (vapor is assumed to be ideal gas) was…

A: Given Data : The temperature-pressure data of the single-component two-phase system is given as:…

Q: The viscosity values for the H2 and Freon-12 gas mixtures at 25 ° C and 1 atm pressure and the mole…

A: Given that, The viscosity of pure H2 gas (Mole fraction of H2 = 1)  μ1 = 88.4×10-6 poise The…

Q: ) A 3.0 L flask containing 2.0 mol O2 and 1.0 mol N2 is in a room that is at 22.0° What is the total…

A: The volume of the flask = 3 L Moles of O2 in the flask = 2 mol Moles of N2 in the flask = 1 mol The…

Q: 4-83 Determine the specific volume of superheated water vapor at 15 MPa and 350°C using (a) the…

A:

Q: An oxygen tank has a volume of 100 ft³. When one pound of gas is expelled from the tank. the…

A: Given Volume of tank V = 100 ft³ Initial temperature T1 = 80°  One pound of O2 remove Final…

Q: You closed the mouth of the 5 liter empty PLASTIC bottle at 20oC, when you took the PLASTIC bottle…

A: The initial volume of the empty plastic bottle, V1 = 5 L Initial temperature of the plastic bottle,…

Q: A closed fixed-volume vessel contains a mixture of benzene and toluene in vapor-liquid equilibrium…

A: Given data: Pressure at vapor-liquid equilibrium = 1.5 bar Composition of air in the vapor phase =…

Q: For a liquid mixture of 10mol% ammonia in water, calculate the partial pressure of ammonia in the…

A: Given: The mole fractions of ammonia in solution is xNH3 = 0.1 or 10 mol% Thus, the remaining is the…

Q: In the experiment of finding the specific temperature of the metal by mixing you have a metal of…

A: Given that, Mass of metal aluminum, mAl = 67 g, specific heat CAl= 0.21 cal/g.⁰C Temperature of…

Q: An ideal gas expands inside a ston-cylinder device from 0.1 m o 0.25 m isothermally. The temperature…

A: Given Data :

Q: The specific volume of superheated Refrigerant 134-a at 1.4 MPa and 110°C is 0.019597 m³/kg in the…

A: Answer:a) we have,  from iddeal gas V= RTP Molecular weight of Refrigerant 134a = 102 g/mol

Q: Determine the specific volume of refrigerant-134a at 2MPa and 100°C,

A: Specific volume is defined as the ratio of volume to the mass of the material. It is also defined as…

Q: Q3: If fluid is thrown from an 807 m-height mountain 15.0°C, what is the maximum temperature of the…

A: Height from which water is thrown, H = 807 m Initial temperature, T1 = 15.0 °C = 288.15 K Heat…

Q: The oxidation of chlorine monoxide occurs according to the following: CIOg) + 0,) = CIO,(2) A,H"…

A: Write the reaction as follows: ClOg + 12O2g ⇆  ClO2g   Calculate the standard enthalpy of the…

Q: 13.72 Calculate the vapor pressure of a solution of 34.0 g of glyc- erol (C,H,O,) in 500.0 g of…

A: The vapor pressure of the solution of glycerol and water is to be calculated.

Q: 56gm of an olefine gas (CuH2a) occupies 40 liters at 1.23 atm (Absolute) and 27'C (ideal behavior).…

A:

Introduction and Basic Calculations in Multiphase Systems

Chemical calculations involve material and energy balance calculations which enable engineers to calculate material and energy requirements in various chemical processes. In addition to this, chemical calculations help to study the behavior and properties of gases, liquids, and their mixtures.