Solve the given problems: 1. An I section has the following dimensions in mm units. Top flange = 150 x 50 Bottom flange = 300 x100 Web = 300 x 50 Find the center of gravity (centroid).

Q: The frame shown is fitted with three 53 cm diameter frictionless pulleys. A force of F = 635 N is…

A: Data given Diameter of pulley =  53 mm F =635 N Find:  (a) At point A, Force at A (b) Reaction…

Q: Problem 10.2 A) For the cantilever beam shown, determine the equation of the elastic curve (e.g.…

A: Given, Cantilever beam with uniformly distributed load    To find : Equation for elastic curve and…

Q: 4.3 Based on the information given in the following table and for each assigned problem, calculate…

A: Mu = 327 k-ftb = 50 inbw = 14 int = 3 ind = 13 infc = 3 ksify = 60 ksiTo find:  The tension steel…

Q: Determine the magnitude of the BIR Assume W-760 lb. a -5.4 ft. b-3.8 ft.r-7 in. W с Answer: A- B A…

A:

Q: Required information A weight Wis supported by bar AO and cables AB, AC, and AD. Point A lies in the…

A: Given:- Weight is supported by bar AO and cable AB, AC, and AD The strength of the bar AO = 3000 lb…

Q: F2 F1 F1 W W D W G. F - AO E Determine the support reactions at A and E. Determine the forces in…

A:

Q: Ea * a *- a а — D F4 В G

A: We will use the method of joints to analyze this truss. Support reactions at A= RA Support reaction…

Q: The post having the dimensions shown is subjected to the load P. Specify the region to which this…

A: Equivalent forces system Free-body diagram:

Q: Calculate the shape factor for the section shown. F1.0 in. 6 in. 1.0 in. e- 6 in.

A: Shape factor: The ratio of plastic modulus of a section to the elastic modulus of the section is…

Q: For the truss shown in Figure 3, members AC and BC have cross sectional area of 2 in.² while members…

A: Diagram;MemberP-ForceK-ForceArea (A)PKL/AEAC124/32 in^2139.63AB-15-5/34 in^268.18BC002…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.