Solve the following parts: a) Calculate the pressure at the bottom of a 30-foot-deep lake in lb/in² and psig. Assume that the lake water has a specific gravity of 1.05. b) Ideal gas law constant has a value of 8.314 J/mol-K. What is the value of the ideal gas law constant in units of Btu/mol-°F?

Q: 16. What is the unit of resistance in SI? O w O W/K O m-K/W O W/m^2-K O K/W

A: Asked;  SI unit of resistance

Q: Explain steady flow in relation to fluid mechanics.

A:

Q: Briefly explain the concept of steady state as it applies to diffusion

A: Diffusion is the process through which particles, molecules, or substances spread or travel from a…

Q: t types of ideal flow patterns in gas

A: Membranes are used in the mass transfer as a barrier in the separation processes. A membrane…

Q: B/ Define the Schmidt number, Prandtl number and Reynolds number and clear up the relation for each…

A: The Schmidt number (Sc), Prandtl number (Pr), and Reynolds number (Re) are dimensionless variables…

Q: What is the basic equation for computing the rate of mass transfer through a membrane?

A: Consider mass transfer through a membrane of area Am takes place from one container with…

Q: Explain flow rate in relation to fluid mechanics

A:

Q: Convert a viscosity of 20 (g)/(cm)(s) to the American Engineering units (Ibr)(hr)/(ft?)

A: Given viscosity is 20 g/cm s Viscosity unit of g/cm s have to convert into American Engineering unit…

Q: Strain is d Both a O chang O chang O O O

A: Introduction: Strain: It is defined as the amount of deformation that a body experiences on the…

Q: What type of materials are membranes made of? Can the membranes be non-porous or if so, how / in…

A: What type of materials are membranes made of? An MBR membrane is essentially a substance that…

Q: Why does the fluid drop in the fluid level measurement experiment when the pump is turned off?

A: In a typical fluid level measurement experiment, the pump is used to recirculate the fluid in a…

Q: Q.3 a). A tensile stress is to be applied along the long axis of a cylindrical brass rod that has a…

A: The magnitude of load is to be calculated.

Q: There are two previously undeformed cylindrical specimens of Aluminum alloyithat are strain hardened…

A:

Q: 2. How is phase diagram of water different from most other materials show with sketches. What is its…

A: In a phase diagram; there are certain important terms which should be explained first. Different…

Q: on control, with no datum features, can be applied to two or more

A:

Q: This type of support has a vertical reaction and a vertical load resisting load (A Unsupported B…

A:

Q: Explain the relationship of Density and Specific Gravity

A: Explain the relationship of density and specific gravity.

Q: 2. List the most important pipe friction formula.

A: Introduction: The friction loss in uniform, instantly sections of pipe, called "major loss", is…

Q: Explain the concept of fluid flow and its significance in chemical engineering processes.

A: The study of fluids, which includes liquids and gases, is known as fluid flow. Fluids may flow and…

Q: Using a flow chart, show how a lubricant oil with high viscosity index can be manufactured from…

A: In petroleum industries, Crude oil is a type of fossil fuel that is a naturally occurring petroleum…

Q: production of paper from ground nutshell complete flow chart

A: In this question flow chart of production paper from ground nutshell is to be discussed.

Q: What

A: The hydrosphere is combined mass of water on ,above and below surface of earth.

Q: Baffles increases the fluid velocity on the tube side. True False

A: Baffles are used to direct fluid across the tube bundle and run perpendicularly to the shell.…

Q: What is the maximum radial distance traveled by any particle in cyclone seperator?

A: Chemical processes consist of the separation stages in which the process streams are separated and…

Q: In the section of a shell and tube exchanger shown on figure 4 the outer diameter of the inner tubes…

A:

Q: Explain and describe possible factors that may affect fluidization.

A: Fluidization parameter (calculated via inlet air drift fee and rotor speed), stress distinction over…

Q: A system asshown in the figure is used to measure accurately the pressure changes when pressure is…

A:

Q: Derive the three laws of crushing from fundamental equation

A:

Q: Please discuss "Drilling problems related to drilling fluid rheological property"

A: Drilling muds or fluid is sued as carrier of rocks produced during the oil and gas drilling…

Q: Calculate the net force acting on the cone in Figure 4.69. Im Water 3 m Figure 4.69 System for…

A:

Q: Reynolds analogy is preferred over Chilton-Colburn analogy. O True False Depends on Sh O Only for…

A: Chilton Coulburn analogy is widely successful analogy used for estimating mass transfer…

Q: What is the bulk-flow effect in mass transfer?

A: The effect of bulk flow in mass transfer is to be defined.

Q: In measuring the surface tension of a liquid (drop weight method), 20 drops of the liquid (? = 0.2…

A: Mass of the liquid, m = 0.95 g Diameter of the tip, dtip = 0.4 cm Number of drops, N = 20 Radius of…

Q: In what dimension is the concept of material balance based?

A:

Q: Why is centrifugal force frequently applied to speed up and facilitate particle-fluid separation?

A: Centrifugation technique uses centrifugal force for the separation of very fine particles from the…

Q: Calculate the viscosity of oxygen at 350 K and 1 atm pressure using equation 7.12 on page 90 of the…

A: Given data: Temperature = 350 K Pressure = 1 atm

Q: 4.) Consider a metal single crystal oriented such that the normal to the slip plane and the slip…

A: Given data: We have a metal single crystal oriented such that the normal to the slip plane and the…

Q: Food storage containers are rigid.As a result, they can keep their shape to hold food.When food…

A: Introduction Most food  storage containers-both single-use and reusable ones,  are made of some…

Q: Describe laminar and turbulent regimes of fluidization

A: The turbulent fluidization regime is happened in between the bubbling and fast fluidization flow…

Q: A peak elutes from a column at 25.7 min, with a width at half height of 14.9 s. How many theoretical…

A: Retention time (tr)  = 25.7 min  Width at half height (W1/2) = 14.9 s Theoretical number of plates N…

Q: The viscosity of honey is about 1 Pa-s. The viscosity of water at 20C is about 1 cp. How many times…

A: Given  Viscosity of honey  µhoney  = 1 Pa-s Viscosity of water  µwater= 1 cp

Q: Describe all the methods of measuring flow in field for pipe flow?

A:

Q: Write the name of the fundamental dimensions

A: Write the name of fundamental dimensions.