Solve nernst equation for solid oxide fuel cell by using natural gas as fuel and oxygen at cathode The input parameters of single cell are given below: Operating temp=550°c Cell voltage=0.8v Power density=850mw/cm2 Cell active area= 121cm2 Power of single cell=103 wat Ocv=1.020 Current density=2250mA/cm2

Q: Qut A thermo.couple junction of area A, mass m, heat capacity C, and emissivity e in a furnace which…

A:

Q: A shell-and-tube heat exchanger consists of 120 tubes of internal diameter 22 mm and length 2.5 m.…

A:

Q: Derive equation for LMTD for parallel flow heat exchanger. Also state necessary assumptions made for…

A: 1) Conduction in tube and shell is negligible2) steady flow conditions3) Kinetic as well as…

Q: A shell-and-tube heat exchanger is to heat an acidic liquid 1. that flows in unfinned tubes of…

A: Key Concept: Heat Transfer & Phase Changes Heat transfer refers to the movement of thermal…

Q: A 20-cm diameter cylindrical enclosed pan is placed on top of a heating unit for vaporizing propane…

A: Given:The diameter of the pan Vapor pressure of propane The heat flux Surface temperature of the…

Q: 45 kg/h liquid propylene will be cooled from 300 K to 288 K by chilled water through a shell and…

A: Heat capacity of liquid propylene at 294 K is 2.6 kJ/kg-KCp-pl = 2.6 kJ/kg-KFlow rate of liquid…

Q: A surface is to be kept at 20 °C (68 °F) with a fixed heat flux of 500 W/m2 , determine the driving…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: furnace is to be designed for a heat duty of 11111.1 BTU/s. If the overall efficiency is 75%. The…

A:

Q: Q4: A 2mm-diameter and 10-m-long electric wire is tightly wrapped with a 1-mm-thick plastic cover…

A: Given data are as follows: Diameter of electric wire d = 2 mm Length of electric wire L = 10 m…

Q: We wish to calculate the internal heat transfer coefficient for water flowing at 0.00958 m/s through…

A:

Q: 1. Heat transfer mechanisms W/m2, determine the driving force (AT in °C and Ts °F) required to…

A: Hello. Since your question has multiple sub-parts, we will solve the first three of the requested…

Q: 2. = The hot and cold inlet temperatures to a concentric tube heat exchanger are Thi = 200°C, Tc,i…

A: Step 1: Step 2: Step 3: Step 4:

Q: 5. A two-pass shell-and-tube heat exchanger cools a hot liquid process stream (120 to 140 C inlet…

A: Given: Process fluid in at 120 to 140 °C Process fluid out at 70 °C Cooling water available at 20 °C…

Q: A heat exchanger is to consist of a number of tubes each 25 mm diameter and 5 m long arranged in…

A: pressure drop = 2KN/mdiameter, d = 25 mmlength, l= 5mviscosity, = 1 mNs/m2 = 10-3 NS/m2Heat load =…

Q: -/20 meat pump operates on the ideal vapor compression refrigeration cycle with R-134a as the…

A: We will use table 134a,How to find the entropy.We will evaluate the conditions.

Q: None

A: Let's go through the detailed step-by-step solution for designing a shell and tube heat exchanger…