Question 1Solar photovoltaic system requires charge controller to store generated electrical energy tothe battery bank. Figure 1 shows a Maxwell bridge which can be used to measure unknowninductance, L, in a power electronic circuit in a charge controller.(a) Based on Figure 1, analyse the value of R₁ and L₁(b) If R₁=3000, C3=0.15µF, R4-3000, while R3 is adjustable between 3000 and 3kn,evaluate the range of the inductance, Ls(c) Then, if the power supply frequency is set to 5kHz, analyse the Q factor of the inductorLs at its minimum value.E23Z₁R3R1C3Figure 1D51RSR₂22wwwZA

Given circuit is Maxwell bridge circuit. Let operating frequency as f, then ω=2πf and Z1=R1 Z2 =Rs +…

Solar photovoltaic system requires charge controller to store generated electrical energy to the battery bank. Figure 1 shows a Maxwell bridge which can be used to measure unknown inductance, L, in a power electronic circuit in a charge controller. (a) Based on Figure 1, analyse the value of R, and L (b) If R₁=3000, C₁=0.15µF, R=3000, while R, is adjustable between 3000 and 3kn, evaluate the range of the inductance, Ls. (c) Then, if the power supply frequency is set to 5kHz, analyse the Q factor of the inductor Ls at its minimum value.

Solar photovoltaic system requires charge controller to store generated electrical energy to the battery bank. Figure 1 shows a Maxwell bridge which can be used to measure unknown inductance, L, in a power electronic circuit in a charge controller. (a) Based on Figure 1, analyse the value of R, and L (b) If R₁=3000, C₁=0.15µF, R=3000, while R, is adjustable between 3000 and 3kn, evaluate the range of the inductance, Ls. (c) Then, if the power supply frequency is set to 5kHz, analyse the Q factor of the inductor Ls at its minimum value.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Similar questions

A rubber rod is rubbed with fur, so that the fur becomes positive. The rod is then used to charge an electroscope. The charge on the electroscope will be:positive if charged by contact. neutral. positive if charged by induction.negative if charged by induction.
i need the answer quickly
If the charging resistor was twice as large as the discharging resistor in Figure 4, theamplitudes of the charging and discharging waveforms would be ________.a. The sameb. Different
If the resistors used for charging and discharging were the same, the charging anddischarging waveform would be ________.a. Symmetricalb. Nonsymmetrical
Given that the zener diode has a valaue of Vz = 35 V. Find the maximum current flowing through the zener diode. **Please show your correct and complete solution for this circuit problem. ASAP! Thank you!**
Find the equivelent resistance of the circuit below. (Rin)Conduction diodes' resistance is 0Insulating diodes' resistance is infinite.R1 = 10 ohm
choose the correct answer
Electrical Engineering Why/how is a small 100OHMS source resistor used to measure the phase angle of current using the oscilloscope?
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 2 ms/cm, and the 'volts/cm' switch is set to 1 V/cm. Determine the (i) amplitude of waveform Q (i) peak to peak value of waveform P. (ii)i frquency of waveform P and (iv) phase angle difference between P and Q in Degrees. Upload your Answers steps in the "Final Answer Submission" Link provided in the Moodle. () Amplitude of waveform Q = (ii) Peak to peak value of waveform P = (ii) Frequency of waveform P = (iv) Phase angle difference between P and Q in Degrees =
C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.
Please solve and answer the question correctly please. Also be sure to give the correct units. Thank you!