Answered: ในแต่ละข้อทำวิธี Slope-Deflection และ… | bartleby

Related questions

Question

ในแต่ละข้อทำวิธี Slope-Deflection และ Moment Distribution Method
*10-8. Determine the moments acting at A and B. Assume
A is fixed supported, B is a roller, and C is a pin. El is
constant.
20 kN/m
80 kN
B
9 m
3 m
3 m.
Prob. 10-8
*10-12. Determine the moments at B and C, then draw
the moment diagram. Assume A, B, and C are rollers and D
is pinned. El is constant.
4 kN/m
0
CI
D
-12 m
TA
-12 m
B
-12 m-
Prob. 10-12

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A circuit is constructed with four resistors, one inductor, one battery and a switch as shown. The values for the resistors are: R1 = R2 = 72 Q, R3 = 61 Q and R4 = 99 Q. The inductance is L = %3D V L 549 mH and the battery voltage is V = 24 V. R3 1) The switch has been open for a long time when at time t = 0, the switch is closed. What is l1(0), the magnitude of the current through the resistor R1 just after the switch is closed? A Submit 2) What is 1(o0), the magnitude of the current that flows through the resistor R1 a very long time after the switch has been closed? A Submit 3) What is VL(0), the magnitude of the voltage across the inductor just after the switch is closed? V Submit 4) What is IL(0), the magnitude of the current through the inductor after the switch has been closed for a very long time? A Submit 5) What is I2(0), the magnitude of the current through the resistor R2 just after the switch is closed? A Submit
Question 8: Draw the circuit that implements each of the following equations: B + AC' (W + Y)' + X' (B + A'D) + (BC)' (W' + XY)' + (VWX' + Z)'
2. calculates the trajectory r(t) and stores the coordinates for time steps At as a nested list trajectory that contains [[xe, ye, ze], [x1, y1, z1], [x2, y2, z2], ...]. Start from time t = 0 and use a time step At = 0.01; the last data point in the trajectory should be the time when the oscillator "hits the ground", i.e., when z(t) ≤ 0; 3. stores the time for hitting the ground (i.e., the first time t when z(t) ≤ 0) in the variable t_contact and the corresponding positions in the variables x_contact, y_contact, and z_contact. Print t_contact = 1.430 X_contact = 0.755 y contact = -0.380 z_contact = (Output floating point numbers with 3 decimals using format (), e.g., "t_contact = {:.3f}" .format(t_contact).) The partial example output above is for ze = 10. 4. calculates the average x- and y-coordinates 1 y = Yi N where the x, y, are the x(t), y(t) in the trajectory and N is the number of data points that you calculated. Store the result as a list in the variable center = [x_avg, y_avg]…