Sketch a straight-line Magnitude Bode Plot for the following system: 5(1+) • H(jw) : 20 jw jw (1+)(1+) 100 500-

Q: Electronic balances must be ideally located in a room with continuous ventilation and natural flow…

A: This problem is from electronic balance.  The statement is true.

Q: . When SW2 is closed, the motor will spin and D1 will light. The current through 1.______ will flow…

A:

Q: What are the conditions to be satisfied when performing parallel operation?

A: ANSWER: Necessary conditions to perform parallel operation of Alternators and Transformers

Q: 4. a) Explain the issues to be considered in the location of wind energy systems. b) Draw the block…

A: Wind turbine locations are very important for successful operations of wind power plants. The…

Q: Draw a simple block diagram of 'Open-Loop Control System' and 'Closed-Loop Control System' Not…

A: CS - control system

Q: Draw a simple block diagram of 'Open-Loop Control System' and 'Closed-Loop Control System' Not…

A: Note -  CS - control system

Q: The figure below shows a loạding truck in a cement factory. The truck has three wheels, front wheel…

A: According to the question, we need to design a control circuit by using a multiplexer that operates…

Q: These transformers normally mounted on power poles or installed inside a large building near…

A: 1) Transformer is an electrical machine which step up step down the voltage without change in…

Q: What is a bus in power systems?

A: The electrical power system is composed of various elements for example generator, transmission…

Q: Short answer. Explain meter loading and why it is important to consider.

A: Meter Loading  Meter loading is generally seen in electrical devices used to measure the voltage and…

Q: What percent of the full-load current will be attained after one time constant?

A: Let's consider the load as R-L load because most of the loads are inductive in nature and initially…

Q: With neat diagram explain the principle and working of motor used in lifts. Prepare 1 page word…

A: Lift uses traction procress. DC series motor were used for traction before, because it has high…

Q: Identify the system which has low stability. a. None of the above b. Open loop and Closed loop…

A: Consider the open loop control system: In this the control system depends only on the input and is…

Q: Write a note on split rings in machines with the help of diagram.

A: The description and relevant diagram of split ring is shown below.

Q: With neat diagram explain the working of motor used in elevators.  Diagram should draw by Hand and…

A:

Q: What is the approximate voltage amplitude and frequency of the waveform below? Trig Vertical Pos…

A:

Q: DA. None of the answers are correct O B. Input convenience OC Remote Control operation O D.Remote…

A: The explanation is as follows

Q: With neat diagram explain the working of motor used in elevators.

A: The motor used for the elevator is a Cumulative compound DC motor, as during the starting high…

Q: Explain the concept of load shedding and provide examples of situations where load shedding might be…

A: Load shedding is a controlled and intentional reduction of electrical power supply to specific areas…

Q: Explain various designs of blades of VAWTs  and HWATs and their relative merits. (explain using…

A: Horizontal Axis Wind Turbine:             Horizontal axis wind turbines, or HAWTs for short, are the…

Q: What is switch Debouncing ? List two or more ways to correct this problem.

A: switch bouncing is the non-ideal behavior of a switch which generates the multiple transitions of…

Q: With neat diagram explain the working of motor used in elevators.

A:

Q: what is nuisance tripping?

A: Nuisance tripping is the repetitive tripping of the RCD in absence of any serious hazard. The…

Q: Fill in the blank: Electrical hazard boots are made up of highly materials.

A: Electrical Hazard boots are used to prevent the shock

Q: 4. How is the commutation process related to the output of the dc generator?

A: Commutation reverses the flow of electricity in the armature winding using a segmented bar and…

Q: On the different maintenance GIVEN BELOW what are the maintenance that need to conduct on the MOTOR…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: Which of the following system works with reference to accuracy? O a. Closed loop System O b. Open…

A:

Q: This is a general question: How do smaller electrical engineering labs relate to building a…

A: Smaller electrical engineering labs can be very helpful in building a relatively larger system. This…

Q: What is voltage padding?

A: In the given questions we need to discuss about the voltage padding and it's importance.

Q: Name any two types of functional earthing that utilise a connection of some type to earth.…

A: Example: Now let's look at a residential structure as an example of protective earthing. A grounding…

Q: What does a compatible load mean? What if the load is not compatible?

A: This question is from "Power system and protection". Under which we are going to study load…

Q: Explain with a neat block diagram the measurement of displacement using RTD (measuring System)

A:

Q: In the next figure.we want to fill the two tanks with water by a pump. The pump is operating…

A: Step 1:A diagram given states:The pump is operated manually by a push-button "Start" (normally open)…

Q: With neat diagram explain the working of motor used in elevators.

A:

Q: What is Bus Bar in electrical engineering?

A: Busbars are mostly used in starting or ending points of the substation. It is a metallic strip or…

Q: Where push-buttons are being used in our daily lives? State some examples.

A: Given: Push button

Q: Question 2: What needs to be done to make an open-loop system to closed-loop? Explain with your own…

A: The system in a control system is described by the transfer function of the system. The control…

Q: DESCRIBE THE PURPOSE OF MULTIPLIERS IN SERIES & SHUNTS ACROSS A METER MOVEMENT.

A: SOLUTION MULTIPLIERS                        Multipliers are used to…

Q: Generators can be connected to the electrical system of the residence in several ways (Select all…

A: Generators can be connected to the electrical system of the residence in several ways

Q: In this class demo, the current: Olighted up an LED. broadcast to a radio. ooo Oturned the motor.…

A: The given figure is shown below. We need to tell in the given demo what is the role of current.

Q: Define and differentiate accidents, unsafe acts and unsafe conditions. essay at least 30 words

A: Electrical Hazards: Hazards are always there with Electricity. it causes damage to equipment on…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.