Situation 2: Determine the diameter of the bolts if the stress in bolt 1 is 200Mpa. Note: Distances are in mm. 60 60 60- 85 120 kN Bolt 1 -120- 43

Q: If in a tensile loading application, the factor of safety for one member is set as FS = 2.2 based on…

A: Given data: FS=2.2σfail=614  MPa Need to determine the allowable stress for member σallow.

Q: Q // If the value of the highest load we get from the tensile test of a wrought iron model with a…

A:

Q: 1-69.M Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be if the…

A: Given:Tensile load, P = 22.3 kN or 22300 NDiameter of circular shank, d = 12 mmHeight of the head, h…

Q: Calculate the range for the stress of the load measures 100 lbs. and the load cell used has an error…

A: Calculated the range of stress of the load .

Q: A 3/8-inch diameter bolt is subjected to a 2,135-lb tensile load. The bolt passes through a very…

A:

Q: A 4ft long rod with a 0.29 inch diameter is subjected to a 10,130lb tensile load. What is the…

A:

Q: Can you calculate the stress for the remaining point instead of point 1 only?

A: Given: To find: State of stress at remaining points

Q: Calculate the allowable force for a 14 gage (.0641" dia) bicycle spoke, if the stress should not…

A: Given information: The gauge of the spoke = 14 gauge  which implies the diameter of the spoke is (d)…

Q: A hollow connecting rod has an inner diameter of 26.25 mm and is subjected to an axial tensile load…

A: A prismatic bar is a straight structural member having constant cross-sectional area throughout its…

Q: A circular rod 2.50in is cut down to a diameter a cutter having a nose radius of 0.25 in compute the…

A: To calculate the maximum stress in the circular rod when it's subjected to a tensile force, we'll…

Q: 12 mm Determine the following: a. Shearing Stress in the head bolt. b. Shearing in the thread c. The…

A:

Q: The lap joint carries an P axial load of P - 50 kN. It is connected by 3-18 mm 150 mm 20 mm 20 mm…

A: As given question  Load =50 kn T=20mm n=3 Dia=18mm We have to find shear stress, bearing stress and…

Q: why do you multiply by 16 in the shear stress?

A: This question is based on the concept of Torsion equation.

Q: A centric load P is applied to the granite block shown. The resulting maximum value of the shearing…

A: A centric load P is applied to the granite block shown. The resulting maximum value of the shearing…

Q: same external tension load. Which pin has the lower shear stress?   O a. The solid pin on the…

A: Given:

Q: 1. You are to design an axially loaded member that is to carry a load of 5,000 lb. The member is to…

A: Given:

Q: For the plate shown in figure 2, the allowable stress is `6 ksi, Determine the maximum allowable…

A:

Q: 2. A flange coupling is to connect two 57 mm shafts. The hubs of the coupling are each 111 mm in…

A: According to our guidelines ,we are supposed to answer 1st three sub parts ,Please repost other…