As shown below, a vertically oriented spring is 0.41m in lengthwhen placed on a table. If when you place a 78N weight on thespring, the spring compresses to new length of 0.16m, thenwhat is the spring constant for this spring?Desmos Calculator0.41m0.16mk =unit%3DMWW

Given Initial length = 0.41 m Final length = 0.16 m

shown below, a vertically oriented spring is 0.41m in length nen placed on a table. If when you place a 78N weight on the pring, the spring compresses to new length of 0.16m, then hat is the spring constant for this spring? Desmos Calculator 0.41m 0.16m MW Mww

shown below, a vertically oriented spring is 0.41m in length nen placed on a table. If when you place a 78N weight on the pring, the spring compresses to new length of 0.16m, then hat is the spring constant for this spring? Desmos Calculator 0.41m 0.16m MW Mww

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter12: Oscillatory Motion

Section: Chapter Questions

Problem 2P: When a 4.25-kg object is placed on top of a vertical spring, the spring compresses a distance of...

See similar textbooks

Similar questions

A bungee cord is essentially a very long rubber band that can stretch up to four times its unstretched length. However, its spring constant vanes over its stretch [see Menz, P.G. “The Physics of Bungee Jumping.” The Physics Teacher (November 1993) 31: 483-487]. Take the length of the cord to be along the direction and define the stretch as the length of the cord minus its un-stretched length that is, (see below). Suppose a particular bungee cord has a spring constant, for of and for. (Recall that the of (Recall that the spring constant is the slope of the force versus its stretch (a) What is the tension in the cord when the stretch is 16.7 m (the maximum desired for a given jump)? (b) How much work must be done against the elastic force of the bungee cord to stretch It 16.7 m? Figure 7.16 (credit modification of work by Graeme Churchard)
As a 75.0-kg man steps onto a bathroom scale, the spring inside the scale compresses by 0.650 mm. Excited to see that he has lost 2.50 kg since his previous weigh-in, the man jumps 0.300 m straight up into the air and lands directly on the scale. (a) What is the springs maximum compression? (b) If the scale reads in kilograms, what reading does it give when the spring is at its maximum compression?
A spring has a length of 0.200 m when a 0.300-kg mass hangs from it, and a length of 0.750 m when a 1.95-kg mass hangs from it. (a) What is the force constant of the spring? (b) What is the unloaded length of the spring?
When an 80.0kg man stands on a pogo stick, the spring is compressed 0.120 m. (a) What is the force constant of the spring? (b) Will the spring be compressed more when he hops down the read?
When a body of mass 0.25 kg is attached to a vertical massless spring, it is extended 5.0 cm from its unstretched length of 4.0 cm. The body and spring are placed on a horizontal frictionless surface and rotated about the held end of the spring at 2.0 rev/s. How far is the spring stretched?
An archer pulls her bowstring back 0.400 m by exerting a force that increases uniformly from zero to 230 N. (a) What is the equivalent spring constant of the bow? (b) How much work does the archer do in pulling the bow? Figure P5.64
A 1.50-kg box rests atop a massless vertical spring with k = 4250 N/m that has been compressed by 15.0 cm from its equilibrium position. The box is released and leaves the spring when it reaches its equilibrium position. What is the maximum height the box reaches above its original position?
A constant 20-N force pushes a small ball in the direction of the force over a distance of 5.0 m. What is the work done by the force?
When a 3.0-kg block is pushed against a massless spring of force constant constant 4.5103N/m , the spring is compressed 8.0 cm. The block is released, and it slides 2.0 m (from the point at which it is released) across a horizontal surface before friction stops it. What is the coefficient of kinetic friction between the block and the surface?
When a 4.25-kg object is placed on top of a vertical spring, the spring compresses a distance of 2.62 cm. What is the force constant of the spring?
Integrated Concepts A toy gun uses a spring with a force constant of 300 N/m to propel a 10.0-g steel ball. If the spring is compressed 7.00 cm and friction is negligible: (a) How much force is needed to compress the spring? (b) To what maximum height can the ball be shot? (c) At what angles above the horizontal may a child aim to hit a target 3.00 m away at the same height as the gun? (d) What is the gun's maximum range on level ground?
A pendulum, comprising a light string of length L and a small sphere, swings in the vertical plane. The string hits a peg located a distance d below the point of suspension (Fig. P7.80). (a) Show that if the sphere is released from a height below that of the peg, it will return to this height after the string strikes the peg. (b) Show that if the pendulum is released from rest at the horizontal position ( = 90) and is to swing in a complete circle centered on the peg, the minimum value of d must be 3L/5. Figure P7.80