Show calculations of the volume, density,and %errorDensity =8.2 DATA SHEET #3Table 3Measurement of the sphere using Micrometer Caliper# of ObsDiameterRatfúsMass1IS SAMM20.542 wm36. 06DATA SHEE21. 55O mm16.040mm.36 25Table 116.039 ma21.528mm36.394.16. 038 mn21.524. mm# of OFAverage15.914 mm.21. 28 6 mmShow calculations of the volume, density and % error in the space below.

Given: The average diameter of the cylinder = 15.914 mm = 15.914×10-3 m The average height of…

Answered: Show calculations of the volume,…

Science

Physics

Show calculations of the volume, density,and %error Density =8.2

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: (a) What is the volume (in km3 ) of Avogadro’s number of sand grains if each grain is a cube and has…

A: Given: The side of the sand grain is l=1 mm. The width of the beach is w=100 m. The depth of the…

Q: This is the samples.... 5.8, 5.2, 5.6, , 4.1, 4.2 and 4.6 Find the mean and variance of the…

Q: The size of a large book is measured. Length is measured as 9.4 cm, the height (thickness) is…

A: 1. Let l, b, h, m, and V denote the given book’s length, breadth, height, mass, and volume,…

Q: Although aluminum foil is very thin, it does have some thickness. We cannot typically “measure” the…

A: The volume of the cuboid = length×width×height Length and width are given but height is not given…

Q: The density law is derived from the basic law D=m/v to reach D=M(wt) x Z / v x Na

A: Density =MassVolume D= m/v

Q: An atom of a particular element has a volume of 6.1 x 10" volume in cubic nanometers ? m What is…

Q: In an experiment four quantities a, b, cand d are measured with percentage error 1%, 2%, 3% and 4%…

Q: Discuss the propagation of errors and state the uncertainty in calculated terms. A cylinder has a…

Q: how to determine experiment density with of a zinc rod with only the mass, length and diameter, when…

A: Given: Mass of zinc rod, m = 69.5 grams length of rod, L = 34.3 cm Diameter of rod, D=19 cm To…

Q: Substitute the experimental value of π you obtained above and the accepted value of π (3.1416) and…

Q: Using a vernier caliper of least count 0.01 cm, the length of a cylinder is measured to be 3.96 cm,…

A: The volume of a cylinder isV =πd2h4 (1) where d is the diameter of the cylinder, h is the length of…

Q: Consider a very long duct as shown below in which all surfaces are black. Determine the net…

A: The given system is, Now due to symmetry we can say, F12=F14=0.5 Now sides 3 and 1 will not…

Q: In an experiment to measure the value of pi, the following results are obtained for pi: 3.14…

A: The computation of percent error helps to determine how near a measured number is to a real value.…

Q: A substance has a hexagonal closed-pack crystal structure, if its density is 6.51 grams per cubic…

Q: what is the density experimental and % error of them

A: Required : Experimental density and percentage error.

Q: two times the volume of a cylinder with the same height and a 8.5−inch

A: Volume is calculated in inches everywhere. Height is same and taken as 1 inch.

Q: A pyramid has a square base of side x and height h. The volume V of the pyramid is given by the…

A: We are given volume of pyramid. We are given uncertainty in height. We are also given uncertainty in…

Q: Draw the planes for the following Miller indices: (a) (1 T O) a = B = y = 900 (b) (T 1 1 ) (c) (1 2…

Q: The mass of an aluminum cube was measured to be (A)=71.2 g. Using the Vernier caliper, the length of…

Q: A (An) ______________ measurement is one in which systematic errors are small.

A: Systematic errors are the errors introduced due to the inaccuracy of the measurement. This error is…

Q: Estimate the number of tennis ball that would fit into a room that is 4m long, 4m wide, and 3m high.…

Q: If ρE = 15 μC/m3 and R1=1/2*R2=1/3*R3= 5.0 cm, plot E as a function of R from R = 0 to R = 20.0 cm.…

A: The diagram to find the electric field within radius R1 can be drawn as below, Here green-dotted…

Q: If n=5, how many values are possible for Ml?

A: For an electron that has n=5, then the possible values of angular momentum quantum number is 0,1,2,3…

Q: A uniform density sheet of metal is cut into the shape of an isosceles triangle, which is oriented…

A: Consider the whole triangle and the small inner triangle with the slice as the base. These are…

Q: Calculate the volume and associated error for the volume of a solid rectangluar block with a length…

A: In this question we have to find the volume of the rectangular block. Please give positive feedback…

Q: An infant’s pulse rate is measured to be ( 132 ± 6 ) beats/min. What is the percent uncertainty in…

A: Given Data: The pulse rate is measured as: 132±6 beats/min

Q: 2.) A single reading taken with a meter stick for the length of a cylinder is 5.5 cm. What is the pn…

A: Meter scale measures the length of object in meters. Percentage error is given by = Measured value-…

Q: The radius of an atom of gold (Au) is about 1.35 Å. How many gold atoms would have to be lined up to…

Q: (a) What is the volume (in km3) of Avogadro’s number of sand grains if each grain is a cube and has…

A: The side of the sand grain, l=1 mm=1×10-3 m The width of the beach, b=100 m The depth of the…

Q: Find the theoritical value of "F" and compare that with an experimental value provided to you…

A: It is a simple force balance lever problem.

Q: Modern instruments usually have digital readouts; the reading in the rightmost digit will sometimes…

A: This type of error is called quantization error or digital noise. Quantization error occurs when an…

Q: Do random errors contribute to % error and/or standard deviation? Why?

A: Random errors are inherent fluctuations in experimental measurements caused by various unpredictable…

Q: Show calculations of the volume, density, and % error . Density = 8.2

A: Given, Average Diameter , D = 1.63 cm Average Height, h = 2.15 cm Average Mass, m = 35.5 g Volume =…

Q: Measured values are usually presented as mean plus or minus uncertainty. If two experimental values…

A: Given Two experimental valuesare (8.1 ± 0.5) and (7.9 ± 0.4) To find out The uncertainty of their…

Q: View T C onstanLS Part B What are the initial and final potential energies (U¡ and Uf ) of the hoop?…

A: Introduction: When a body is displaced vertically a work is done on the body which is stored in the…

Q: You repeat a measurement that contains random error many times, construct a histogram of your…

A: Given: Full Width Half Measurement of the histogram is = 1.9…

Question

Show calculations of the volume, density,and %error Density =8.2

DATA SHEET #3
Table 3
Measurement of the sphere using Micrometer Caliper
# of Obs
Diameter
Ratfús
Mass
1
IS SAMM
20.542 wm
36. 06
DATA SHEE
21. 55O mm
16.040mm.
36 25
Table 1
16.039 ma
21.528mm
36.39
4.
16. 038 mn
21.524. mm
# of OF
Average
15.914 mm.
21. 28 6 mm
Show calculations of the volume, density and % error in the space below.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A person's blood pressure is measured to be: 115 ± 7 mm Hg. What is its percent uncertainty? (Express your answer to the correct number of significant figures and proper units. Use unrounded values in your calculations.)
A parameter x is measured with a relative uncertainty of 4 percent. If x=19.0, what is the absolute uncertainty in the natural logarithm of x? If x=0.082, what is the absolute uncertainty in the natural logarithm of x?
Please help with using step by step formulas.
A series of four measurements of g are made in the physics lab. The results of these measurements in ms2/ are: 9.63, 9.58, 9.71, 9.68. The average of these four measurements is the experimental value of g and the accepted value is 9.80 ms2/. What is the percent error of these measurements?
What is the percent error in the accuracy in the measured volume of the cube? Use the calculated value as the expected value. Round your answer to 2 digits.
Show solution There were two experiments. The initial result was 236 g/ml, followed by 199 g/ml. Find the percent error for the first result if the actual value is 243 g/ml.
If the density (mass divided by volume) of the wall material is the same as that of pure water, what is the mass (in mgmg) of the cell wall, assuming the cell to be spherical and the wall to be a very thin spherical shell?
What, roughly, is the percent uncertainty in the volume of a spherical beach ball of radius r = 0.8460.04 m?
(a) What is the volume (in km3 ) of Avogadro’s number of sand grains if each grain is a cube and has sides that are 1.0 mm long? (b) How many kilometers of beaches in length would this cover if the beach averages 100 m in width and 10.0 m in depth? Neglect air spaces between grains.
Show calculations of the volume , density ,and %error in the space below. Block density =2.7
An infant's pulse rate is measured to be (130+ 5.0) beats/min. What is the percent uncertainty in this measurement? The percent uncertainty is %.