short cylindrical cast iron post supports a compressive load of 20 tons (40 kips). If the factor of safety is taken equal to 10, find the diameter of the post. Ultimate stress for compression is 80,000 psi. Neglect slenderness ratio and no buckling. (2.52in)

Q: TOP The assembly shown has pin support at E and roller support at V. A steel rod is connected at M…

A:

Q: 3.40-3.41 For the space trusses shown in Figures P3-40 and P3-41, determine the nodal dis-…

A:

Q: Stepped bar ABC is fabricated out of aluminum and supported by a fixed support at C as shown. The…

A:

Q: The rectangular bar is connected to the support bracket with a circular pin, as shown in the figure.…

A: Bar width, w= 2.25 in Bar thickness, t= 0.375 in Pin diameter, d= 0.775 in Applied load, P= 4800 lb…

Q: The assembly consists of two rods AC and BD attached to the 100-lb uniform rigid beam AB. There is a…

A:

Q: The part shown is made from AISI 1040 CD steel and is loaded at point C with 300 N in the positive y…

A: Given : material - AISI 1040 CD diameter of bar d = 12 mmYield strength for AISI 1040 CD is 415 MPa

Q: Find the tensile stress in MPa in member AB shown in the figure. All connection bars have square…

A:

Q: 2. An aluminum rod is 1.5 m long. For aluminum, Young's Modulus is E = 70 GPa. An axial force of 3…

A:

Q: A column is made of the two materials side by side as shown. Each material carries a portion of the…

A:

Q: 1. Use the tabulated solutions: Calculate the critical buckling stress for each of the flat plates…

A: E = 29106 psi = 0.30thickness, t = 3/16 inch = 0.1875 in

Q: 2- For the truss structure shown, use symmetry to determine the displacements of the nodes and the…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.