SG = 0.87 Q.1. Oil of SG = 0.87 and a kinematic viscosity v = 2.2×10-4 m²/sec flows throught the vertical pipe shown in Figure at a rate of 4x10-4 m³/sec. Determine the manometer reading, h. Evaluate and compare the results if the Fluid is Water, or have SG = 1.2 and 1.5.[CLO3, PLO2] 20 mm 4 m SG = 1.3

Q: ng based on the degress scal from 0 to 72

A: 4 steps are present in the IC cycle. inlet compression power exhaust

Q: A symbol used to identify a physical feature of a part as a datum feature is called a: O Reference…

A: Reference feature: There are the feature where the other features are referenced from. feature…

Q: able to draw the sequence chart?

A: you are asking about Sequence chart.

Q: Briefly describe the action taken by the following G&M command blocks assuming absolute coordinates.…

A:

Q: where are the graphs?

A: Given data in the related question: Maximum speed = vf = 183.58 mi/hr Distance travelled = 5 mi Time…

Q: (a) tang tan

A: Given data: Opposite side =4 Adjacent side=2

Q: Which of the following settings does not allow you to control point specifications?a. Grid b. Snap…

A: From the given options, the snap, ortho and the polar settings are used to specify a point. Hence…

Q: Two cylinders act right after one another. Each cylinder is metered, and some actions are slow, and…

A: Volume for each action:Cyl. A extends DE = 65 cubic inCyl. A retracts DR = 62 cubic inCyl. B extends…

Q: General Questions Not Directly Print Related) 1.  ____________use conventional symbols with single…

A: Fill in the blanks

Q: Draw an orthographic(three-view drawing) of the four objects including front, top, and right views

A:

Q: 1. What is the name of the circuit? 2. How many reservoir symbols are shown, and how many reservoirs…

A: As per Bartleby Answering Guidelines we are supposed to give answer first three sub parts of the…

Q: The circular pattern feature can be used in creating the following part. True False

A: Circular patterns are used to draw the circular solidworks diagram as shown in the given figure.For…

Q: To convert an arc to a circle: a. Use the FILLET command with a 0 radius b. Use the EXTEND command…

A: JOIN:The JOIN command joins similar objects to form a single unbroken object. The JOIN command…

Q: 6 Using the drawing callout shown in Figure 5 below, which part(s) shown in Figure 4 would now…

A: According to the given dimensional tolerance for the part, the maximum and minimum allowable…

Q: State any three rules of orthographic parallel projection.

A: Orthographic parallel projection is a method of representing 3D objects normally by three 2D…

Mechanical Drawings

A mechanical drawing is described as a technical drawing created by engineers following standard layout conventions, terminology, interpretation, and many other factors. It is also known as an engineering drawing.