Set P = 14 kN, w = 21 kN/m,

Q: Calculate the diameter of vertical pipe needed for flow of liquid at R = 1800 when the pressure…

A: Consider the given data

Q: 3m. E 3m. B •6m. 6 m.

A:

Q: a 100mm height cylinder with specific weight of 5kn/m^3 is submerged ina a a fresh water with…

A:

Q: Water flows into a vertical cylindrical tank at 12 ??³ /???; the surface rises in 6 ??/???. Find the…

A: Given: The flow rate is 12 ft3/min. The flow velocity is 6 in/min.

Q: Q (5-8)/ Water flows uniformly in an earth Trapezoidal cross section open channel. Data available…

A:

Q: A horizontal water jet impinges against a vertical flat plate at 33 ft/s and splashes off the sides…

A:

Q: What effect do end contractions have on the device coefficient and discharge flowing through your…

A: Given- Discharge through rectangular weir End contractions effect on discharge cofficient and…

Q: Verticle load is 258 kN as opposed to 25*8kN - Apologies

A: Yes,    As in the previous answer, it is notes as 25×8 .    Now In this Solution I will provide you…

Q: (50m x 50m) swimming pool. The pool is 2m deep and pumps maintain a slow, steady horizontal flow…

A: Consider the given data  Length of the swimming pool=50 mBreath of the swimming pool=50 mDepth of…

Q: 7. A swimming pool is 20 ft wide and 40 ft long and its bottom is an inclined plane, the shallow end…

A:

Q: Water is moving steadily through the double-exit elbow shown below for which Vị = 5 m. and V, = 10…

A: V1 = 5 msV2 = 10 msd2 = .18md1 = .5md3 = .2m p1 = 25000 pa gage

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.