Select the correct influence line diagram for shear force at x of the following beam: (a) (b) (c) (d) 0.5 6 m 0.5 0.5 0.75 -12 m- 0.5 0.5 X 0.25 0.5 0.5 anco 916 0.2 4 m 0.33 0.5

Q: Draw the influence line diagram for bending moment at A for the frame shown. Then using this ILD…

A:

Q: Influence Line: Moving load group Determine the largest (absolute value) of the shear just left of C…

A: Consider the beam diagram;

Q: |A B C 3 m 2 m

A: There is a beam AC as follows:(a) Find the line of influence of the vertical reaction at point A.(b)…

Q: Assume that the loads are being transmitted to the bottom chord in the truss depicted, and draw the…

A:

Q: Consider pin A, which is used in a single shear connection. Use the ultimate shear strength, the…

A:

Q: D/11 Oil, SG=0.83 3m 2m m Gate

A:

Q: The concrete dam is designed so that its face AB has a gradual slope into the water as shown. The…

A:

Q: 4e. Draw the qualitative (i.e. no values) Influence Line for the vertical reaction at C. A B A B 4f.…

A: Given continuous beam with support and hinges,It is asked to draw the ILD for following,1.…

Q: The moving load is transmitted to the bottom chord of the truss. F G 3 m B C D 3 panels at 4 m = 12…

A: considering joint d

Q: The structure is in Static Equilibrium, calculate forces at A, B and C. 200 N 30 B. A 5 m 5 m ायरूत…

A: To find force at A,B ,C

Q: Situation B. The rigid frame in the figure is subjected to a horizontal load and a vertical load as…

A:

Q: Which of the following is corresponds to the force acting at member CE? E 20 k 12 ft C D 12 ft 5 k B…

A: Let, The angle makes by member CE for line of 20 k load = θSo, tanθ = 1024θ = 22.62oThe angle makes…

Q: 7. Determine the magnitude of the resultant force acting at A. 2 im a- 600 N 3.5 m 0.5 m Fc-450 N…

A: To find resultant force

Q: Problem 6 Using the Muller-Breslau's Principle, draw the influence lines of the following response…

A:

Q: Draw the shear and moment diagram of the structure shown below.

A: Draw the free-body diagram of the beam. Write the equilibrium equation for the sum of the moment…

Q: Influence Lines of Beam: For questions Q1 and Q2, draw the influence lines for the vertical reaction…

A: To draw ILD for reaction at D and moment at C

Q: Solve for the support reactions and draw and label the SFD and BMD

A: The given beam is shown below:

Influence Lines

The graphs that show the variation of a function at a specific point on a beam or truss due to a unit load placed at any point along the structure are known as influence lines in engineering. Some common functions that are studied with influence lines are shear, moment, and deflection. In designing beams and trusses, it is important to use influence lines in structures where loads would move along their span such as bridges, crane rails, conveyor belts, floor girders, etc. The influence lines help to study where a load will create the maximum effect for any of the functions.