-Select the correct answer for the alternatives given. -which of the following does not change in transformer a)-current b)-voltage c)- frequency d)-all of the above 2- The full-load copper loss and iron loss of transformer are 6400w and 5000w respectively. The copper loss and iron loss at half load will be respectively. . a)-(3200 w and 2500 w) b)-(1600 w and 1250 w), c)-(1600 w and 5000w d)- (3200 w and 1250 w) 3-A d.c. shunt motor is running with certain load. The effect of adding an external resistance in field circuit is to a)-reduce the motor speed b) increase the motor speed; c)- stop the motor d)- reduce the armature current of the motor 4- The emf induced in the windings of a transformer will a-lag the core flux by 90°. b)-be in-phase with the core flux c)- lead the core flux by 90° d)-be independent of the core flux 5-In a 4-pole, 25kw,200v wave wound dc shunt generator the current in each parallel path will be a)- (62.5A) " b)- (125A). c)- (250A) d)- (31.5A)

-Select the correct answer for the alternatives given. -which of the following does not change in transformer a)-current b)-voltage c)- frequency d)-all of the above 2- The full-load copper loss and iron loss of transformer are 6400w and 5000w respectively. The copper loss and iron loss at half load will be respectively. . a)-(3200 w and 2500 w) b)-(1600 w and 1250 w), c)-(1600 w and 5000w d)- (3200 w and 1250 w) 3-A d.c. shunt motor is running with certain load. The effect of adding an external resistance in field circuit is to a)-reduce the motor speed b) increase the motor speed; c)- stop the motor d)- reduce the armature current of the motor 4- The emf induced in the windings of a transformer will a-lag the core flux by 90°. b)-be in-phase with the core flux c)- lead the core flux by 90° d)-be independent of the core flux 5-In a 4-pole, 25kw,200v wave wound dc shunt generator the current in each parallel path will be a)- (62.5A) " b)- (125A). c)- (250A) d)- (31.5A)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What did the first digital electrical computer consist of?
To get the best reading on a GPS, the device needs to locate:a. Three GPS satellites b. Seven GPS satellites c. Two GPS satellites d. Four GPS satellites
7) The higher the Q factor , the_ the filter. 7) A) more selective C) lower the center frequency of B) greater the bandwidth of D) less selective I, 10 ohms V1 I2 v(t) 200*/2 sin(ot) 20 ohms :-j11, 552 Note: For the circuit shown above, the Impedance of the capacitor is -j11 Ohm not –j11.55.
Suppose the cache access time is 1 ns, main memory access time is 40 ns, and the cache hit rate is 97%. Assuming memory access is initiated with cache access, what is the effective memory access time? Note: The Lockdown browser is setup to give you access to a standard calculator. Copyright © 2016-2021 by A.Berrached-All Rights Reserved.
In the Internet of Things, which of the following is responsible for translating an electrical signal into a physical output? Solar Panel a. Photo diode b. Actuator c. Sensor Solar Panel a. Light-Emitting Diode b. Actuator c. Sensor a. Photo diode
In the Internet of Things, which of the following is responsible for translating an electrical signal into a physical output? Solar Panel a. Photo diode b. Actuator c. Sensor Solar Panel a. Light-Emitting Diode b. Actuator c. Sensor a. Photo diode
In the Internet of Things, which of the following is responsible for translating an electrical signal into a physical output? Solar Panel a. Photo diode b. Actuator c. Sensor Solar Panel a. Light-Emitting Diode b. Actuator c. Sensor a. Photo diode
Q 3
(True or False) Analog-to-digital (A/D) conversion and digital-to-analog (D/A) conversion are two basic types of data conversion.