Select the appropriate response Question 45 True or False: To verify the fiber closure requirements, a 10 to 20-foot water head test shall be completed. True O False Submit Response Select the appropriate response Question 46 What is the typical source of post amplifier noise in a LASER transmitter? O dark current statistical deviation of arriving photons ODC test points OPIN photodiode O random variations in the LASER output amplitude Submit Response

Q: Compute the output frequency, fout for the sequential circuit given in Fig. Q2(b)(i). Assume a 48…

A: Below I have provided the handwritten solution to the given question

Q: What is the photomask writing time for a gigabit circuit with 1 000 000 000 contact holes, when the…

A: The mask writing time would be 8 seconds.

Q: Find the maximum amount of noise that can be tolerated in this circuit VIL VOL VIH VOH Driver Driver…

A: The answer for the maximum amount of noise that can be tolerated in the given circuit is provided…

Q: (a) Compare between the JK flip-flop and SR flip-flop in terms of operation and application. (b) Use…

A: A circuit that has two stable states is treated as a flip flop. Flip flop are used to design…

Q: What circumstances necessitate recalibration and replacement of the measuring device?

A: The purpose of calibration is to reduce the uncertainty of the recorded estimates, hence providing…

Q: Select any one function such as sine, cosine, triangular, ramp, saw tooth, raising exponential,…

A: y = linspace( x1,x2 ) returns a row vector of 100 evenly spaced points between x1 and x2 Code: x =…

Q: Generally, when an output waveform is found to be incorrect, what is the next step to be taken?

A: GIVEN : when an output waveform is found to be incorrect what is the next step to be taken?…

Q: Consider the following Hoare Triple (all variables are of type integer): {y >0} if x = x A x>0} Give…

A: The given Hoare Triple is valid iff the following Hoare Triples are both valid:. 1) {y > 0, x…

Q: For an active instrument, the power supply must be DC O True O False O O

A: Answer:- False Explanation:- For an active instrument, the power supply must be AC.

Q: nen the loop in the PLL is locked, what is the difference in frequency detected by the phase…

A: PLL is Phase Locked Loop

Q: For the half-wave rectified if Vp-p given as (220) the VDC equal Answer:

A: The average voltage equation for a half wave rectifier is VDC = Vm/π

Q: AIM- To study the gain and phase response of LTI system for different frequencies using Bode plot.…

A: Code clc; clear all; close all; syms s; num = poly([-10 -20]);         den = poly([0 0 0 -100…

Q: tfor this model using D and JK flip flops. Below, provide input equations for the flip flops storing…

A: Here we need to excitation equation since depending upon the present state and next state bits we…

Q: Design a series stub for a Yagi antenna whose input impedance is (40 + j 30) ohms to be matched to a…

A:

Q: The signal can be considered a set of measurements arranged in on a 1-D grie space time width depth

A: I have provided solution in step2.

Q: Digital Electronic

A: Step 1: Step 2: Step 3: Step 4:

Q: The time delay of following program is if crystal frequency is 8 MP LDI R15, 12 LDI R16, 14 LDI R21,…

A: We have to find the time delay. Given: Crystal Frequency= 8 Mhz

Q: 1. Connect the circuit shown bellow and draw the signal for each component using oscilloscope: 10k)…

A: …

Q: Compare the output waveform of Biased diode positive clipper from a Biased diode negative clipper?

A: Compare the output waveform of Biased diode positive clipper from a Biased diode negative clipper?…

Q: Determine the resonant frequency for the Wien bridge oscillator for the resistor 100k2 and capacitor…

A:

Q: The quantization stage of the ADC having an error (power) less than

A: In pipeline ADC, in order to get integral nonlinearity (INL) <1LSB, we need to make sure that the…

Q: Single slope ADC has excellent noise rejection characteristics. Select one: True False

A: Refer to step 2 for the answer.

Q: You are controlling an angle type, servo motor which moves from -90 to +90 degrees. The period of…

A: INTRODUCTION: Given that servo motor moves = -90 to +90 degrees PWM is =20 m.s

Q: What is the maximum wet film thickness (mils) for Sherwin-Williams B67R5? O a. 6.0 O b. 150.0 OC.…

A: Let's see the solution in the next steps

Q: Nyquist plot technique is the frequency response method for the analysis and design of control…

A: Nyquist plot of a frequency response is used in control or signal processing. So it helps in design…

Q: In Active-High Decoder, each output line is produced using Select one: O a. OR O b. NOR O C. AND O…

A: In Active-High Decoder, each output line is produced uing AND gate.

Q: A readout device such as voltmeter has the specifications sensitivity error Resolution 0.01 psi 0.05…

A:

Q: Choose the Correct Answer: Electrical model of a transmission line does not consider as a primary…

A: Explanation: The primary parameters of a transmission line are resistance, inductance, capacitance,…

Q: PAM Demodulator consists of Comparator and Sawtooth O Flip flop and LPF O Reference pulse generator…

A: Introduction: PAM Demodulator consists of Comparator and Sawtooth Flip flop and LPF The reference…

Q: 13. Determine the output waveform in Figure 3–83. A B X C D C

A: 1) We have 4 inputs A, B, C and D connected to a NAND Gate, which ouptuts X 2) Pattern for input A,…

Q: Problem 1: Design the circuit for the following truth table using a Multiplexer. 40 00 00 00 0 A 1 1…

A: Here we have given a Truth table and asked to design a multiplexer circuit for that.Here when we…

Q: 1. For the circuit below, sketch the output waveform Q with the given input and clock signals.…

A: 1.output wave form Q with the given input 2.SR flip-flop to flip-flop

Q: A change in the mode field diameter (MFD) results in a change in: signal velocity coating…

A: Answer: The mode field diameter (MFD) portrays the width of this power profile. The better an…