Section 16.7 Member AB is rotating with oAB=4 rad/s, aAB=5 rad/s? at this instant. Determine the velocity and acceleration of the slider block C at this instant. 2 m 4 rad/s 5 rad/s2 A ALA 0.5 m

Q: how job costing system is implemented?

A:

Q: Explain why efficiency can never be 100% or more on a machine

A:

Q: ent sequential operations. A product needs to go through only one of the three assembly operations…

A: Given data of Kenneth day Manufacturing is  Sawing = 2.1 units/hrSanding = 7 units/hr Drilling = 6…

Q: Solve it all handwriting please

A: the stresses and select a shaft diameter for the industrial mixing machine. However, I cannot…

Q: The Old Hickory Furniture Company manufactures chairs on the basis of the BOM shown below. At the…

A: Given:To find:a. Develop a materials plan for all the parts.b. What actions should be taken now?c.…

Q: A continuous conveyor with 140 m in length uses a belt with a width of 30" to transport a material…

A: To Find:The load capacity.The recommended operating speed.The selection of the roller…

Q: There are 5 steps involved when defining a project, which of the following is the last? Assign the…

A: A project is defined as a sequence of tasks that should be completed to get a certain outcome.…

Q: 3- Consider the precedence relationship between the activities of an assembly line. Knowing that the…

A: Write the expression of the sum of the performance of the cycle. Understand that the cycle time (T)…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.