The rotor of the turbine of a yacht makes 1200 r.p.m clockwise when viewed from the stern. The rotorhas a mass of 750 kg and its radius of gyration is 250 mm. Find the maximum gyroscopic coupletransmitted to the hull (body of the yacht), when the yacht pitches with maximum angular velocity of.1 rad/s.

Answered: s of 750 kg and its radius of gyration…

Engineering

Mechanical Engineering

s of 750 kg and its radius of gyration is 250 mm. Find t to the hull (body of the yacht), when the yacht pitches w

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The 2 m long bar BC weighing L touches the polished surface at a point 1 m away from point A. The…

A: A smooth surface will not exert any friction force on object except the normal reaction. The normal…

Q: if mass (m)=345kg radius of gyration kG = 0.54 m θ= 200 degree Tmin=1523 N assuming no…

Q: The circular concrete culvert rolls with an angular velocity of w = 0.58 rad/s when the man is at…

A: In this problem we will use the moment equation and the relative acceleration approach.

Q: calculate the force under the light roller B of the 17.4-kg slender bar AB.

Q: Your answer is partially correct. The figure shows the cross section of a uniform 174-lb ventilator…

A: W = 174 lb K = 12.7 lb ? = 4.2 ft

Q: The 110-kg wheel has a radius of gyration about its center O of ko = 220 mm, and radius r = 0.4 m.…

Q: The strings AB and AC connect 500-g mass A to the vertical shaft BC. When the shaft rotates with a…

Q: Question #1: Find the total system kinetic energy for the weight and pulley system shown in the…

Q: Arm BC has a mass of 14 kg, and the moment of intertia about its center of mass is 2 kg m². Point B…

A: According to the given information we have an arm BC mass of 14 kg, and the moment of inertia about…

Q: 2 An object is made of two identical uniform 3m long rods connected as shown. The total mass of the…

Q: The rigid body (slab) has a mass m and rotates with an angular velocity es about an axis passing…

A: The expression of the mass moment inertia is written as The expression of the conservation of…

Q: Calculate the tensions of three cables when the mass of the basket is 50 kg. (Assume that B is…

A: Given: Mass of the basket is 50 kg. The system is shown below:

Q: A 2.2 tonne racing car has a wheel base of 2.4 m and a track of 1.4 m from the rear axle. The…

Q: The shown 61 lb spool of radius R = 1.5 ft has a centroidal radius of gyration ko = 0.7 ft is…

Q: The pendulum consists of a 35-lb sphere R-0.6 ft, and a 14-lb slender rod a-13 ft. Just after the…

A: Mrod=14-lb = 0.435133 slugsa=1.3 ft R=0.6 ftMsp=35-lb =1.08783 slugsParallel axis…

Q: Q2/ The rodor of aturbine in stalled in boat with its axis alongthe Longitudinal Viewed from the…

Q: Model the arm ABC as a single rigid body. Its mass is 320 kg, and the moment of inertia about its…

A: The mass of the rigid body is M=320 kg. The moment of inertia about the center of mass of I=390…

Q: A rotating shaft carries four unbalanced masses 20 kg, 16 kg, 18 kg and 14 kg at radii 55 mm, 65 mm,…

A: Draw the configuration diagram of the given system as follows: -

Q: An aeroplane makes a complete half eircle of 50 metres radius, towards left, when flying at 200 km…

Q: An aeroplane makes a complete half circle of 70 metres radius, towards left, when flying at 500 km…

A: Given Radius, R = 70 m Speed, V = 500 km/hr = 138.88 m/s…

Q: Determine the equivalent of the system using the angular motion of the bar L 4 4 4 Slender bar of…

A: Given data: Spring constant = k Need to determine the equation of the given system.

Q: The drum shown in Fig. (a) has a radius of gyration of 30 cm and weights 1,8 kN. It is supported by…

A: Given data: k=30 cmw=1.8 kJW=1 kNr=37.5 cm Need to determine the angular acceleration of the drum.

Q: A shaft has three eccentric of mass 1 kg each. The central plane of the eccentrics is 50 mm apart.…

Q: Determine the force Fe Biv constant velocity Ve= 13m/s for the mechanism The linkage is in the…

A: given; →AB=800mm→mass(m4)=3kg→velocity(VB)=13m/s→moment of inertia(I)=0.03kgm2

Q: B bar, negligible weight movement on the surface indicated by the wheels is doing. The bar is at…

Q: The 24-kg wheel has a radius of gyration about its center O of ko = 260 mm, and radius r= 0.4 m.…

Q: At the instant shown, the uniform slender rod with mass m = 33 kg is pin-supported at point O. It…

Q: a) In extreme cases, the filled bucket of water is dropped from rest (see the figure above). Help…

Q: (3) The 12-lb lever OA with 10-in. radius of gyration about point O is initially at rest in the…

A: Given Data: The weight of the lever is W = 12 lb. The radius of gyration is r = 10 in The spring…

Q: (Meriam and Kraige 6th ed. 6/89) The spool (ro = 0.2 m, ri = 0.075 m) has a mass of 25 kg and radius…

A: Given data The outer radius of spool =0.2 m The inner radius of spool =0.075 m Mass of spool =25 kg…

Q: Problem 05: The circular disk of 200 mm radius has a ma centroidal radius of gyration k-175 mm. The…

A: The kinetic diagram for the system is as follows,Consider no slipping condtion.

Q: 1372. The unbalanced wheel shown in Fig. P-1372 weighe 322 Ib and hasa mas radius of Kyration of…

Q: Block A rests on top of block B and the cord is parallel to the inclined, if u=0.14 for all surfaces…

A: The angle theta in degree when motion of B will impend block A is 7.97o.

Q: The bar AB is uniform and has a mass of 50.0 kg. At the moment shown, the rod has an angular…

A: Given that, Mass of bar AB = 50 kg Angular velocity of rod = 4 rad/sec Spring is stretched by 0.3 m

Q: 1) The shown spool has a mass of 100 kg and radius of gyration of 0.3 m. For P = 70 N and µ, = = 0.2…

A: Given data: Mass of spool, m = 100 kg Radius of gyration, k = 0.3 m Force, P = 70 N Internal radius…

Q: At the instant shown, the uniform slender rod with mass m = 32 kg is pin-supported at point O. It…

Q: 5kg plate, and 3 kg slender rod. FIND, the radius of gyration of the pendulum about an axis…

Q: F3-5. If the mass of cylinder C is 40 kg, determine the mass of cylinder A in order to hold the…

Q: The 3.0 kg pendulum with mass center G is pivoted at A to the ficed support CA. It has a radius of…

Q: F3-5. If the mass of cylinder C is 40 kg. determine the mass of cylinder A in order to hold the…

A: Find the mass of cylinder A.

Q: The strings AB and AC connect 500-g mass A to the vertical shaft BC. When the shaft rotates with a…

Q: The 150-kg wheel shown in Fig. In the initial position shown, the velocity of G is 2 m/s down the…

A: Given data: m=150 kgk=0.36 mv=2 m/ss1=150 mmks=1000 N/mr=0.45 mθ=30° Need to determine the maximum…

Q: The moment of inertia for an extended body is I = r² dm. Prove that for a circular disc of mass M…

Concept explainers

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.

Question

The rotor of the turbine of a yacht makes 1200 r.p.m clockwise when viewed from the stern. The rotor
has a mass of 750 kg and its radius of gyration is 250 mm. Find the maximum gyroscopic couple
transmitted to the hull (body of the yacht), when the yacht pitches with maximum angular velocity of.
1 rad/s.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

At what position (d) you will place the pencil horizontally so that when it is released from rest, it will experience maximum angular acceleration The pencil has a mass (m} kg, and total length of 2. Bm. Consider the pencil as a uniform rod. Assume that the pencil will purely rotate about "O
A wheel is attached by a cable to a block The wheel has a radius of 2ft and weighs 300lbs, the block weights 20lbs. If the radius of gyration about the point of rotation of the disk is 1.5ft, how many revolutions will it take for the wheel to come to a stop assuming it was moving at 10 rad/s CW. Assume the block is on the left side of the wheel and thus causes a CCW moment.
THE WEIGHT OF THE UNBALANCED WHEEL IS 200 KG AND IT HS A RADIUS OF GYRATION ABOUT ITS MASS CENTER, G, OF 0.3 METERS. AT THE INSTANT SHOWN IT IS ROTATING AT 6 RAD/SIN A CLOCKWISE DIRECTION. FIND THE FORCES BETWEEN AT THE PIVOT POINT C. Please include a Free Body Diagram
Write clearly and show the complete solution.
The shown body is composed of a disk with mass 10 kg and a slender bar with mass 5kg which is released from rest form the 4m Im horizontal condition (it is released when 0 = 0). calculate the angular velocity and angular acceleration and the forces at the hinge point (Point O) when 0 = 60 deg. Length of bar is 4m and the radius of disk is Im.
The uniform 50-kg sphere has radius r = 0.2 m and is welded to the center of the uniform 30-kg shaft as shown. When a constant couple moment M is applied to the shaft, its angular velocity reaches 74 rad/s after 4 s. Determine the magnitude of the moment M. Write your answer in N.m but do not write the units. M R= 0.1 m Taylor e m Te am Answer: Answer
The strings AB and AC connect 500-g mass A to the vertical shaft BC. When the shaft rotates with a constant angular velocity of 15 rad/s, the ball has circular motion in the horizontal plane with the strings having angles of a = 55° shown in the figure. Find the tension forces at the strings AB and AC. B 500g 400 mm 400 mm
The homogeneous bars have a mass as follows: bar AC has a mass of 7 kg, bar ABhas a mass of 10 kg, and rod BD has a mass of 2 kg. In the drawn position, therod AC has an angular velocity of 4 rad/s and an angular acceleration of 2 rad/s2, both clockwise.Determine the magnitude of the moment M acting on the member AC. Give all the equations neededto solve this question without calculating it