RLC circuit with AC power supply, find reactance for C

Q: Learning Goal: To calculate and use complex impedance. A 25.0-Q resistor, 50 mH inductor, and 200 µF…

A:

Q: An inductor of inductance 400 mH, a capacitor of capacitance 4.43 μF, and a resistor of resistance…

A: Solution:-Given thatInductance (L)=400 mH=0.4 Hcapacitance (C)=4.43 μF=4.43×10-6 FResistance (R)=500…

Q: The impedance of the parallel RLC circuit shown is given by Vo sin ot -1/2 (A) R? 1 1 B 1 1 wC- R2 ©…

A: According to question we need to find impedance of parallel RLC circuit.

Q: circuit A 50 cycle A.C. Supply is supplied to having an inductance of # fl akd. Calculate impedance…

A: To find-Impedance (Z)=?Given-f=50 c/sL=1πHR=2 k-ohm=2000 ohm

Q: Explain why at high frequencies a capacitor acts as an ac short, whereas an inductor acts as an open…

A: We know that:- The capacitive reactance , Xc=1ωC=12πfC We can say, the value of the capacitive…

Q: A series LR circuit contains an emf source of 19 V having no internal resistance, a resistor, a 29 H…

A:

Q: Give any four characteristics of series RLC circuit at resonance.

A: RLC circuit = It is an electric circuit that consists of Resistance(R), Inductor(L), and…

Q: (a) An alternating voltage is applied to a series R-L-C circuit. Derive the expression for impedance…

A: An LCR circuit is a circuit that contains an inductor (L), a capacitor (C), and a resistor (R). When…

Q: A 50 cycle A.C. Supply is supplied to circuit inductance of 4 fl impedance having an and resistanc…

A: AC circuit problem.

Q: D The Phase Shift for a series BLe circuit sØ=- for the current relative to the 4, -ource voltaae.…

A: For LCR circuit  Tan φ = XL - Xc /R

Q: A 102- resistor, a 0.211-μF capacitor, and a 5.04-mH inductor are connected in series to a generator…

A:

Q: Aparn working near the secondary of a transformera shown in the figure below The primary voltage is…

A:

Q: 3. Find the value of the inductive reactance when A.C. voltage of 220 V at 50 Hz is passed through…

A: Given data: AC voltage (V) = 220 V Frequency (f) = 50 Hz Inductance (L) = 10 H Required: The value…

Q: A series LCR circuit has capacitor of 0:2 F ond induclor of 8mtf. Find ils resonant foequency.

A: To find-Resonating frequency (Fr)=?Given-Capacitor (C)=0.2 μF=0.2×10-6 FInductance (L)=8 mH=8×10-3 H…

Q: A 115-2 resistor, a 52.7-mH inductor, and a 193- uF capacitor are connected in series to an ac…

A: In a series combination of R-L-C, the inductor and the capacitor are the energy storing while…

Q: Find the impedance of this circuit when the angular frequency of the ac source is adjusted to the…

A:

Q: A 30V electromotive force is applied to an LR series circuit with .1 henrys of inductance and 50…

A: The expression for the LR series circuit is,

Q: Fill in the blank with comect answers: Vo AC circuit. The voltage-current phase diagram shown in the…

A: In a given graph, it can only contain two curves of voltages of EMF and inductor. Hence the picture…

Q: A 50 cycle A.C. supply is supplied to a 1 circuit having an inductance of Henry and resistance 2kN.…

A: Impedance is a measurement of electrical resistance.

Q: An A.C. supply of 50 Hz is supplied to a series combination of 25 uF capacity 0.1 Henry inductor and…

A: We have to find (1) Reactance and (2) Impedance Given that, f=50 Hz ;C=25 μF=25×10-6 F ;L=0.1 H;R=24…

Q: A 50 cycle A.C. Supply is supplied to circuit having an induclance of 4 fe and resistance ake.…

A: To find-Impedance (Z)=?Given-f=50 c/sL=1πHR=2 k-ohm=2000 ohm

Q: If the resistance in an RLC circuit remains the same, but thecapacitance and inductance are each…

A:

Q: At an instant of time during the oscillations of an LC circuit.The current is at its maximum value…

A: Introduction: An LC circuit is an electric circuit consisting of an inductor,  and a capacitor…

Q: A 0.35-H inductor is connected across a 12-V AC power source whose frequency can be varied.…

A:

Q: In a series RLC AC circuit, the resistance is 230, the inductance is 27mH, and the capacitance is…

A:

Q: In an RLC series AC circuit, at resonance the capacitive reactance will be the inductive reactance.

A:

Q: 6a. An RC circuit consists of a 43.0 Ω resistor and a 4.50 μF capacitor. Find its impedance at 65.0…

A:

Q: What is the reactance is 10 at 60 Hz? self-inductance of a coil whose

A: Given that-The reactance of the inductor is 10ΩOperating frequency is 60 HzWe know…

Q: I am doing a lab about Analysis of AC circuits and am not sure about this activiy. How do we…

A: In a pure ohmic resistor the voltage waveforms are “in-phase” with the current. In a pure inductance…

Q: At sliat frequency 20 μF capacitor inductor? is the reactance of a equal to that of a 10-mH

A: Solution:-Given thatCapacitive reactance=Inductive reactanceCapacitance (C)=20 μF=20×10-6…

Q: In a series LCR circuit, the inductor of inductance 100 mH, a resistor of 10 ohm and a variable…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.