Riine jXline VL |L1 L2 L1: Absorbs an average power of 5kW at a leading power factor of 0.5. L2 : Absorbs an apparent power of 8 kVA at a lagging power factor of 0.8. Find the power factor of the source VL = 22020°V(rms) Хtine = 0.20 Rine = 0.10

Riine jXline VL |L1 L2 L1: Absorbs an average power of 5kW at a leading power factor of 0.5. L2 : Absorbs an apparent power of 8 kVA at a lagging power factor of 0.8. Find the power factor of the source VL = 22020°V(rms) Хtine = 0.20 Rine = 0.10

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A sinusoidal voltage is applied to a single phase load. The input current wave form is as shown…

A: Phaser diagram is given, From the diagram, vm=1202 V RMS voltage is given by, Vr=Vm2=12022=120 V

Q: For reactive load, the power factor is equal to Select one: O a. 90 O b.0 O c.2 O d. 1

A: Reactive load is either capacive or inductive in nature.

Q: Find power factor of given circuit 30/0° V rms -j22 42

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: Two impedances Za = 4 – j7 W and Zb = 6+ j 9 W are connected in parallel connected to a 60 hz…

A: In the question, Two impedances Za = 4 – j7 W and Zb = 6+ j 9 W are connected in parallel connected…

Q: For the circuit in the figure below, determine the load impedance that maximizes the average power…

Q: The power factor across a load is 0.57 lag. The real power across the load is 375 W. Voltage applied…

A: A system which have power factor across a load is 0.57 lag. The real power across the load is 375 W.…

Q: The load resistance R in Figure is adjusted until it absorbs the maximum average power. Calculate…

A: Step-1->

Q: Find the power factor and apparent power

A: It is given that: vt=160cos377t+100 V V=160∠100 V Z=60+j40 Ω

Q: 13. List the formulas for the Ohm's law used in the analysis of RC circuits. 1. Describe the phase…

A: In this question , some part related to seriss RC circuit and parallel RC circuit is given...We have…

Q: 1. Deternine Vo in the circuit below 2 H 42 ww 32 sin 41 V 4 cos 4t A

A: Given that Electrical network as follows

Q: Compute the reactive power for -j252 with a voltage source, Vg = 24020° (rms) 12.5 N 15 2 V, -j25 N…

A: In this question we will find reactive power in capacitor...

Q: 1. a) Find the rms magnitude and the phase angle of ICA in the circuit shown. 2. b) What percent of…

A: (a) The given load is connected as a delta load. Convert it into a star connected load.

Q: Please answer in typing format

A: Step 1: as seen from circuit first we will finding out the voltage at point A as seen in the…

Q: For the circuit shown below, solve for Z₁ that draws the maximum average power and what is that…

Q: Find the Phasor voltage Vo and the rms voltage for Vo in the circuit shown.

Q: 1. Determine the equivalent impedance across 'a' and 'b'.

A: It is given that:

Q: A Z load draws 12kVA from a 120 V-rms sinusoidal source with a back power factor of 0.85. Find the…

Q: Question No. 9 The average power delivered to an impedance (4-j3) by a current 5 cos(100nt + 100) A…

A: Given- Impedance, Z=4-j3 Ω. Current, I=5 cos100πt+100 A. To find- The average power delivered.

Q: Find the power factor and apparent power unla cun v(t)=160 cos (377 t+10 grados) nos cuando se le…

Q: B) Consider the RLC circuit shown below, write the state equations ONLY R1 L1 m R3 C1 C2 R2 L2 X₁ =…

Q: Ra avelage pauter is 250+2178 KW and the pauer facdor digueis is0 707Lagging The gererálar is…

Q: The source voltage in the circuit is 100cos5000t V (rms). The load impedance (ZL) connected is…

A: Assume a voltage of 1 V at the output terminals. Draw the circuit diagram.

Q: A unit feedback system has the following forward gain function. Calculate magnitude and phase angle…

Q: Find the power factor and apparent power v(t)=160 cos (377 t+10 grados) Onios Cuando se aplica un…

Q: From the following circuit, a. Find the total number of real powers, reactive power, and complex…

A: Evaluating the value of the current flowing in the circuit:

Q: A Z load draws 10kVA from a 120 V-rms sinusoidal source with a back power factor of 0.8. Find the…

A: Given that Although fromula of real power or average power is given by

Q: 62 Find power factor of given circuit ww- 30/0° V rms

Q: Compute for the value of the impedance load that will absorb a maximum average power. 10Ω j15 N ell…

A: To absorb maximum average power first we have to calculate Thevenin's impedance across the load by…

Q: 120 V rms +. Z= 10 +j12 2 60 Hz What is the power factor if we change the nature of the impedance…

A: Option - A. (Answer)

Q: 4. Given Vin (t) 5 cos 5x10 3 t + 1000m 0.1 h 865 Ω

Q: A 5+j1552 15-j5r

A: Given data, Circuit diagram is given as,

Q: For reactive load, the power factor is equal to Select one: O a. 90 O b.0 O c.2 O d. 1

A: Reactive power load Have power factor?

Q: Problem 7: Compute the complex power S in polar form, drawn by a certain load if it is known that a.…

A: Use basic formulas of power triangle

Q: In Figure 1, the power distribution system operates at 50 Hz, 260 V and is occurs. Find the total…

A: The power distribution system 50 Hz, 260 V and consists of three loads. Find the total real and…

Q: The parallel circuit shown has a total average power of 1500 W. Obtain the complex power, active…

Q: A voltage and current applied to a single phase load is v= 27 cos (300t+20°) and i= 17 cos (250t-…

A: Voltage and current signals are given Find the active power and reactive power of the system.

Q: Use node analysis to find Io. Find the complex power supplied by each source and the sum of complex…

A: In the given question we need to calculate the current io. And complex power of each source.

Q: If a Load absorbs an average power of 8 kW at a lagging power factor of 0.8, then the complex Select…

A: Active power P= 8kW Power factor = 0.8 leading Complex power S?

Q: A sinusoidal source supplies 20 KVAR reactive power to load Z = 250 2 75° Q. Determine the apparent…

Q: Correct the power factor seen by the voltage source in the following circuit so that it is better…

A: It is given that:

Concept explainers

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.

Question

Riine jXline
VL |L1
L2
L1: Absorbs an average power of 5kW at a leading power factor of 0.5.
L2 : Absorbs an apparent power of 8 kVA at a lagging power factor of 0.8.
Find the power factor of the source
VL =
22020°V(rms)
Хtine
= 0.20
Rine = 0.10

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

None
A Load absorbs an average power of 8 kW at a lagging power factor of 0.8, The complex power is: Select one: a. 6400 + j4800 VA O b. 8000+ j6000 VA O c. 8000 -j6000 VA O d. none of these Oe. 8000 +j10000 VA
Two circuit having the same numerical dimic impedance are joined in parallel. The power factor of one circuit is 0.8 lag and that of the other is 0.6 lag. Find the p.f. of the whole circuit.
Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the power factor and state whether lagging or leading. Show your solutions. Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the APPARENT POWER in VA. Show your solutions. Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the REACTIVE POWER in VAr. Show your solutions. Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A. Determine the TRUE POWER in watts. Show your solutions.
What is the value of capacitance that needs to be connected in a parallel configuration to the load in order to correct the pf source to 0.94 lagging. Frequency f= 129 Hz
In an L-R-C series circuit the source voltage leading the current with the phase angle of 30°. The resistance of the resistor is 100 Ohm. If the average power delivered by the source is 100 W, what is the rms voltage of the source? 165 V O 115 V 30 V O 200 V 60 V
Problem 2 Determine the magnitude and phase of the current I, in the circuit below -j10 202 2/0° V lo HH j20 110 HH j10 I'm j10 192 152
Please do it fast please
Consider the circuit show in below figure 492 ww 200°V rms -j 20 The average power delivered by the source is (A) 37.85W, pf = 0.93 (Leading) (B) 75.7W, pf = 0.93 (Leading) (C)_75W,pf=0.93 (Lagging) (D) 37.85W, pf = 0.93 (Lagging) 6Ω
Problem: Five linear components of complex impedances Z1, Z2, Z3, Z4 and Z5 are connected as it is shown in the circuit bellow. They are supplied by a sine wave voltage source U. Z1 Z4 Il Z3 13 Z2 Z5 If it is known that: Z1 Z3 Z4 Z5 II 13 Ω Ω Ω Ω A A 30 + j5 30 + j10 30 + j15 0+ j25 0.470 - jo.114 0.002 - j0.007 A) Find the average power that each component dissipates; B) Find the average power absorbed by the circuit; C) Verify the results.
Two 660 V (rms) loads are connected in parallel. The two loads draw a total average power of 76.2 kW at a power factor of 0.8 leading. One of the loads draws 46 kVA at a power factor of 0.96 lagging
Letters D E F need answer