Rigid member BED is supported using steel rods AB, CD, and EF as shown below. E for steel. If a force P is applied at E, determine: a) The stress in each rod b) The length of each rod after applying the force L1 (mm) L1 (mm) P (kN) AAB (mm2) ACD (mm) AEF (mm2) 395 350 20 250 250 450

Q: -5 @ 3m-15m- C F H J K ML boo I A 4@4m=16m B D G E 60 kips A For the truss shown, what is the force…

A:

Q: Rigid bar ABCD is loaded and supported as shown. Bars (1) and (2) are unstressed before the load P…

A:

Q: Assume that all members are pin connected and P = 5 kN. (Figure 1) Figure 3 m3 m3 m3 m- P FEP =…

A: A truss is hinged at E and a roller is supported at A.3  point loads are acting downward of P = 5kN…

Q: Consider the truss shown in (Figure 1). Suppose that F = 10 kN. Figure 3 m 4 KN 5KN kN H B C D E F…

A: Determine the force in members CD, CJ and JK of the truss.

Q: A simply supported beam having a simple span o 8 m must support a uniformly distributed service load…

A: Span (L)= 8 mDead load = 10 KN/m

Q: The assembly consists of two steel bolts AB and EF and an aluminum rod CD. When the temperature is…

A: Free body diagram of rigid cap. Applying equation of equilibrium in vertical direction,Summation of…

Q: 4. Design the reinforced lap joint as shown in Figure 6.2. The plates are 7 in wide of A36 steel and…

A:

Q: 25. Design stress is less than the ultimate strength. Truo

A: (25)Design stress is the maximum allowable stress that a material can withstand under normal…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.