Rigid bar ABC is supported by pin-connected bar (1). Bar (1) is 1.625 in. wide and 1.125 in. thick, and made of aluminum that has an elastic modulus of E= 10,300 ksi. Assume that a = 22 in., b = 36 in., c = 15 in., and d = 27 in. Determine the maximum magnitude of load P that can be applied to the rigid bar without causing member (1) to buckle. Anci A P - a D (1) Th B

Q: 16. When a liquid is at a temperature lower than its saturation point, it is said to be

A: When the liquid is at a temperature lower than the saturation point then it is called Compressed…

Q: 1 "16. You have just moved to a hot, dry climate where it is 37C and 20% rh, and the heat is…

A:

Q: b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32…

A:

Q: Convert each temperature. 22 °C to K (approximate room temperature)

A: Given, temperature = 22oC we know 1oC = 273 K

Q: A power plant turbine releases its discharge into a condenser operating at 20C at 100% saturated…

A: It is given that:condenser temperature is 20°C. Steam enters condenser as 100% saturated vapor.Mass…

Q: The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32 mm…

A: Find  Mean effective pressure, Indicated Power

Q: My desk has a mass of 200 lbm the Earth's surface. What is its weight in pound force (lbf) on the…

A: Given that  Mass = 200 lbm  Acceleration due to gravity = 3.6 ft/ sec2

Q: Stall speed of an aircraft depends on:

A:

Q: Diogrum height, cm The bore diameter of each cylinder in a six-cylinder four-stroke petrol engine is…

A: Given  No of cylinder K=6 4 stroke engine,

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.