RID I FIND THE POLOWING 1. CURRENT IN EICH RESKTORS 2. VOLTAGE In EACH RETACTDRS CefoaSE 4 AMONG G NETWORK R5e TiEDREM : a. KIRCHOFRS LAW 6. TEVENING THEREM C. MAXWEL METH d. NaDE VOLTAGE e. NORFHON THEOREM A. MILLMANTHEREM Veasy

Q: I want ideas for the electronics and renewable energy course project

A: Types of renewable energy resources  Solar Wind Tidal Water Geothermal  Biomass....etc

Q: mostly don't know how to do question (d) and (e)

A:

Q: Determine the following: Ic, VF , VR , R1

A: BJT (bipolar junction transistor) A transistor having a three terminal made up of semiconductor…

Q: I understand the process but looking at my written work where did i make a mistake? How do i fix it?

A: We need to point out the incorrect steps in the given solution in order to find total resistance of…

Q: Coriolis flow meter is a type of -------- flow meter.

A:

Q: I dont get it. howcan I make sure its in low condition?

A: You have asked that how to make sure it is in low condition.

Q: Question 1 (a) Convert between the following number systems (show your working): (i) 578 decimal to…

A: First of all we should convert the given decimal number into binary   This conversion want to divide…

Q: Numerical answer: A 14-bit DAQ device is used to measure a voltage range of +- 8 Volts. What is the…

A: Resolution is the smallest change in the DAQ voltage due to transition of LSB bit.If there are n…

Q: Test I. Number system conversion and arithmetic operation 1. Convert the following to other bases,…

A: To convert a number from base A to base B first convert it to in a decimal value then convert that…

Q: please show steps towards answer and how you calculated it

A:

Q: Count Mounting method 15. From the information you have studied about the various electrical…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: RL Circuit Switch E = 120 V R = 200 Q L = 10.0 H b ell a R L What is the final current? i Δί L At…

A:

Q: Convert the HEX NUMBER 4FA2 . 439 to octal number showing the steps

A: Given 4FA2.439 is a Hexa decimal number

Q: About the electrical circuit using the ladder diagram (PLC Ladder)? +24 e -24 G

A: To draw Plc ladder diagram

Q: Explain the operation of squelch circuit

A:

Q: Define Five of the following Heliostats, Primary energy, capacity factor, commercial energ;…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: Determine how many degrees of lead in each question?

A:

Q: I need a code that can display digits from 0 to 15 on a 2 7-segment display on a basys 3, for now, i…

A: It is asked to write a VERILOG code to display digits from 0 to 15 on 2 7-segment display on a Basys…

Q: Can you write the given values?

A:

Q: Need solution within 15 mins. Give 5 stars for correct solution

A: The solution is provided in the following section:

Q: Question 13 The information signal is always an analog signal. an analog signal in case of an analog…

A: We need to tell about the information signal.

Q: Whats the maximam numper that can be represented by 10 digit decimal number and 10 digit binury…

A: As we know that maximum single digit decimal number is (9)10 which is 1 less than 101. Similarly…

Q: Determine the truth table of the digital circuit shown in the figure below and explain its…

A: A bipolar junction transistor (BJT) is a current-controlled switch. The current between the…

Q: Is there a way to clean up this answer by using proper notation

A:

Q: With the help of schematics, briefly describe, how a telephone set works.

A:

Q: Explain the main difference between an analogue and a digital type of measuring instrument?

A: There is a lot of difference between analogue and digital type of measuring instrument.  The…

Q: in this Lab you will be laying out and installing an emergency service panel. Emergency service…

A: (1)  Legally Required standby systems provide electric power to selected loads during firefighting…

Q: Convert below base20 number into base3 number  (7AD)base 20 Please provide answer as soon as…

A:

Q: Explain any 2 types of Battery?

A: Steel and a combination of zinc/manganese/potassium/graphite make up the majority of an alkaline…

Q: im still confused can you break it down more for me please

A:

Q: R variable (ohm) V1. (ohm) (ohm) (mA) (Volt.)(Volt.) 4,550.9 2.7 2-空 100 100 27-51lok . 95-780. X…

A: Graph Plot basically shows a relation between two parameters that how a system or anything behaves…

Q: The value of 0.050950502 rounded to three significant digits is 0.0510 0.051 0.510 0.0509

A: Given number is  0.050950502  rounded to three significant digits  as per the significance rule, as…

Q: Explain what this matching box is. Describe the parts

A: The given diagrams are shown below. It is asked what is this matching box and also it asked to…

Q: 3 What is a Pump Storage Hydro Power Plant? Explain briefly.

A:

Q: Two real life examples of conduction current

A: There are two types of current in an electrical network, these are:  Conduction current…

Q: Q1/The Gray code ( 10110111101)= ( ) in decimal number 1753 931 869 None of them 1877 1750 1749 867

A: We need to convert the given gray code to Decimal number

Q: Explain why test lights are not recomended for testing computer circuits

A: Test lights are not recommended for testing computer circuits because they are used where circuits…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.