resistors are connected as shown in the figure. The voltage on AB is 30V and the total resistance is 2 ohms. The voltage across resistor 1 is 14.25 V and the current passing resistor 3 is 6 amperes. Determine the total current of the circuit and all other unknowns. COMPLETE SOLUTION PLEASE

Q: R- 5000 - 3000 10000 5002 Figure a

A: Dear,as per company guidelines we can answer only one question at a time, kindly post other…

Q: voltmeter

A: Resistance in parallel- 1Req=1R1+1R2+1R3+........... Resistance in series- Req=R1+R2+R3+...........

Q: A voltage divider consists of a 3000 – ohm, a 5000 – ohm, and 10000 – ohm resistor in series and the…

A: Given  Voltage divider with series current Is=15 mA The resistors 3000 Ω,5000 Ω and 10000 Ω are…

Q: Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a…

A:

Q: he figure the current in resistance 6 is ig = 1.36 A and the resistances are R1 = R2 = R3 = 2.50 N,…

A: The solution can be achieved as follows.

Q: Draw the flow of current for the given circuit and discuss thouroughly how the five voltage drop are…

A: The asked problem is based on the concept of kirchhoff's voltage law ( kvl ) , kirchhoff's current…

Q: Refer to Figure D. Determine the total current of the entire circuit. a. 1.0 A b. 0.5 A c.   0.2…

A: In this question we will find total current....

Q: Three resistors, 1902.50 and 14 0 are connected in parallel in a circuit. What is the equivalent…

A: Given data, Resistances are given R1=19 Ω, R2=5 Ω, R3=14 Ω.

Q: RS R = 5000 R, = 1ko Ry = 4700 9100 1.1O 1.1ka = 3000 R2 1.50 R4 R = 22 ko R = 1ka 10000 R= 5000…

A:

Q: Two lamps incandescent and fluorescent are connected in series. Incandescent is rated 50 W at 100 V…

A:

Q: 12 V 2 kn 3 kn 4 mA 1 kn 3 kn 2 kn 1o

A: The voltage drop across 2k ohms is determined for the above-shown circuit diagram

Q: 24 Ω 4 Ω 5Ω 12 V 12 Ω 3V Ar 3 Ω

A:

Q: R; = 12 R = 6 R, = 8 ŽR; = 4 Rs = 4 Re = 2 20 V R2 = 10

A: Calculate: Req, total current, and current through 2 ohm resistor

Q: In the circuit shown in below figure, a voltmeter reads 60V when it is connected across 650 Q…

A:

Q: In the figure the current in resistance 6 is i6 = 1.33 A and the resistances are R₁ = R₂ = R3 = 1.56…

A: According to the question, for the given circuitWe need to find emf of the battery.

Q: E www R

A: We need to find out voltage across resistor for given circuit .

Q: C. slightly greater than the resistance of the resistor B. D. slightly less than the resistance of…

A:

Q: equivalent current that flow in each Loop in resistor circuits.

A: In a closed loop of a circuit- Summation of all the voltage drops is equals to zero. In a node of a…

Q: Determine the total resistance, the total current and the current at the 2-ohm resistor in the…

A:

Q: VCC = 5V IN=10 uA R1=2k A В R2=3k GND = OV

A: The question, asks to construct a circuit that has 500 mV at node A and 1000 mV at node B.

Q: Three resistors of 5, 10, and 15 ohms respectively are connected in series with a 24V source…

A: In this question we will find current through 5 ohm..

Q: Write down the steps on how to Parallel Resistors Current Division

A:

Q: 5A 3V (3

A: For finding the current I in the circuit we use nodal analysis which states that the sum of all…

Q: What is the voltage across the 50 Ohm and 5 Ohm resistors? Using the loop hole equation, what is the…

A:

Q: All resistors in the figure are measured in ohms. Solve for the equivalent resistance at points A…

A: In this question we will find equivalent resistance between point A and B..

Q: 6. The equivalent total resistance in the circuit in Figure 1 is 2200 E=7V- 4700 1000. 100. 3300…

A:

Q: Find all the missing quantities. Show your work. Determine the total resistance for the circuit.

A: The unknown quantity of the given circuit needs to be calculated and the same can be calculated by…

Q: a 12 volt source with an internal resistance of 1.2 ohm is connected across a wire wire wound…

A:

Q: Explain briefly why is the source (total) voltage almost the same as the voltage across the…

A: This circuit is series RLC circuit and current will be same in each element.

Q: 2. Determine the voltages across each resistance using Kirchhoff s Law. All resistances are in ohms.…

A: In this question,  Find the voltage across the each resistance?  We are solving this problem using…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.