Required information A smooth steel (SG = 7.86) sphere is immersed in a stream of ethanol at 20°C moving at 1.5 m/s. Take D = 0.5 cm. For ethanol at 20°C, take p= 789 kg/m³ and u= 0.0012 kg/m-s. Take n= 22/7.

Required information A smooth steel (SG = 7.86) sphere is immersed in a stream of ethanol at 20°C moving at 1.5 m/s. Take D = 0.5 cm. For ethanol at 20°C, take p= 789 kg/m³ and u= 0.0012 kg/m-s. Take n= 22/7.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Change the number of cells per X and Y, see figure 2.16b, for the laminar boundary layer and plot…

A: First, we need to change the number of cells per X and Y in the computational grid for the laminar…

Q: Describe how Foilsim calculates lift and drag.

A: For students studying about the lift of airfoils and wings, FoilSim II is very good software. The…

Q: Choose a specific airfoil for an airplane and determine the lift and drag forces after that…

A: given; choose a specific airfoil for an airplane? drag force and lift force? required power?

Q: Draw the diagram of the dimensionless velocity profile and 11 for the boundary layer on the surface…

A: To discuss the dimensionless velocity profile in a boundary layer under a pressure gradient, we need…

Q: Consider a flying wing aircraft made using a NACA 2418 airfoil with a wing area of 22 m², wing span…

A: Given: Wing area= 22 m2 Wing span=15 m Span efficiency facto e=0.85 angle of attack α=4o Reynold's…

Q: An aircraft has a total mass of (1.26x10^2) kg and a wing area of (2.3000x10^1) m². It operated with…

A: Chord line is the line joining the leading and tailing edges of the airfoil. Profile line is defined…

Q: d = 1.49 kg/m-s. For steel, take p≈ 7800 kg/m³.

A: To determine the constant fall velocity of the steel sphere in glycerin using the modified…

Q: (c) the sign is rotated by 90 degrees (so that it is 3 m high and 1 m wide) and the wind is parallel…

A: Solution: Given Data: V=15 mph To Find:

Q: Figure 2 shows a 0.25 kg kite with an area of 0.65 m² flies in a 25 km/h wind such that the…

A: Vector is a physical quantity that has magnitude and direction both. Scalar is a physical quantity…

Q: How you find minimum drag and velocity from the equations

A: Given: The drag, D = ax+[b(mg)2/x]

Q: An aircraft has a total mass of (1.14x10^2) kg and a wing area of (2.4000x10^1) m² It operated with…

A: Given Data: Drag coefficient, Cd=0.1 The density of air, 1.2 kg/m3

Q: What is the f (equivalent drag area) for an aircraft that creates 600 lbs of parasite drag at 10,000…

A: Write the density of air at an altitude of 10000 ft. ρ=0.0565 lbs/ft3

Q: A turbojet engine weight 7 kN and has a wing area of 20 m2. The drag coefficient of aircraft is…

A: Turbojet engine weight, FL=7 kN=7*103 N Wing area, A=20 m2 Drag coefficient of air craft,…

Q: Cd=1.4 (coefficient of drag) ¥=10 ft/sec (velocity) Ƴ=62.4 #/ft3 g=32.3 ft/sec2 a. What is the…

A: givencoefficient of drag CD=1.4velocity of water V=10ft/sdensity of water γ=62.4 lb/ft3g=32.3…

Q: Q1: Find the boundary layer thickness (8) equation, the shear stress (to) and the coefficient of…

Q: an angl ng in a w ing attacl is incline

Q: Derive a general expression to find circulation and the lift force for NACA 27014

Q: A surface buoy is located in 180 ft of water and is moored with a wire rope weighing 3 lb/ft. The…

Q: Q1: Find the boundary layer thickness (8) equation, the shear stress (to) and the coefficient of…

Q: Write down the Bernoulli equation and explain how the lift force is generated by an airfoil using…

A: The Bernoulli Equation is given by:P + ρgh + (1⁄2ρV2) = constant along a streamline (1)Where:P =…

Q: celeration and deceleration. (The effects of friction and aerody- travels from the North Pole to a…

Q: The monthly wind speed for Baghdad station 3 m/s at height 10m and S.D is equal o.75, Calculate the…

A: given; specific density(S.D)=0.75at height(h1)=10mwind power density(ρ2)=?at height(h2)=50m

Q: Explain briefly what is meant by drag and its form.

A: Drag is the force that opposes the motion of the aircraft through the air. It is generated by the…

Q: Kindly give me both right solutions with clear calculations The drag polar of a glider is given by…

Q: A light truck weighs 3,300 lb and is rated at 30 miles per gallon for 52 mph highway driving on…

A: Given:Truck weight, W=3300 lbconsumption=30 miles/gallonvelocity, V=52 mph or 76.27 ft/s or 23.25…

Q: An aircraft has a total mass of (1.48x10^2) kg and a wing area of (2.0000x10^1) m². It operated with…

A: For the given situation, we first need to obtain the trust required and the take-off velocity for…

Q: A body travels through 60° standard air at 60 mph, and 5.5 hp is required to maintain this speed. If…

Q: A B-2A is flying at 42,500 ft in standard day conditions at 420 KTAS. The mean chord length is 39.6…

A: Given Data

Q: A flight enthusiast is designing a man-powered single wing aircraft. According to her calculations,…

A: Part (a) Write the given value using suitable variables. Here CL signifies lift coefficient, CD…

Q: Calculate the power of the wind at a site that has wind speed of 12 m/s, air density of 1.2 kg/m3.…

Q: For the vehicle whose specifications are given below, calculate the engine power required in kW to…

A: Givenslope=12%=12100=0.12tanθ=0.12⇒θ=tan-10.12=6.84ovehicle speed (v)=99 km/h=99×518m/s=27.5 m/swind…

Q: A truck experiencing drag is able to reach a maximum velocity of v₁ = 30.5 m/s. It has…

A: Given:Maximum velocity of truck for area A1=1.6 m2, v1=30.5 m/sDrag coefficient for A1=1.6 m2,…

Q: An airplane with a NACA 662-215 airfoil cruises at 170 m/s at an altitude of 4550 m. The airfoil has…

A: Velocity = 170 m/s Altitude = 4550 m Aspect ratio = 9 Span length = 30 m Angle of attack = 2

Q: 2. The table below shows experimental data for the shape and pressure distribution on the upper and…

A: The central difference for the numerical derivatives are dYudx=Yui+1…

Q: The car shown in the figure below moves at a constant speed on a highway and has a drag coefficient…

Q: Aircraft flying at an altitude of (3 Km ) with a velocity of (100 m/sec). The planform area of the…

Q: An air current impinges laterally on an isolated train car of dimensions 3 m high, 12.2 m long and…

Q: A vehicle is moving at 90 km/h at an air temperature of 20 °C (the density of air at this…

A: Speed of vehicle, V=90 km/h=90*10003600m/s=25 m/sAir temperature, Tair=20oCAir density, ρair=1.204…

Q: A person weighing 160 lb is caught in a tsunami flood water 24 inches deep. Calculate the…

A: A person weighing 160 lb

Q: A three-blade propeller of a diameter of 1.5 m has a rotational speed is 60 Hz, the activity factor…

A: Given:The diameter of the propeller, The rotational speed, The activity factor, The static torque…

Q: ceilings

A: Sea level maximum R/C condition Lift coefficient for maximum rate of climb CL=-TW+TW2+12CD,OK2K…

Q: Assuming air resistance with drag ratio =0.50 find the terminal velocity for an object, initially…

Q: A wing has an elliptical load distribution across its wingspan that totals a lift of 2,500.0 N.…

A: To find: The induced drag of the wing in Newton. Given: The total lift is L=2500 N. The wing lift…

Q: A flat plate flying at a speed of 44.7 m/s at standard sea level conditions has a chord of 0.91 m…

A: Given: Speed of the flat plate: →V=44.7 m/s Length of the chord→L=0.91 m Span of the chord→w=1.83 m…

Q: Choose a specific airfoil for an airplane and determine the lift and drag forces after that power…

A: Airfoil for an aeroplane: The wing of an aeroplane has a unique shape known as an airfoil. The…

Q: 3 If the pressure difference in the wind tunnel experiment is 50 mmH,0, the density of air is 1.2…

Question

Estimate its drag in N. Take C_D ≈ 0.4.

Required information
A smooth steel (SG = 7.86) sphere is immersed in a stream of ethanol at 20°C moving at 1.5 m/s. Take D = 0.5 cm. For
ethanol at 20°C, take p= 789 kg/m3 and u= 0.0012 kg/m-s. Take n= 22/7.
Estimate its drag in N. Take CD = 0.4.
The drag is
N.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Solve asap using plot(attach it)
An aircraft with symmetric airfoil of wing area 20 m2, flyingwith velocity 60km/hr experiences lift coefficient of 0.8. Considering the aircraft flying at sea level conditions, determine the mass of the aircraft.
Calculate the lift and drag of the wing (full span) shown below (half span) if it is flying at 25000 ft. with an airspeed of 260 ft/s with a wing span of 30ft. Let Cl = 0.98 and Cd= 0.064. English system not metric.
An aircraft has a wing area of 70 m? and a wing loading of 2500 N/m2. The air density could be taken as 0.45 kg/m3. The drag equation for the aircraft is given as: Cp-0.016+0.055 C2 Calculate its minimum drag speed in m/s. Keep 2 decimals.
Do fast or Skip and allow others to work.
A light truck weighs 3,300 lb and is rated at 30 miles per gallon for 52 mph highway driving on level ground. Under those conditions, the engine must overcome air resistance, rolling resistance, and other sources of friction. Give your answers in the units shown. (a) The coefficient of drag is 0.55 at 52 mph, and the truck's frontal area is 28 ft. What is the drag force on the truck? (Express your answer using three significant figures.) Fo Ib (b) How much power must the engine produce at 52 mph just to overcome air resistance? (Express your answer using three significant figures.) hp (c) In part (b) how much gasoline would be consumed each hour (neglecting other frictional effects)? (Express your answer using three significant figures.) V = gal
A propeller-driven aircraft has an in-flight weight of 4,105 lb (equivalent to a mass of 1,862 kg) and is cruising at a true airspeed of 120 kts. The lift-to-drag ratio of the aircraft is 8.2. If the propeller efficiency, ηp, is 0.8, then how much brake power is required for flight? Work through this problem in both USC and SI units.
An aircraft has a total mass of (1.26x10^2) kg and a wing area of (3.000x10^1) m2. It operated with an aerofoil section having CL = 1.0 and CD=0.1. Assuming that the total drag of the wing represents the whole drag of the aircraft, find the power input required for to overcome gravity and take off. Assume density of air to be 1.2 kg/m3. Answer should be in Watts with three significant figures.
Q1: Find the boundary layer thickness (6) equation, the shear stress (to) and the coefficient of drag (C₁) if the velocity distribution in the laminar boundary layer over the face of a spillway was observed to be: u 7- (C)-()*+C)*. U Then calculate the boundary layer thickness and drag force if the air flows over a sharp edged flat plate 0.25m long and 0.5m wide at a velocity 1 m/s, take the air density 1.23 kg/m³ and the kinematic viscosity is 1.46*10-5 m/s².
An aircraft is required to climb with 10° of climb angle. The aircraft has a mass of 30,000 kg and produces 50,000 N of drag. Assume zero angle of attack and zero thrust setting angle. How much thrust the aircraft engine must produce?
2.4 A 2650-lb car is traveling at sea level at a constant speed. Its engine is running at 4500 rev/min and is producing 175 ft-lb of torque. It has a drivetrain efficiency of 90%, a drive axle slippage of 2%, 15- inch-radius wheels, and an overall gear reduction ratio of 3 to 1. If the car's frontal area is 21.5 ft², what is its drag coefficient?
What does the coefficient of lift represent and why is it dimensionless? From the lift equation, which of the variables does the pilot control and how?