Relative Humidity One measure of the amount of water in the atmosphere is the relativehumidity, the ratio of the actual partial pressure of water vapor to the maximum possiblepartial pressure of water. If the partial pressure of water vapor exceeds the vapor pressure (Figure 1) at that temperature, the vapor condenses to liquid and either fog or dew begins toform. In that case the relative humidity would be 100%.FigureVapor pressure of water (kPa)8O10LiquidVapor-pressure curve20Temperature (°C)Gas30401 of 1Part AReferring to (Figure 1), if the partial pressure of water in the atmosphere is 1.7 kPa when the air temperature is 25°C, what is the relative humidity?Express your answer to two significant figures and include appropriate units.0.54SubmitμAProvide FeedbackUnits?Previous Answers Request Answer

The relative humidity is defined as the ratio of partial pressure of water to the vapour pressure of…

Answered: Relative Humidity One measure of the…

Similar questions

Constants Part A If the humidity in a room of volume 630 m³ at 25 °C is 65 % , what mass of water can still evaporate from an open pan? Express your answer to two significant figures and include the appropriate units. HẢ ? Value Units m = Submit Previous Answers Request Answer
The region between warm (red and orange) to cold (blue) shows the location of the greatest change in SST over distance. The maximum mean velocity of the Gulf Stream is located ______.a.on the blue, cold watersideb.in the region with the greatest color, or temperature, change over distancec.on the warm, red and orange, watersideBased on what you have learned in this investigation, you could assume that the water level is ______ to the left of the direction of motion of the Gulf Stream.a.lowerb.higher
a. Determine the work done ON a fluid that expands from 1 to 4 as indicated in the figure at the right.b. How much work is done ON the fluid if it is compressed from 4 to 1 along the same path? * For part (a), provide a derivation equation in terms of variables for initial andfinal pressure and volume.
In a container of negligible mass, 0.300 kg of ice at an initial temperature of -25.0°C is mixed with a mass m of water that has an initial temperature of 80.0°C. No heat is lost to the surroundings. Part A If the final temperature of the system is 19.0°C, what is the mass m of the water that was initially at 80.0°C? Express your answer with the appropriate units. m = Submit μA Value Request Answer Units ? Review
how to do?
A large cylindrical tank contains 0.750 m³ of nitrogen gas at 22.0°C and 6.50x103 Pa (absolute pressure). The tank has a tight-fitting piston that allows the volume to be changed. Part A What will be the pressure if the volume is decreased to 0.530 m³ and the temperature is increased to 165°C? Express your answer in pascals. —| ΑΣΦ P = Submit Request Answer < Return to Assignment Provide Feedback ? Pa
I am doing some practice problems to prepare for an exam and i cannot solve this problem, specifically part a but I would like to check this problem A piston cylinder device contains 0.8 kg of air initially at 100 kPa, 27 °C. The air is now compressed slowly in a polytropic process during which PV^1.3 =constant, until the volume reaches 1/2 its original volume. The system is then heated at constant pressure until the volume gets back to its original value. NOTE: THIS IS NOT A CYCLE. Data: Rair = 0.287 kJ/kg K; Cv=0.731 kJ/kg K; Cp=1.018 kJ/kgK. a) Determine the amounts AND directions of the Work and Heat(each in kJ) for each of the two processes. show all work used to get your values. b) Sketch the two processes on a P-v diagram, clearly showing all three state points and the two processes with their directions.
part c
Please Asap
Hello please help me answer this physics question attached below
So-called volcanic "ash" is actually finely pulverized rock blown high into the atmosphere. A typical ash particle is a 50-μm-diameter piece of silica with a density of 2400 kg/m³.
Q3. Péclet number - We've seen the Péclet number Pé vl as a useful metric to D determine if stirring (Pé > 1) is more efficient than diffusion (Pé < 1) for mixing solutions. "Stirring" here can designate any process which applies a force on the molecules, resulting in a velocity v. a) Show that the Péclet number, like the Reynolds number, is unitless. Let's think about why scale (f) matters for mixing. 2-DNA, a DNA polymer containing 48,502 base pairs, has a diffusion coefficient of D field of 1 V/m, we can expect 1-DNA to reach a terminal velocity of 30 nm/s. 6.4 × 10-13m²s¬1. Under an electric b) Find the Péclet number for a system of dimension of e = 10 cm. This corresponds to the scale of most benchtop instruments used to manipulate or separate biomolecules. c) Find the Péclet number for a system of dimension of e to the scale over which most cellular processes occur. d) Find the scale l for which diffusion is just as efficient as electric field for displacing = 10 µm. This…