Regarding the distribution substation, it is known that they receive power from the transmission system on the input side and on the output side up to 8 primary feeders can be output. But inside the substation yard a grounding resistor is connected, what is the function of this equipment?

Q: 1. From the results you obtained, discuss the mechanism of comparing two D. C voltages by the…

A: Given the circuit, as shown below: Given the result: a) From the results we need to discuss the…

Q: Question 12 A12 kVA transformer has a voltage ratio of 416 V(Y)/ 13.8 KV(Y). The rated current of…

A: The solution can be achieved as follows.

Q: . You are working in an industrial plant. You must install a single-phase transformer. The…

A: Given that  Primary voltage—13,800 V Secondary voltage—240 V Impedance—5% KVA rating =150 KVA…

Q: In a flat-film strain gage having a rectangular cross section, if the thickness of the film is…

A: In the given question, the considered conductor is flat film strain gauge. The resistance of the…

Q: Which one of the following is used to measure the voltage and power in transmission line? a. Special…

A: Potential transformer is used to measure the voltage in transmission line.

Q: Q.5: a) Correct any five of the following sentences using suitable scientific phrases. tion whan…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 500A 200A Run 250 ft. Cu 250 Kcmil (single conductor feeder) 3ph 480V MCC Troubleshooting a conveyor…

A: The limited approach boundary:Limited approach boundary is defined as a distance from live…

Q: Refer to page 30, the single line diagram shows 1000 kVA. if the transformer capacity rating to be…

A: From the given reference and by changing the ratings according to given values  the single line…

Q: The ratings of a 3-phase circuit breaker are 1500 A. 750 MVA, 66 kV, 3 seconds. Then find (1) Rated…

A: We have an specification of a 3-phase circuit breaker.   And we have been asked to find, Rated…

Q: Discussion: 1. From the results you obtained, discuss the mechanism of comparing two D. C voltages…

A: Given the circuit, as shown below: Given the result: a) From the results we need to discuss the…

Q: 18. A delta connected system has a line voltage of 220 volts and a line current of 100 Amperes. Draw…

A:

Q: How do substations contribute to the reliability of power transmission and distribution?

A: Substations are critical components of power transmission and distribution systems, and they play a…

Q: 3. Two identical 600 kW, 230 V dc generators are operating in parallel and take equal shares of an…

A: The supply voltage, E∘=230 V The full load voltage, VFL=250 V The voltage regulation, Vreg=0.05

Q: Fill-up the missing Process in Principle of Thermal Power Generation. What is the letter of the…

A: Thermal power generation station is a station in which thermal energy is converted into electrical…

Q: Which one of the following preliminary multistator watthour meter adjustments may be made while…

A: To select: Which one of the following preliminary multistator watthour meter adjustments may be made…

Q: What happens if the primemover of an alternator is removed after connecting to the infinity busbar?…

A: What happens if the prime mover of an alternator is removed after connecting to the infinity bus…

Q: The farm equipment loads and the farm dwelling will be supplied by a common service. A feeder is…

A:

Q: In a transmission system, step up transformers are used to increase the voltage for decreasing the…

A: (1)Step up transformer used to increase the transmission voltage. In high voltage transmission…

Q: Why are the outlets in homes never wired in series? What problems might this present?

A: In homes, all the circuits are connected in parallel manner.  The reason behind using the parallel…

Q: The PTs are to be connected delta-wye, to monitor the voltage of a 250 kV line, PTs are to be…

A:

Q: The using of relay is * Break the fault current O Sense the fault Sense the fault and direct to trip…

A: Current transformer is used to step down high current and then the output is feed to relay.

Q: Two resistors, 46.3 and 58.80, are connected in parallel. The current through the 58.8-resistor is…

A: It's a basic circuit with two resistors are in parallel

Q: What is the purpose of a substation in a power distribution network?

A: The purpose of the substation in a power distribution network needs to be briefed.

Q: Question 15 A12 kVA transformer has a voltage ratio of 416 V(Y)/ 13.8 KV(Y). The ratio of the phase…

A:

Q: power transmission based on the given function.

A: Transformer- A device that transfers the electrical energy between two electrical circuits which are…

Q: The feeder is a conductor connecting the sub-station (or localized generating station) to the area…

A: c. True The feeder is a conductor which is for connecting the substation (or a localized generating…

Q: self-synchronizing high

A:

Q: Look at the photo and answer the following questions it Is a 6 pole, non-salient pole design, 3…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Question: A 1-phase full bridge inverter can operate in load commutation mode in case load consists…

A: A single phase bridge inverter can operate in load commutation mode in case load consists of  1.…

Q: The type of connection selected to supply current for heavy loads using solar modules is a. None of…

A: When the solar modules is connected in series the voltage of the system increases. When the solar…

Q: Chose the Substations do not change the Voltage Level Switching Substations O b. Converting…

A: We need to tell about the substations.

Q: What conclusions can you draw concerning the two-wattmeter method of power measurement when…

A: We need to write conclusions that can be drawn concerning the two-wattmeter method of power…

Q: Given the exciting current of a 20 KVA single phase transformer on a 2,200-volt circuit is 5 percent…

A:

Q: What is a substation, and what role does it play in a power distribution system?

A: A substation is a crucial component in a power distribution system. It serves as an intermediary…

Q: Construct the code segment in order to keep the LED array blinking on and off in an infinite loop.…

A: The 8086 micro processor is a 16 bit micro processor. Its address bus is 20 bits and data bus is 16…

Q: These cables or conductors connect the Consumer or Load End with the Distribution Substation.

A: Distributors, feeders, earthing wires and service mains are the part of the distribution system.

Q: When the feeder ring is energized by two or more than two generating stations or substations, the…

A: We need to tell about the given statement is true or false.

Q: each other that supply the critical and the normal feeder circuits. These two panelboards must be…

A: 12a) fact based question because these are standards set by NEC  Correct option is AWG4  AWG stand…

Q: please answer all question which four ) no need to write your explnation

A: In this question we need to choose a correct option.