Refrigerant 134 A enters in a condenser of a heat pump at 180 kPa and -4 0C and exits with a quality of 0.8 and the same pressure of 180 kPa. The mass flow rate of the refrigerant is 65 kg/h, and the heat pump compressor consumes 45 kJ/min of power. Determine the coefficient of performance of the heat pump. Type your answer in the first box.

Q: The heat engine, in which the working gas is air, performs a circular change. First, air at a…

A:

Q: The steam from a boiler enters a steam turbine and work is done by the steam turbine. After work…

A: Answer: The correct answer is option (a) i.e. Open system.

Q: refrigerator refrigerated space at -35°C by rejecting waste heat to cooling water that enters the…

A:

Q: A 3.19 kg/s of oxygen gas enters a compressor with the shown conditions and then enters the heat…

A: To find: The mass flow rate of helium gas. Given: The oxygen mass flow rate is m˙O=3.19 kg/s. The…

Q: An ammonia refrigeration compressor takes its suction from the evaporator at a temperature of -20oF…

A:

Q: The mass flow rate of the refrigerant in a Single Stage Vapor Compression (SSVC) refrigeration…

A:

Q: Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg. the steam…

A:

Q: The vapour compression cycle below (Figure Q4) utilises the refrigerant R134a flowing at 0.05 kg s¹.…

A:

Q: Refrigerant-134a enters the compressor of a residential heat pump at 140 kPa at a rate of 216 kg/h…

A:

Q: The refrigerant circulating in the following system is R404A; the data of the system is as follows:…

A: According to the policies of bartleby, for a question only first three subparts are answered. You…

Q: For the cycle shown, the following enthalpies are known: h1 = 3424 kJ/kg; h2 = 2980 kJ/kg; h3 = 2240…

A: (a) The mass flow rate in the boiler can be determined as shown below.

Q: f 7.59 kg/s. If conde

A:

Q: An ideal Carnot heat pump operates from a low temperature reservoir T₁-272.6 K and supplies 9.94 kW…

A:

Q: An electric water cooler for drinking water should cool 10 gal/h of wate from 65 degrees Fahrenheit…

A:

Q: In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine…

A:

Q: Air goes through a Brayton cycle gas turbine, entering the compressor at 11 °C and 108 kPa. When it…

A:

Q: A geothermal powerplant consists of a flash chamber (basically a yalve) which decreases the pressure…

A: according to the given data

Q: Refrigerant 134 A enters in a condenser of a heat pump at 200 kPa and -4 0C and exits with a quality…

A: Answer: The coefficient of performance of the heat pump: (COP)H.P. = 4.0118

Q: Water inter a condenser at a mass flow rate of (2.5 kg/s) and (21 kPa and 65 C), and exit with (h=…

A:

Q: A heat exchanger is used to cool the water that enters at 100 kPa, 400 at rate of 5 kg/s. The water…

A: Solution: a) Since water exits as saturated vapour from the heat exchanger saturation temperature at…

Q: KOLP 55 750 LP Condumer Compressor valve Evaparate Refrigerant-134a enters the condenser of a…

A:

Q: Refrigerant (known as R-134a) enters a heat exchanger at 100 kPa. The refrigerant is of 20% quality…

A: Given data: The pressure of refrigerant in the heat exchanger is P = 100 kPa. The dryness fraction…

Q: pressor -200C, leaving the compressor 500C; entering th

A: Given-Information:- 4-cylinder Diameter, D = 35 cm = 0.35 mLength, L = 40 cm = 0.4 mSpeed of…

Q: The mass flow rate of the refrigerant in a Single Stage Vapor Compression (SSVC) refrigeration…

A:

Q: A pump at a power plant supplies water to the boiler at a flow rate of 1,000 gal/min, measured at…

A: Given:Discharge,Q=1000galminEfficiency,η=70%=0.7Pressure difference,∆P=(2985-185)psi=2800psi

Q: Consider a condensing heat exchanger operating with two separate fluids, R-134a and the water.…

A:

Q: Refrigerant vapor rejects 70 kW of heat as it passes through an air-cooled condenser. The condenser…

A:

Q: Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg. the steam…

A:

Q: Determine the efficiency of the reversible Heat Engine cycle shown: 4 800K 600K 300K 1 S (kJ/kg-K)…

A: This is the very basic question of thermodynamics. Used concept is area under the T-s curve  On…

Q: In a closed feedwater heater, steam warms the feedwater and the condensate leaves the heater through…

A: Answer: It allows the liquid to flow into a lower pressure without loss of enthalpy.

Q: The maximum efficiency of a heat engine works between 660 K and 323 K is

A:

Q: Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.22 MPa and 27 C…

A: First of all, calculate the enthalpy and entropy at the inlet of the compressor at the given…

Q: 3. Steam enters the turbine at the rate of 1.5 kg/s with enthalpy of 2300 kJ/kg and exhaust enthalpy…

A: The turbine work is 614.075 HP.

Q: Air at 17 °C is compressed steadily in an adiabatic compressor from 100 kPa to 680 kPa. If the…

A: Given: The initial temperature is T1=17°C=(17°C+273) K=290 K, The initial pressure is P1=100 kPa,…

Q: Your company produces small power units that generate electrical energy by expanding the residual…

A:

Q: An air-conditioning absorption system has an evaporator capacity of 350 kW with a COP of 0.90…

A: Given Heat C.O.P OF THE GENERATOR=temperature of starting=Condensing temperature =Rejection of heat…

Q: In the Figure below, one of the engines A or B is reversible. Determine if the heat pump is…

A:

Q: A condenser of a refrigeration system rejects heat at a rate of 120 kW, while its compressor…

A: