Referring to Fig. compute the maximum force P that can be applied by the machine operator, If the shearing stress in the pin at B and the axial stress in the control rod at C are limited to 4000 psi and 5000 psi, respectively. The diameters are 0.25 inch for the pin, and 0.5 inch for the control rod. Assume single shear for the pin at B. Figure P-121 2 in 10 MATHno.oo 6 in 2 in

Q: 1.10 Link BD consists of a single bar 1 in. wide and in. thick. Knowing that each pin has a -in.…

A:

Q: A thin rectangular plate is uniformly, deformed, as shown. Determine the shear strain Yxy at P.…

A: Solution: The shear strain of the thin rectangular sheet in the y-direction can be obtained using…

Q: Based on the sign convention we are using, if we cut a beam and draw the left portion of the beam,…

A: Cutting a beam and draw the left portion

Q: The homogeneous wire ABCD is bent as shown and is attach to a hinge at C. Determine the length L…

A: this question is about to measure center of gravity of wire for equilibrium.

Q: A 8-mm-thick rectangular alloy bar is subjected to a tensile load P by pins at A and B, as shown in…

A:

Q: 10 lb 7 lb w=3lb/ft What is the value of the shear at point a? What is the value of the shear at…

A:

Q: Two solid cylindrical rods support a load of P = 37 kN as shown in Figure below. R has a diameter of…

A: We know that   we first draw a free body diagram of the system given as  Now We calculate the angle…

Q: What torque

A: Given dataL=2.76m=2760mmInner diameter, c=3.313×10−2m=33.13mmSimilarly outer diameter b=76.63mmAngle…

Q: 1-66. Determine the largest load P that can be applied to the frame without causing either the…

A:

Q: A 7-kip · ft torque is applied to a hollow aluminum shaft having the cross section shown. Neglecting…

A: Given data- T=7 kip-ft Radius of outer circle, r0=7 in Radius of inner circle, ri=14 in-4 in-2 in2=4…

Q: H horizontal force of P = 1,400 lb is applied to the rectangular bar shown in Figure above. d = 1.80…

A:

Q: An axial load Pis applied to the rectangular bar shown. The cross-sectional area of the bar is 216…

A: Answer: Normal stress,  σ =2.73×108 N/m2 Shear stress,  τ =1.51×108 N/m2

Q: A fishing rope of length (74+ 50) m has the diameter (74 + 5) mm. When a weight of (74 +200) N is…

A: i. The cross-sectional area of the rope is given by,

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).