Refer to the photo provided and please make sure your handwriting is readable a = 1.01 m b = 2.02 m c. 1.505 m d. 4.505 m P1 = 6.06 kN P2 = 24.04 kN 1. Compute the resultant reaction at I in kN. 2. Compute force member DE in kN 3. Compute normal stress in member CE in kN/m2 if the value of the area is A mm2.

Q: 2. A finite element analysis of a bearing housing indicates that at a point p, the material is…

A: Principle stresses are the those stresses that are to the normal with zero plane. The value of…

Q: Q/Normal and shear stresses acting at the point is shown in Figure 1- Determine the principal…

A:

Q: The rigid beam in (Figure 1) is supported by the three suspender bars. Bars AB and EF are made of…

A: Reference : Structural analysis, Stresses in bars. Given : Allowable stresses and area of bar. To…

Q: Determine the axial stress acting on a circular column. *

A: Axial Stress- Axial stresses are those which are responsible for bringing a change to the length of…

Q: 5- The solid rod is subjected to the loading suown. Determine the state of stress at point A, and…

A: Given : Determine the state of stress at point A and show the results on a differential volume…

Q: 1.3 Two solid cylindrical rods AB and BC are welded together at B and loaded as shown. Determine the…

A: Determine the magnitude of the force P for which the tensile stress in rod AB has the same magnitude…

Q: Problem 5.9 A solid steel bar has a cross section of side b and is supported as shown. Knowing that…

A: To Determine Depth of the beam, b

Q: a. The beam weighs 3600N. Draw the V and M diagram. b. Assume we do not know the weight of the beam…

A: 1-If Beam weighs 3600 N then drawing of SFD and BMD2- if Beam Weighs is not know then finding of…

Q: W A L A Test beam Strain gauge (a) Unsymmetrical cantilever beam with weight applied at the free end…

A: The objective of the question is to calculate the location of the centroid, the second moments and…

Q: Required information Consider the given state of stress. 416 ksi 10 ksi ormino the normal and…

A: The given data is: σx=0 ksiσy=16 ksiζxy=10 ksiθ=15°2θ=30°

Q: For the element with stresses as shown below, find: . The magnitudes and directions of major and…

A: To determine-

Q: Determine by the RITTER method the forces and the types of stress in the  bars in the bars AE, DE…

A: The Ritter method, also known as the Method of Sections, is a powerful tool in statics used to…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.