Refer to the figure below. Ao,, at point A with the following values: q1 = 120 kN/m; q2 =350 kN/m; x1 = 3.5 m; x2 = 1.5 m; z = 2 m. Line load = 91 Line load = 92 %3D X1 Ao, A

Q: According to the general shear stress formua, shear stress distribution on a rectangular crosss…

A: This question is related to the Solid Mechanics from Civil Engineering. Given Data -   Crosss…

Q: A) Show the following on Mohr's stress circle: 1-The value of direct stress in the plane of the…

A: Plotted values and labelled value that is asked in question  A is shown in next step Further plane…

Q: For the state of stress shown, determine the range of values of for which the magnitude of the…

A: Given,  X=100 MPa  Y=45 MPaτx'y'≤40 MPaTo determine,permissible ranges of θ

Q: Figure 1 shows a cantilever beam subjected to two point loads (Figure 1a) and the cross section a-a…

A: Given that:                         NOTE: As per our answering guidelines, we can only answer 1…

Q: Which of the following statements are correct (select all that apply) ? Group of answer choices…

A: The objective of the question is to identify the correct statements among the given options related…

Q: Find the stress resultants N, V and M, draw the diagrams of the stress resultants (N,V,M)

A: Stress ResultantsN= -7 kN (Compression)V= 18 kNMmax= 54 kN-m  As seen on the diagram at explanation…

Q: Problem 2. The 200 mm diameter rod is subjected to 300 N and 500 N loads as shown in Figure 2.…

A: in the given beam both torque and bending moment both are acting so that  torque - transverse load…

Q: A concentrated load of 290 kips is applied to the ground surface. Required What is the vertical…

A: Solution is attached below as

Q: Calculate the weight of a Wire Mesh Reinforcement needed for a 10'x10' slab. The specifications are…

A: Requirement of wire mesh reinforcement in slab Mesh reinforcement is required in a composite slab…

Q: Determine the normal stress in a ball, which has an outside diameter of 160 mm and a wall thickness…

A: Pressure (P)=84kPa = 0.084MPa Thickness (t)=3.6mm Outside diameter (D)=160mm Inside diameter (d)=…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.