ree gases are stored at 25°C in separate but connected containers. The first container is 10.0 L and contains 1.008 g of hydrogen gas, the second is 5.0 L and contains 70.9 orine gas, and the final is 20.0 L and contains 132.027 g of carbon dioxide. After sitting in storage for 30 years (NOT the age of Dr. Skinner), the containers are placed on a unter and the gases are allowed to mix. What is the pressure of each gas before mixing? What is the total pressure after the gases mix? What is the pressure of each gas after mixing?

ree gases are stored at 25°C in separate but connected containers. The first container is 10.0 L and contains 1.008 g of hydrogen gas, the second is 5.0 L and contains 70.9 orine gas, and the final is 20.0 L and contains 132.027 g of carbon dioxide. After sitting in storage for 30 years (NOT the age of Dr. Skinner), the containers are placed on a unter and the gases are allowed to mix. What is the pressure of each gas before mixing? What is the total pressure after the gases mix? What is the pressure of each gas after mixing?

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter6: The Gaseous State

Section: Chapter Questions

Problem 6.73QE

See similar textbooks

Similar questions

105 The decomposition of mercury(II) thiocyanate produces an odd brown snake-like mass that is so unusual the process was once used in fireworks displays. There are actually several reactions that take place when the solid Hg(SCN)2 is ignited: 2Hg(SCN)2(s)2HgS(s)+CS2(s)+C3N4(s)CS2(s)+3O2(g)CO2(g)+2SO2(g)2C3N4(s)3(CN)2(g)+N2(g)HgS(s)+O2(g)Hg(l)+SO2(g) A 42.4-g sample of Hg(SCN)2 is placed into a 2.4-L vessel at 21°C. The vessel also contains air at a pressure of 758 torr. The container is sealed and the mixture is ignited, causing the reaction sequence above to occur. Once the reaction is complete, the container is cooled back to the original temperature of 21°C. (a) Without doing numerical calculations, predict whether the final pressure in the vessel will be greater than, less than, or equal to the initial pressure. Explain your answer. (b) Calculate the final pressure and compare your result with your prediction. (Assume that the mole fraction of O2 in air is 0.21.)
Explain why the plot of PV for CO2 differs from that of an ideal gas.
What does “STP’ stand for? What conditions correspond to STP? What is the volume occupied by one mole of an ideal gas at STP
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
You have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.
Methanol (CH3OH) can be produced by the following reaction: CO(g)+2H2(g)CH3OH(g) Hydrogen at STP flows into a reactor at a rate of 16.0 L/min. Carbon monoxide at STP flows into the reactor at a rate of 25.0 L/min. If 5.30 g methanol is produced per minute, what is the percent yield of the reaction?
A four-liter tank is filled with propane gas, C3H8. The mass of the tank filled with gas is 1236 g. The pressure in the tank is 2.68 atm. The temperature in the room is 37C. The propane in the tank is used up under the same conditions of temperature and pressure. What is the mass of the empty tank?
Butane, C4H10, is an easily liquefied gaseous fuel. Calculate the density of butane gas at 0.857 atm and 22C. Give the answer in grams per liter
How does hydraulic fracturing differ from previously used techniques for the recovery of natural gas from the earth?
A balloon filled with helium gas is found to take 6 hours to deflate to 50% of its original volume. How long will it take for an identical balloon filled with the same volume of hydrogen gas (instead of helium) to decrease its volume by 50%?