Answered: Record the acceleration Determine the… | bartleby

Related questions

Question

How do I determine friction force from data recorded?

Tension- alter the magnitude of the tension force
Mass- alter the mass
Theta- alter the angle of the tension force
• Coef. of Static Friction- alter the amount of frictional force when the block
• Coef. of Kinetic Friction- alter the amount of frictional force when the blo
2. Apply the following settings: Mass (kg) =2.5, Theta 0, Coefficient of Static
and Coefficient of Kinetic Friction = 0.4
3. Conduct the trials in the table below and for each:
a.
Record the acceleration
b.
Determine the unknown frictional force
Tension (N) Acceleration (m/s)
Friction (N)
15 2.08
30 8.08
60 20.08

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Problem: An ice skater moving at 9 m/s coasts to Problem: An ice skater moving at 9.0 m/s coasts a halt in 95 meters on an ice surface. What is the to a halt in 95 meters on an ice surface. What is coefficient of kinetic friction between ice and the coefficient of kinetic friction between ice and skates? Use a value for g of 9.80 m/s?. skates? Use a value for g of 9.80 m/s?. а. 0.04 b. 0.043 а. 0.04 b. 0.043 С. 0.0435 С. 0.0435 d. 0.04350 d. 0.04350
A 1,380-N crate is being pushed across a level floor at a constant speed by a force F of 320 N at an angle of 20.0° below the horizontal, as shown in the figure a below. a) What is the coefficient of kinetic friction between the crate and the floor? (Enter your answer to at least three decimal places.)(b) If the 320-N force is instead pulling the block at an angle of 20.0° above the horizontal, as shown in the figure b, what will be the acceleration of the crate? Assume that the coefficient of friction is the same as that found in part (a).m/s2
Consider a pulley system of the type shown in the figure above. Suppose that the upper pulley has no mass and the lower two pulleys have a total mass of 9.1 kg; the block attached to the lower pulleys represents a car engine of mass 115kg . a) What is the tension T in the rope? Assume that all sloped segments of the rope are vertical. b) What force does the ceiling exert on the upper pulley, assuming you pull straight up on the rope?