Reciprocal levelling was conducted across a wide river to determine the difference in level of point A and B, A situated on one bank of the river and B situated on the other. The following results on the staff held vertically at A and B from Level stations 1 and 2, respectively, were obtained. The level station 1 was near to A and station 2 was near to B. Instrument Staff reading on at A A 1.485 B 1.190 B 1.725 1.415

Reciprocal levelling was conducted across a wide river to determine the difference in level of point A and B, A situated on one bank of the river and B situated on the other. The following results on the staff held vertically at A and B from Level stations 1 and 2, respectively, were obtained. The level station 1 was near to A and station 2 was near to B. Instrument Staff reading on at A A 1.485 B 1.190 B 1.725 1.415

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

From a transit line to the edge of a river a series of perpendicular offsets are taken. These offsets are spaced 4.0 m apart and were measured in the following order: 0.5 m, 1.4 m, 2.5 m, 5.6 m, 8.5 m, 7.4 m, 3.8 m, 5.1 m, and 2.3 m. Determine the area included between the transit line, the river’s edge and the line offsets using (1) Trapezoidal Rule, (2) Simpson’s One-Third Rule.
step by step solution
provide complete solution and solve for the encircled question
What is the area of below cross-section if you know the formation level is 27.71m and ground elevation equal 25.89? 15 m 1 3 Answer:
Situation No. 10 Solve and Give the complete solutions.
1. For the given force system shown in figure 1, if force P=150kn & force F=300kn, determine the magnitude and direction of the horizontal component of force P. 2. In problem 1, determine the magnitude and direction of the vertical component of force 600kn. 3. In problem 1, determine the magnitude and direction of the horizontal component of the resultant force. 4. In problem 1, determine the magnitude and direction of the vertical component of the resultant force. 5. In problem 1, determine the magnitude of the resultant force. 6. In problem 1, determine the angle of inclination of the resultant force with respect to the positive x-axis.
Correct solution
The areas bounded by the water line of a reservoir is determined by using a planimeter.The contour interval is 2m.A1 = 20,400sq.m.;A2 = 18,600sq.m ; A3 = 14,300 sq.m ;A4 = 10,200 sq.m. ; A5 = 8,000 sq.m ;and A6 = 4000 sq.m..Determine thecapacity of the resevoir.
A portion of a river is modeled with two reaches, A and B. Reach A extends from section1 to section 2 and has a length of 15000 ft, n = 0.07, S = 1 %, and Rh = 4 ft. Reach 2 extends from section 2 to section 3 and has a length of 17000 ft, n = 0.05, S = 0.5% and Rh = 5 ft. The hydrograph at Section 1 is (200, 300, 700, 600, 500, 400, 350, 300, 250, 225, 210, 205, 200), with a time increment, t of 10 min. Assume the initial discharge at downstream sections is 200. Using the Convex Routing Method, (a) route the hydrograph from section 1 to section 2 and then from section 2 to section 3.
Given: As = 3m2 C = 0.92 Ao = 0.01m2 Find: Determine the time for the depth of liquid in the tank to be 0.8m
A SHEROID YAS A FIRST ECCENTRICITY OF 0.81427. COMPUTE THE VALUE OF ITS FLATTENING.
What is the Froude number of the channel shown if the water flows at a velocity of 2 m/s? a. 0.376 b. 0.475 c. 0.828 d. 1.808