re are a number of transmission motion potentiometers with resistors ranging from 100 oh k ohms in increments of 100 ohms. According to the design requirements, the output volta potentiometer with a step length of 0.1 m is measured by a voltmeter with a resistance of s. Maximum measurement error occurs when the slider is in two-thirds of the entire path, uld not exceed 1% of the read value. Choose the most suitable potentiometer.

re are a number of transmission motion potentiometers with resistors ranging from 100 oh k ohms in increments of 100 ohms. According to the design requirements, the output volta potentiometer with a step length of 0.1 m is measured by a voltmeter with a resistance of s. Maximum measurement error occurs when the slider is in two-thirds of the entire path, uld not exceed 1% of the read value. Choose the most suitable potentiometer.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

An uncharged capacitor and a resistor are connected in series to a source of emf. If = 8.00 V, C = 25.0 µF, and R = 100 Ω, find the following. (a) the time constant of the circuit Your response is off by a multiple of ten. ms(b) the maximum charge on the capacitor µC(c) the charge on the capacitor at a time equal to one time constant after the battery is connected µC
Please answer #3
Do first 2 subparts
https://Imssb1.mutah.edu.jo, Given that the delivered power to a resistor is equal to P when the current flowing in the resistor is lo. If the current increased to 6.4 lo the delivered power to the resistor will be:
(a) In the figure what value must R have if the current in the circuit is to be 1.1 mA? Take ε1 = 3.0 V, ε2 = 4.2 V, and r1 = r2 = 2.7 Ω. (b) What is the rate at which thermal energy appears in R?
In the Wheatstone bridge experiment shown in 2,2 kn the figure the values of the resistors are R=2.2 k2, R2=4.7 k2, R3=3.3 k2 .Calculate the value of resistor R, when the current in the HA ampere-meter is zero. R2
In an RC series circuit EMF = 120.0 V, R = 1.40 MOhm, and C = 1.80 muF. (a) Calculate the time constant. (b) Find the maximum charge that will appear on the capacitor during charging. (c) How long does it take for the charge to build up to 20 muC? (d) What is the maximum current through the resistor? (e) What is the potential difference across the capacitor after it has been charging for 1.0 sec? (f) Sketch the charge and current as functions of time. (g) After being totally charged, the capacitor is carefully disconnected from the circuit above without discharging it. It is connected to a 520 kOhm resistor and begins to discharge. What is the time constant for this circuit? (h) What will be the potential difference across the capacitor after 400 msec? (i) Sketch the charge and current as functions of time.
The largest operating wind La generator in the world has a rotor diameter of almost 100m. This nits generator can deliver 3 3.1 MW of power. Suppose you connect adl 3.0 K resistor, a 4.0K resistor, and a 5.ok resistor in parallel- klhat potential difference must be applied across these resistors) in order to dissipate power w 1.00 percent of the Jock equal to power provided by the generator? Show all working step-by-step gat2 word stz
In this experiment, you have a 28.4N resistor. If the lab manual specifies that the maximum safe electric current through the resistor is 473MA, what is the maximum voltage (in unit of volt) you can apply to the resistor?
Two cells having unknown emfs E and E (E> EJ are connected in potentiometer circuit so as to assist each other. The nui point is obtained aft 8125 m trom, the higher potential end. When cell Eis'Connected so ÉS fo oppose cell E, the null point is obtained at 1.25 m from same end. Compare the em.fs. of two cells. .
Two cities are 150 km apart. Electric power is sent from one city to another city through copper wires. The fall of potentiai per km is 8 volt and the average resistance per km is 0.5 . The power loss in the wire is :
In (a) "The absolute tolerance is ±0.001" In (b) "The absolute tolerance is ±10"Box your answer