ransfer in the form of H(s) = Vout(s) / Vin(s) of the circuit given above Determine the zero and poles by obtaining the function of the energy storage elements. accept initial values b-) By using the transfer function you obtained in the previous option, Plot the approximate total amplitude response graph with the help of BODE curves. In these drawings the total amplitude response equations of the system, the amplitude of each component in these equations response graphs and the total graphs drawn should include frequency values.

Q: The asymptotic gain-frequency characteristic of a system is shown in FIGURE . Assess the transfer…

A: Minimum phase system does not contain any poles and zeros on the right side of imaginary axis.

Q: A resistor having a resistance of 40 ohms is connected in series with an inductor having an…

A: To find the resonant frequency of the circuit in rad/sec

Q: Given a transfer function G(s) 50/(s+5), where K is a constant, Y dB. low frequency asymptotic…

A: From given transfer function we will find magnitude and phase equations . From magnitude equation we…

Q: (a) Design an active high-pass filter circuit using op-amp and calculate the value of the capacitor,…

A:

Q: Design a low-pass filter using a 100 mH inductor and a single resistor R to obtain a cutoff…

A: Given: The cut off frequency is 7500 Hz ± 2%. The inductance is 100 mH.

Q: 1. Find the impedance of a RC combination when the capacitor is 0.01pF, the audio frequency is 1kHz…

A:

Q: Q2 A series RLC bandreject filter is used to reject a 200 Hz sinusoid while passing other…

A:

Q: I. Problem Solving Compute the following values for each item. Write your answers on a clean sheet…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 1. Specify the Nyquist rate and the Nyquist interval for each of the following signals: (a) g(t) =…

A: In this question we need to find the Nyquist rate and Nyquist interval of the given signal.

Q: Q: Design a basic RC band stop filter with a lower cut-off frequency of 200Hz and a higher cut- off…

A: Bandwidth: This is the range of frequency in which different frequencies signal lies. Outside the…

Q: A Finite Impulse Response (FIR) filter is required with a phase response of zero, and a magnitude…

A:

Q: A circuit contains a capacitor with C-20.0 uF connected to an AC source operating at an amplitude of…

A:

Q: A coil with resistance of 100 and an inductance of 15 mH is connected in series to the paralle…

A: Solve the problem

Q: A second order system has damping ratio 0.2 and natural frequency 10 rad/sec. Therefore resonant…

A: The resonant frequency in rad/sec is as follows: ωr=ωo2-2β2β=0.2ωo=10 rad/secωr=102-×20.22     =9.89…

Q: The maximum phase of the system is given as 30-degree and the maximum angular frequency is under…

A: The maximum phase is expressed as:

Q: D Sketch by hamd the asymptotes of the Bode mounitude and phase plots Sor the open- loop trons fer…

A:

Q: Since k = 0.35x103, VGso = 6.2 V, VGS(Th) = 2.4 V, RF = 100 MQ, RG = 10 MQ, RD = 7.6 kQ, RS = 2.2 kQ…

A: In this question we need to find the output voltage

Q: Passive filters are made of passive components, tuned to the harmonic frequencies that are to be…

A:

Q: Consider the system- Y(n)= x(n)+ x(n-10) Compute and sketch its magnitude and phase response.

A: The solution is provided in the following section:

Q: A filter with a positive phase shift is non-causal, i.e. it looks into the future. This is not…

A: The filter in an electronic circuit is used to remove the undesired part of the frequency band from…

Q: QUESTION 22 Which of the followings is true? Given an RC circuit, O A. the circuit has a negative…

A: In the q no 22 there is we have to give the true statement out of 4 The RC circuit has the Resistor…

Q: See Figure 752. D=1. The Bode gain and phase plots for a RC circuit are shown in the fig Determino

A: Given that D=1. So on a semilog paper corresponding values of C=0, E=2, F=3 As per the given data,…

Q: 20log(|H(jw)|) 20dB 17dB -20dB 2000 8000

A: According to the question, Its characteristic is given below filter circuit using butterworth…

Q: Design an active Low-Pass Filter with a specified break frequency of 10100 rad/sec and a Passband…

A: The in detail answer is provided in the steps along with the codeExplanation:Step 1:To design an…

Q: useing matlab please.

A: Clear all variable values then clear console:clear; clc;Set up parameters:fs = 4000; %…

Q: Vout H(f) = IB 1+j in fB

A:

Q: Write a difference equation that characterizes a system whose frequency response is H(el) =…

A:

Q: An audio signal needs to be split into two components; a low frequency com- ponent (f 2 kHz) that…

A: standard Low pass RL circuit is, Concept: XL=jωLAt low frequency,ω→0, i.e XL=0so inductor is short…

Q: Refer to the RLC circuit shown below. Your job is to write a Matlab code to plot the Gain and Phase…

A: To write a Mat lab code to plot the Gain and Phase responses of the circuit.

Q: U₁ 2 L₁ C www.l wwww L₂ U₁₂ R The circuit comprises two inductors with L, = 15 mH. For a frequency…

A: At   and at

Q: Convert the decimal number 24710 to base 2, base 8, and base 16. Convert the following decimal…

A: Since you have posted multiple questions, we will provide the  solution   only to the first question…

Q: The open-loop system transfer function is given by Ks (s + a)(s² + 14s + 49) G(s) = = The frequency…

A: The Bode plot of the systemThe transfer function of the system ishere

Q: The bode plot of the following open-loop T.F. is as shown in Figure below: K(s+1) s(s+10)(s+5)(s+2)…

A: The calculation for all the terms, phase margin, gain margin, phase crossover frequency and gain…

Q: Q.3 Find the technique (2TF RIS) Ha RLS), és)

A: Transfer function: It shows the relation between output and input of the system.

Q: In designing a signal-switching circuit (RC circuit), it was found that a 100-µF capacitor was…

A: Time constant: In RC circuit the time constant is also called as tau and it is equal to the product…

Q: The phase of a transfer function decreases by -45 at a zero frequency (Wz) and experiences -90 at…

A: In this question,  Find the phase transfer function decrease -45 at the zero frequency Wz What is…

Q: It satisfies both Additivity and Homogeneity property. It satisfies amplitude scaling. It satisfies…

A: Linear system offers linear relationship between output and input.

Q: The circuit below is switched at t = 0 after reaching the steady-state. From the given circuit…

A: As per Bartleby guideline we need to answer the first three questions only. Kindly repost the rest…